A New MPPT Method for Low-Power Solar Energy Harvesting

This paper describes a new maximum-power-point-tracking (MPPT) method focused on low-power (<; 1 W) photovoltaic (PV) panels. The static and dynamic performance is theoretically analyzed, and design criteria are provided. A prototype was implemented with a 500-mW PV panel, a commercial boost converter, and low-power components for the MPPT controller. Laboratory measurements were performed to assess the effectiveness of the proposed method. Tracking efficiency was higher than 99.6%. The overall efficiency was higher than 92% for a PV panel power higher than 100 mW. This is, in part, feasible due to the low power consumption of the MPPT controller, which was kept lower than 350 μW. The time response of the tracking circuit was tested to be around 1 s. Field measurements showed energy gains higher than 10.3% with respect to a direct-coupled solution for an ambient temperature of 26°C. Higher gains are expected for lower temperatures.

[1]  Johan H R Enslin,et al.  Integrated photovoltaic maximum power point tracking converter , 1997, IEEE Trans. Ind. Electron..

[2]  Yanqiu Li,et al.  Hybrid Micropower Source for Wireless Sensor Network , 2008, IEEE Sensors Journal.

[3]  Luca Benini,et al.  Dynamic power management - design techniques and CAD tools , 1997 .

[4]  Gehan A. J. Amaratunga,et al.  Analytic Solution to the Photovoltaic Maximum Power Point Problem , 2007, IEEE Transactions on Circuits and Systems I: Regular Papers.

[5]  David E. Culler,et al.  Perpetual environmentally powered sensor networks , 2005, IPSN 2005. Fourth International Symposium on Information Processing in Sensor Networks, 2005..

[6]  M. Gasulla,et al.  A Review of Commercial Energy Harvesters for Autonomous Sensors , 2007, 2007 IEEE Instrumentation & Measurement Technology Conference IMTC 2007.

[7]  Simone Buso,et al.  Low-Complexity MPPT Technique Exploiting the PV Module MPP Locus Characterization , 2009, IEEE Transactions on Industrial Electronics.

[8]  P.L. Chapman,et al.  Comparison of Photovoltaic Array Maximum Power Point Tracking Techniques , 2007, IEEE Transactions on Energy Conversion.

[9]  Luca Benini,et al.  Modeling and Optimization of a Solar Energy Harvester System for Self-Powered Wireless Sensor Networks , 2008, IEEE Transactions on Industrial Electronics.

[10]  Timothy C. Green,et al.  Energy Harvesting From Human and Machine Motion for Wireless Electronic Devices , 2008, Proceedings of the IEEE.

[11]  P.H. Chou,et al.  Efficient Charging of Supercapacitors for Extended Lifetime of Wireless Sensor Nodes , 2008, IEEE Transactions on Power Electronics.

[12]  Mani B. Srivastava,et al.  Design considerations for solar energy harvesting wireless embedded systems , 2005, IPSN 2005. Fourth International Symposium on Information Processing in Sensor Networks, 2005..

[13]  Luca Benini,et al.  Dynamic Power Management , 1998 .

[14]  Biranchinath Sahu,et al.  An Accurate, Low-Voltage, CMOS Switching Power Supply With Adaptive On-Time Pulse-Frequency Modulation (PFM) Control , 2007, IEEE Transactions on Circuits and Systems I: Regular Papers.

[15]  Roger A. Dougal,et al.  Parallel-Connected Solar PV System to Address Partial and Rapidly Fluctuating Shadow Conditions , 2009, IEEE Transactions on Industrial Electronics.

[16]  Cesare Alippi,et al.  An Adaptive System for Optimal Solar Energy Harvesting in Wireless Sensor Network Nodes , 2008, IEEE Transactions on Circuits and Systems I: Regular Papers.