Droplet–Droplet Interactions in Spray Drying by Using 2D Computational Fluid Dynamics

A 2D axisymmetric model of the spray drying process is presented. The two-phase flow theoretical model is based on a combined Eulerian-Lagrangian approach and takes binary interactions (coalescence or bouncing) between spray droplets into consideration. Validation of the model (incorporated in FLUENT 6.3.26) demonstrated good agreement and consistency with the literature data. The results of transient simulations showed that droplet–droplet interactions displace the region of heat and mass transfer from the central core toward the periphery of the drying chamber. It was also found that insulation of the spray dryer can substantially affect temperature and humidity patterns, whereas its influence on the velocity flow field is less marked.

[1]  Phillip N. Ross,et al.  Modeling of the Air Flow Pattern in a Countercurrent Spray-Drying Tower , 1971 .

[2]  David F. Fletcher,et al.  Simulation of the agglomeration in a spray using Lagrangian particle tracking , 2004 .

[3]  A. S. Mujumdar,et al.  A Parametric Study of the Gas Flow Patterns and Drying Performance of Co-current Spray Dryer: Results of a Computational Fluid Dynamics Study , 2003 .

[4]  K. Ridgway,et al.  D4 – INVESTIGATION OF AIR-FLOW IN A SPRAY-DRIER BY TRACER AND MODEL TECHNIQUES , 1981 .

[5]  Transactions of the Institution of Chemical Engineers , 1924, Nature.

[6]  P. Kerkhof,et al.  Air flow, temperature, and humidity patterns in a co-current spray dryer: modelling and measurements , 1997 .

[7]  A. Levy,et al.  Heat and mass transfer of single droplet/wet particle drying , 2008 .

[8]  David F. Fletcher,et al.  USE OF COMPUTATIONAL FLUID DYNAMICS TECHNIQUES TO ASSESS DESIGN ALTERNATIVES FOR THE PLENUM CHAMBER OF A SMALL SPRAY DRYER , 2001 .

[9]  A. S. Mujumdar,et al.  Use of Computational Fluid Dynamics to Evaluate Alternative Spray Dryer Chamber Configurations , 2003 .

[10]  T. Langrish,et al.  New Engineered Particles from Spray Dryers: Research Needs in Spray Drying , 2007 .

[11]  M. Mezhericher,et al.  The Influence of Thermal Radiation on Drying of Single Droplet/Wet Particle , 2007 .

[12]  Ireneusz Zbicinski,et al.  Development and experimental verification of momentum, heat and mass transfer model in spray drying , 1995 .

[13]  Li Xin Huang,et al.  A Three-Dimensional Simulation of a Spray Dryer Fitted with a Rotary Atomizer , 2005 .

[14]  C. Crowe,et al.  The Particle-Source-In Cell (PSI-CELL) Model for Gas-Droplet Flows , 1977 .

[15]  Pjam Piet Kerkhof,et al.  Measurement and Modelling of the Air Flow Pattern in a Pilot-Plant Spray Dryer , 1997 .

[16]  Christopher J. Rutland,et al.  A new droplet collision algorithm , 2000 .

[17]  K. Kuo.  Principles of combustion , 1986 .

[18]  T. Langrish,et al.  The Effect of Swirl on Flow Stability in Spray Dryers , 2001 .

[19]  A. S. Mujumdar,et al.  Simulation of a Spray Dryer Fitted with a Rotary Disk Atomizer Using a Three-Dimensional Computional Fluid Dynamic Model , 2004 .

[20]  Avi Levy,et al.  Theoretical Drying Model of Single Droplets Containing Insoluble or Dissolved Solids , 2007 .

[21]  Ireneusz Zbicinski,et al.  The effects of air inlet geometry and spray cone angle on the wall deposition rate in spray dryers , 1994 .

[22]  D. Oakley,et al.  Computational modelling of spray dryers , 1993 .

[23]  David F. Fletcher,et al.  Prospects for the Modelling and Design of Spray Dryers in the 21st Century , 2003 .

[24]  Lixing Zhou,et al.  Theory and numerical modeling of turbulent gas-particle flows and combustion , 1993 .

[25]  Arun S. Mujumdar,et al.  A comparative study of a spray dryer with rotary disc atomizer and pressure nozzle using computational fluid dynamic simulations , 2006 .

[26]  Avi Levy,et al.  Steady state one dimensional flow model for a pneumatic dryer , 1999 .

[27]  J. Straatsma,et al.  Spray drying of food products: 1. Simulation model , 1999 .

[28]  Arun S. Mujumdar,et al.  Development of a New Innovative Conceptual Design for Horizontal Spray Dryer via Mathematical Modeling , 2005 .