The role of asteroid strength, porosity and internal friction in impact momentum transfer

Abstract Earth is continually impacted by very small asteroids and debris, and a larger object, though uncommon, could produce a severe natural hazard. During impact crater formation the ballistic ejection of material out of the crater is a major process, which holds significance for an impact study into the deflection of asteroids. In this study we numerically simulate impacts into low-gravity, strength dominated asteroid surfaces using the iSALE shock physics code, and consider the Double Asteroid Redirection Test (DART) mission as a case study. We find that target cohesion, initial porosity, and internal friction coefficient greatly influence ejecta mass/velocity/launch-position distributions and hence the amount by which an asteroid can be deflected. Our results show that as the cohesion is decreased the ratio of ejected momentum to impactor momentum, β − 1, increases; β − 1 also increases as the initial porosity and internal friction coefficient of the asteroid surface decrease. Using nominal impactor parameters and reasonable estimates for the material properties of the Didymos binary asteroid, the DART target, our simulations show that the ejecta produced from the impact can enhance the deflection by a factor of 2 to 4. We use numerical impact simulations that replicate conditions in several laboratory experiments to demonstrate that our approach to quantify ejecta properties is consistent with impact experiments in analogous materials. Finally, we investigate the self-consistency between the crater size and ejection speed scaling relationships previously derived from the point-source approximation for impacts into the same target material.

[1]  Antti Näsilä,et al.  European component of the AIDA mission to a binary asteroid: Characterization and interpretation of the impact of the DART mission , 2018, Advances in Space Research.

[2]  Paul L. Miller,et al.  Deflection by kinetic impact: Sensitivity to asteroid properties , 2016 .

[3]  Derek C. Richardson,et al.  The formation of asteroid satellites in large impacts: Results from numerical simulations , 2004 .

[4]  N. Lundborg,et al.  The strength-size relation of granite , 1967 .

[5]  M. Mendenhall,et al.  On the Formation of Basin Secondary Craters by Ejecta Complexes , 1979 .

[6]  C. Fassett,et al.  Impact bombardment of the terrestrial planets and the early history of the Solar System , 2013 .

[7]  K. Holsapple,et al.  Point source solutions and coupling parameters in cratering mechanics , 1987 .

[8]  K. A. Holsapple,et al.  On the Scaling of Crater Dimensions 2. Impact Processes , 1982 .

[9]  Kai Wünnemann,et al.  Impacts into quartz sand: Crater formation, shock metamorphism, and ejecta distribution in laboratory experiments and numerical models , 2016 .

[10]  D. Scheeres,et al.  Dynamics of rotationally fissioned asteroids: Source of observed small asteroid systems , 2011, 1404.0801.

[11]  S.-Y. Su,et al.  The velocity distribution of collisional fragments and its effect on future space debris environment , 1990 .

[12]  Kenneth L. Lee,et al.  Drained Strength Characteristics of Sands , 1967 .

[13]  P. Michel,et al.  Rotational breakup as the origin of small binary asteroids , 2008, Nature.

[14]  Michael J. S. Belton,et al.  Mitigation of Hazardous Comets and Asteroids , 2011 .

[15]  Joachim M. Blum,et al.  Science case for the Asteroid Impact Mission (AIM): A component of the Asteroid Impact & Deflection Assessment (AIDA) mission , 2016 .

[16]  J. H. Tillotson.  METALLIC EQUATIONS OF STATE FOR HYPERVELOCITY IMPACT , 1962 .

[17]  K. Holsapple,et al.  Crater ejecta scaling laws - Fundamental forms based on dimensional analysis , 1983 .

[18]  S. Werner,et al.  The effect of target properties on transient crater scaling for simple craters , 2017 .

[19]  R. M. Schmidt,et al.  Meteor Crater: Energy of formation - Implications of centrifuge scaling , 1980 .

[20]  S. Sugita,et al.  Measurements of Ejecta Velocity Distribution by a High-Speed Video Camera , 2005 .

[21]  K. Holsapple.  THE SCALING OF IMPACT PROCESSES IN PLANETARY SCIENCES , 1993 .

[22]  B. A. Ivanov,et al.  Implementation of dynamic strength models into 2D hydrocodes : Applications for atmospheric breakup and impact cratering , 1997 .

[23]  D. Ming.  Lunar sourcebook. A user's guide to the moon , 1992 .

[24]  Derek C. Richardson,et al.  AIDA DART asteroid deflection test: Planetary defense and science objectives , 2018, Planetary and Space Science.

[25]  H. J. Moore,et al.  Hypervelocity impact of steel into coconino sandstone , 1963 .

[26]  P. Pravec,et al.  Modeling of lightcurves of binary asteroids , 2009 .

[27]  K. Housen.  Crater ejecta velocities for impacts on rocky bodies , 1992 .

[28]  H. Melosh,et al.  Basin-forming impacts: Reconnaissance modeling , 2010 .

[29]  P. Schultz,et al.  Asymmetry of ejecta flow during oblique impacts using three-dimensional particle image velocimetry , 2003 .

[30]  S. Hasegawa,et al.  Impact velocity dependence of transient cratering growth , 2017 .

[31]  M. Arakawa,et al.  Ejecta velocity distribution of impact craters formed on quartz sand: Effect of projectile density on crater scaling law , 2015 .

[32]  Brandon C. Johnson,et al.  Jetting during vertical impacts of spherical projectiles , 2014 .

[33]  C. W. Hirt,et al.  SALE: a simplified ALE computer program for fluid flow at all speeds , 1980 .

[34]  T. Ahrens,et al.  Impact Jetting of Geological Materials , 1995 .

[35]  R. Goodman.  Introduction to Rock Mechanics , 1980 .

[36]  H. J. Moore,et al.  Spray Ejected from the Lunar Surface by Meteoroid Impact , 1963 .

[37]  P. Schultz,et al.  Time-resolved studies of hypervelocity vertical impacts into porous particulate targets: Effects of projectile density on early-time coupling and crater growth , 2011 .

[38]  W. Hartmann.  Impact experiments. I - Ejecta velocity distributions and related results from regolith targets , 1985 .

[39]  Kevin R. Housen,et al.  Impact Cratering: A Geologic Process , 1987 .

[40]  G. R. Johnson,et al.  A CONSTITUTIVE MODEL AND DATA FOR METALS SUBJECTED TO LARGE STRAINS, HIGH STRAIN RATES AND HIGH TEMPERATURES , 2018 .

[41]  B. Ivanov,et al.  Numerical modeling of the formation of large impact craters , 2002 .

[42]  T. Ahrens,et al.  Deflection and fragmentation of near-Earth asteroids , 1992, Nature.

[43]  V. Oberbeck.  The Role of Ballistic Erosion and Sedimentation in Lunar Stratigraphy , 1975 .

[44]  Patrick Michel,et al.  Physical properties of Near-Earth Objects that inform mitigation , 2013 .

[45]  P. Schultz.  Atmospheric effects on cratering efficiency , 1992 .

[46]  Stanley G. Love,et al.  Gravitational tractor for towing asteroids , 2005, Nature.

[47]  Farquhar,et al.  Estimating the mass of asteroid 253 mathilde from tracking data during the NEAR flyby , 1997, Science.

[48]  P. Schultz,et al.  Early-stage ejecta velocity distribution for vertical hypervelocity impacts into sand , 2010 .

[49]  Gareth S. Collins,et al.  Modeling damage and deformation in impact simulations , 2004 .

[50]  P. Michel,et al.  Hypervelocity impacts on asteroids and momentum transfer I. Numerical simulations using porous targets , 2014 .

[51]  Kevin R. Housen,et al.  Ejecta from impact craters , 2011 .

[52]  H. J. Melosh,et al.  A hydrocode equation of state for SiO2 , 2007 .

[53]  K. Holsapple,et al.  Momentum transfer in asteroid impacts. I. Theory and scaling , 2012 .

[54]  Raphaël F. Garcia,et al.  Probing the internal structure of the asteriod Didymoon with a passive seismic investigation , 2017 .

[55]  D. Agard,et al.  Microtubule nucleation by γ-tubulin complexes , 2011, Nature Reviews Molecular Cell Biology.

[56]  Erik Asphaug,et al.  Validation of numerical codes for impact and explosion cratering: Impacts on strengthless and metal targets , 2008 .

[57]  P. Michel,et al.  Asteroid Impact & Deflection Assessment mission: Kinetic impactor , 2016 .

[58]  R. Greenberg,et al.  Asteroids and meteorites - Parent bodies and delivered samples , 1983 .

[59]  M. Cintala,et al.  Ejection‐velocity distributions from impacts into coarse‐grained sand , 1999 .

[60]  Andrew F. Cheng,et al.  Modeling Momentum Transfer from Kinetic Impacts: Implications for Redirecting Asteroids☆ , 2015 .

[61]  E. A. Murray,et al.  Quasi-Static Compression Stress-Strain Curves--IV, 2024-T3510 and 6061-T6 Aluminum Alloys , 1976 .

[62]  Gareth S. Collins,et al.  A strain-based porosity model for use in hydrocode simulations of impacts and implications for transient crater growth in porous targets , 2006 .

[63]  Kevin R. Housen,et al.  Impact cratering on porous asteroids , 2003 .

[64]  P. Michel,et al.  Spin-up of rubble-pile asteroids: Disruption, satellite formation, and equilibrium shapes , 2012 .

[65]  G. Collins,et al.  Scaling of oblique impacts in frictional targets: Implications for crater size and formation mechanisms , 2009 .

[66]  Kai Wünnemann,et al.  Effect of target properties and impact velocity on ejection dynamics and ejecta deposition , 2018, Meteoritics & Planetary Science.

[67]  K. Holsapple,et al.  Estimates of crater size for large-body impact: Gravity-scaling results , 1982 .

[68]  Gareth S. Collins,et al.  Improvements to the ɛ-α porous compaction model for simulating impacts into high-porosity solar system objects , 2011 .