Estimated accuracy of classification of defects detected in welded joints by radiographic tests

Over the last two decades, there has been a considerably increase in the number of publications of research projects for the detection and classification of welding defects in radiographs using image processing and pattern recognition tools. All these research projects aim to set up an automatic or semi-automatic classification system for weld joint defects detected by the radiographic method. A classification system as such would allow a reduction in some inherent inexactnesses that occur in the conventional method, consequently increasing the precision of the report. This work is a study to estimate the accuracy of classification of the main classes of weld defects, such as: undercut, lack of penetration, porosity, slag inclusion, crack or lack of fusion. To carry out this work nonlinear pattern classifiers were developed, using neural networks. Also the largest number of radiographic patterns as possible was used as well as statistical inference techniques of random selection of data with (Bootstrap) and without repositioning in order to estimate the accuracy of the classification. The results pointed to an estimated accuracy of around 80% for the classes of defects analyzed.

[1]  R.P. Kraft,et al.  Automated inspection of solder joints-a neural network approach , 1995, Seventeenth IEEE/CPMT International Electronics Manufacturing Technology Symposium. 'Manufacturing Technologies - Present and Future'.

[2]  T. Warren Liao,et al.  An automated radiographic NDT system for weld inspection: Part I — Weld extraction , 1996 .

[3]  David G. Stork,et al.  Pattern classification, 2nd Edition , 2000 .

[4]  N. A. Diamantidis,et al.  Unsupervised stratification of cross-validation for accuracy estimation , 2000, Artif. Intell..

[5]  Luis Volnei Sudati Sagrilo,et al.  Evaluation of the relevant characteristic parameters of welding defects and probability of correct classification using linear classifiers , 2002 .

[6]  Gang Wang,et al.  Automatic identification of different types of welding defects in radiographic images , 2002 .

[7]  Yasuo Suga,et al.  Application of artificial neural network to discrimination of defect type in automatic radiographic testing of welds , 1999 .

[8]  Simon Haykin,et al.  Neural Networks: A Comprehensive Foundation , 1998 .

[9]  I. M. Elewa,et al.  Automatic inspection of gas pipeline welding defects using an expert vision system , 2004 .

[10]  Robert Tibshirani,et al.  An Introduction to the Bootstrap , 1994 .

[11]  David G. Stork,et al.  Pattern Classification (2nd ed.) , 1999 .

[12]  Yueming Li,et al.  An automated radiographic NDT system for weld inspection: Part II—Flaw detection , 1998 .

[13]  T. W. Liao,et al.  Detection of welding flaws from radiographic images with fuzzy clustering methods , 1999, Fuzzy Sets Syst..

[14]  S. Matsui,et al.  DEVELOPMENT OF AN AUTOMATIC WELD DEFECT IDENTIFICATION SYSTEM FOR RADIOGRAPHIC TESTING , 1993 .

[15]  George V. Lashkia.  Defect detection in X-ray images using fuzzy reasoning , 2001, Image Vis. Comput..

[16]  Shigeo Abe DrEng.  Pattern Classification , 2001, Springer London.

[17]  Romeu Ricardo da Silva,et al.  Pattern recognition of weld defects detected by radiographic test , 2004 .

[18]  I. M. Elewa,et al.  Assessment of welding defects for gas pipeline radiographs using computer vision , 2004 .

[19]  David G. Stork,et al.  Pattern Classification , 1973 .