A thermal-fluid coupling numerical study on the characteristics of air–oil two phase flow and heat transfer in a micro UAV bearing chamber
暂无分享,去创建一个
Hulin Huang | Lu Peng | Xingwen Zheng | Li Wei | Peijie Yang | Yezhen Yu
[1] Kyros Yakinthos,et al. CFD Modeling and LDA Measurements for the Air-Flow in an Aero Engine Front Bearing Chamber , 2011 .
[2] Michael Flouros. Correlations for heat generation and outer ring temperature of high speed and highly loaded ball bearings in an aero-engine , 2006 .
[3] Klaus Dullenkopf,et al. Active Outer Ring Cooling of High-Loaded and High-Speed Ball Bearings , 2013 .
[4] Michael Flouros. Analytical and Numerical Simulations of the Two-Phase Flow Heat Transfer in the Vent and Scavenge Pipes of the CLEAN Engine Demonstrator , 2008 .
[5] C. W. Lee,et al. Comparison of Computational Fluid Dynamics and Particle Image Velocimetry Data for the Airflow in an Aeroengine Bearing Chamber , 2005 .
[8] Yi Zhang,et al. Effect of oil droplet deformation on its deposited characteristics in an aeroengine bearing chamber , 2014 .
[9] Guo-Ding Chen,et al. Research into Configuration and Flow of Wall Oil Film in Bearing Chamber Based on Droplet Size Distribution , 2011 .
[10] Klaus Dullenkopf,et al. Influence of Operating Condition and Geometry on the Oil Film Thickness in Aeroengine Bearing Chambers , 2006 .
[11] K. Simmons,et al. The Effect of Initial Injection Conditions on the Oil Droplet Motion in a Simplified Bearing Chamber , 2008 .