Heat source identification and on-line temperature control by a Branch Eigenmodes Reduced Model

Abstract This paper presents the advantages of a Branch Eigenmodes Reduced Model used in a control process of a heating system. The experimental setup is a 3D heat conductive system in which a heat source is set. First, the reduced model is used to solve the non-linear Inverse Heat Conduction Problem: identification of the heat source strength variations from time-varying temperatures. Then, the reduced model is used to control hot points in the system. The objective of the method is to allow sequential temperature control by decreasing the computation time necessary for the simulation.

[1]  Etienne Videcoq,et al.  Experimental modelling and estimation of time varying thermal sources , 2003 .

[2]  O. Quéméner,et al.  Comparison of Two Nonlinear Model Reduction Techniques: The Modal Identification Method and the Branch Eigenmodes Reduction Method , 2006 .

[3]  O. Alifanov,et al.  Extreme Methods for Solving Ill-Posed Problems with Applications to Inverse Heat Transfer Problems , 1995 .

[4]  Yvon Jarny,et al.  Determination of heat sources and heat transfer coefficient for two-dimensional heat flow – numerical and experimental study , 2001 .

[5]  W. Arnoldi.  The principle of minimized iterations in the solution of the matrix eigenvalue problem , 1951 .

[6]  Haralambos Sarimveis,et al.  Model predictive temperature control in long ducts by means of a neural network approximation tool , 2007 .

[7]  M. Raynaud,et al.  A guide for the use of the function specification method for 2D inverse heat conduction problems , 1998 .

[8]  Frédéric Lefèvre,et al.  A parameter estimation approach to solve the inverse problem of point heat sources identification , 2004 .

[9]  B. Blackwell,et al.  Inverse Heat Conduction: Ill-Posed Problems , 1985 .

[10]  Daniel Petit,et al.  Identification methods in nonlinear heat conduction. Part II: inverse problem using a reduced model , 2005 .

[11]  Christophe Le Niliot,et al.  THE BOUNDARY-ELEMENT METHOD FOR THE TIME-VARYING STRENGTH ESTIMATION OF POINT HEAT SOURCES: APPLICATION TO A TWO-DIMENSIONAL DIFFUSION SYSTEM , 1998 .

[12]  M.O.M. Osman,et al.  On-line estimation of time-variant thermal load applied to machine tool structures using a s-domain inverse solution , 1999 .

[13]  E. Videcoq,et al.  The Use of Model Reduction and Function Decomposition for Identifying Boundary Conditions of A Linear Thermal System , 2003 .

[14]  Hyung-Min Park,et al.  Sequential solution of a three-dimensional inverse radiation problem , 2003 .

[15]  D. Maillet,et al.  Flash experiment on a semitransparent material: interest of a reduced model , 2001 .

[16]  James V. Beck,et al.  Numerical Solution of the General Two-Dimensional Inverse Heat Conduction Problem (IHCP) , 1997 .

[17]  B. Blackwell,et al.  Comparison of some inverse heat conduction methods using experimental data , 1996 .

[18]  Bernard Flament,et al.  Simulation de la conduction non linéaire en régime variable: décomposition sur les modes de branche , 1999 .

[20]  Shih-Ming Lin,et al.  A modified sequential approach for solving inverse heat conduction problems , 2004 .

[21]  M. Lazard,et al.  Modelling of a tool during turning: Analytical prediction of the temperature and of the heat flux at the tool¿s tip , 2004 .