Buckling of a Longitudinally Stiffened Flat Panel
暂无分享,去创建一个
(a) Purpose of Investigation. To determine the least size of stringers necessary to prevent overall buckling of a flat stiffened panel before buckling of the plates between stringers. (b) Range of Investigation. The conditions for buckling of a longitudinally stiffened flat panel are established on the assumption that the rotational stiffness of the stringers is negligible. The results are applied to determine the limiting characteristics of the stringers to ensure that these members remain straight up to the stress at which the plates buckle between stringers. The analysis has been carried through in detail for panels with one, two, or three stringers and is capable of extension to four, five or more stringers. This extension appears unnecessary, because the three stringer case is moderately close to the limiting case of a wide panel with an indefinitely large number of stringers. (c) Conclusions. The stiffening effect of the stringers, having each the area of section A , and modulus of section A s K 2 , when attached to a sheet of thickness t and length a , at spacing b depends upon the three ratios ( k/t ), ( a/b ) and ( A s /bt ) In general, the size of stringer necessary to ensure that the stringers remain straight until the plates buckle between stringers may be represented by the conditions . For a panel stiffened by one stringer only suitable values are λ = 4.5 and μ = 12.5, independent of the value of (a/b) , while v=0.366 ( a/b ) 2 or 23 if 8>(a/b)>6. For two or more stringers the same general conditions hold, but it is impossible to assign values to λ and μ which would be fully satisfactory for all values of the ratio a/b . In these cases, therefore, it is more satisfactory to select the values of λ and μ appropriate to each value of the ratio a/b . These values may be obtained from Figs. 2 and 3 where curves of bt/A s against ( k/t ) 2 for varying values of ( a/b ) are shown for two and three stringers respectively. For an indefinitely large number of stringers the corresponding condition is and the second condition ( k/t ) 2 0.366 (a/b) 2 is virtually included in the first. (d) Further Developments . In the present analysis the resistance of the stringers. to rotation is neglected. Inclusion of this characteristic in the basic analysis is straightforward, but practical interpretation of the results becomes much more difficult. Moreover, the effect of this stiffness in modifying the condition for buckling between stringers is likely to affect the conclusions more than the direct effect of their torsional stiffness in modifying the condition for buckling of the stiffened panel. This consideration is particularly important in cases of light stringers and heavy sheet, when the effective rotational stiffness of the stringers at buckling of the plates between stringers may be greatly reduced as a result of the end loading and may even be negative. Representation of the effect of both longitudinal stiffeners (stringers) and lateral stiffeners (ribs), including their stiffnesses to rotation is also straightforward; but interpretation of the results in forms suitable for practical application would be extremely difficult.
[1] S. Timoshenko. Theory of Elastic Stability , 1936 .