论文信息 - Investigation of Local Flow Parameters Caused by Flow Acceleration Corrosion Downstream of an Orifice in a Piping System

Investigation of Local Flow Parameters Caused by Flow Acceleration Corrosion Downstream of an Orifice in a Piping System

In this study, the performance of an impeller according to blade length and pitch angle was studied experimentally by building a variable pitch impeller while changing blade length to review the effect of blade length and pitch angle on a fan`s performance. The pitch angle was changed in six steps from at intervals of while the blade lengths were changed to 90 mm, 100 mm, 110 mm and 120 mm with an identical airfoil shape while carrying out the experiment. The results are summarized as follows : The air flow per static pressure of axial fans increased linearly with increase of pitch angle, but the high static pressure showed a decrease at a pitch angle of . The shaft power increased proportionally to the pitch angle at all blade lengths; the larger the pitch angle, the larger the measured increase of shaft power. This is because the drag at the fan`s front increases with the pitch angle. In the axial fans considered in this research, the flow and incre.

[1] Vivekanand Kain,et al. Flow accelerated corrosion and its control measures for the secondary circuit pipelines in Indian nuclear power plants , 2007 .

[2] Hammad Mazhar,et al. The hydrodynamic effects of single-phase flow on flow accelerated corrosion in a 90-degree elbow , 2010 .

[3] F. Berger,et al. MASS TRANSFER IN TURBULENT PIPE FLOW MEASURED BY THE ELECTROCHEMICAL METHOD , 1977 .

[4] B. Chexal,et al. Flow-accelerated corrosion in power plants , 1996 .

[5] S. Koshizuka,et al. Evaluation Method on Flow Accelerated Corrosion of Components in Cooling Systems of Nuclear Power Plants by Coupling Analysis of Corrosion and Flow Dynamics , 2008 .

[6] W. Ahmed,et al. Flow and mass transfer downstream of an orifice under flow accelerated corrosion conditions , 2012 .

[7] Young-Hwan Choi,et al. Fluid effects on structural integrity of pipes with an orifice and elbows with a wall-thinned part , 2009 .

[8] B. Poulson. Complexities in predicting erosion corrosion , 1999 .

[9] T. Jin,et al. Identification of the Relationship between Local Velocity Components and Local Wall Thinning inside Carbon Steel Piping , 2009 .

[10] J. Dawson,et al. Mass transfer enhancement associated with sudden flow expansion , 1996 .

[11] Y. M. Ferng,et al. Predicting local distributions of erosion–corrosion wear sites for the piping in the nuclear power plant using CFD models , 2008 .