Effects of pilot injection parameters on low temperature combustion diesel engines equipped with solenoid injectors featuring conventional and rate-shaped main injection

Abstract The potential of pilot injection has been assessed on a low-temperature combustion diesel engine for automotive applications, which was characterized by a reduced compression-ratio, high EGR rates and postponed main injection timings. Dwell time sweeps have been carried out for pilot injections with distinct energizing times under different representative steady-state working conditions of the medium load and speed area of the New European Driving Cycle. The results of in-cylinder analyses of the pressure, heat-release rate, temperature and emissions are presented. Combustion noise has been shown to decrease significantly when the pilot injected mass increases, while it is scarcely affected by the dwell time between the pilot and main injections. The HC , CO and fuel consumption trends, with respect to both the pilot injection dwell time and mass, are in line with those of conventional combustion systems, and in particular decreasing trends occur as the pilot injection energizing time is increased. Furthermore, a reduced sensitivity of NO x emissions to both dwell time and pilot injected mass has been found, compared to conventional combustion systems. Finally, it has been observed that soot emissions diminish as the energizing time is shortened, and their dependence on dwell time is influenced to a great extent by the presence of local zones with reduced air-to-fuel ratios within the cylinder. A combined analysis of the results of swirl sweeps and dwell time sweeps is here proposed as a methodology for the detection of any possible interference between pilot combustion burned gases and the main injected fuel. The effect of pilot injection on engine performance and emissions has also been assessed in the presence of rate-shaped main injections. These main injection profiles have been implemented with solenoid injectors by designing the injection fusion between a pre injection shot, which is added after the pilot injection, and the main injection. This innovative strategy shows benefits, with respect to combustion noise, although it still results in a reduced impact on NO x emissions. Furthermore, the brake specific fuel consumption and soot levels generally become worse than in the case of the simple pilot–main injection schedules. The injection fusion strategy has a significant impact on the soot versus dwell time dependence, which is influenced by the interference between the main injection and pilot combustion.

[1]  Balaji Mohan,et al.  Fuel injection strategies for performance improvement and emissions reduction in compression ignition engines—A review , 2013 .

[2]  Federico Millo,et al.  Experimental investigation on the effect of multiple injection strategies on emissions, noise and brake specific fuel consumption of an automotive direct injection common-rail diesel engine , 2003 .

[3]  Li Wei,et al.  Effects of DME pilot quantity on the performance of a DME PCCI-DI engine , 2010 .

[4]  H. Suh.  Study on the twin-pilot-injection strategies for the reduction in the exhaust emissions in a low-compression-ratio engine , 2014 .

[5]  Youngjae Lee,et al.  Analysis of different modes of low temperature combustion by ultra-high EGR and modulated kinetics in a heavy duty diesel engine , 2014 .

[6]  Ezio Spessa,et al.  Analysis of the EGR system performance in modern diesel engines , 2012 .

[7]  Choongsik Bae,et al.  Effect of Multiple Injection Strategies on Emission and Combustion Characteristics in a Single Cylinder Direct-Injection Optical Engine , 2009 .

[8]  P.M.V. Subbarao,et al.  Effect of main injection timing for controlling the combustion phasing of a homogeneous charge compression ignition engine using a new dual injection strategy , 2015 .

[9]  K. Min,et al.  Effect of the diesel injection strategy on the combustion and emissions of propane/diesel dual fuel premixed charge compression ignition engines , 2015 .

[10]  Rolf D. Reitz,et al.  Mechanism of Soot and NOx Emission Reduction Using Multiple-injection in a Diesel Engine , 1996 .

[11]  Choongsik Bae,et al.  Effects of Multiple Injections in a HSDI Diesel Engine Equipped with Common Rail Injection System , 2004 .

[12]  Balaji Mohan,et al.  Multiple Injections Study Based on an Advanced Combustion Investigation System , 2015 .

[13]  Andrea Catania,et al.  Premixed-Diffusive Multizone Model for Combustion Diagnostics in Conventional and PCCI Diesel Engines , 2011 .

[14]  Alessandro Ferrari,et al.  FEM modeling of the piezoelectric driving system in the design of direct-acting diesel injectors , 2012 .

[15]  Valeri Golovitchev,et al.  Injection Strategy Optimization for a Light Duty DI Diesel Engine in Medium Load Conditions with High EGR rates , 2009 .

[16]  Alessandro Ferrari,et al.  Response of different injector typologies to dwell time variations and a hydraulic analysis of closely-coupled and continuous rate shaping injection schedules , 2016 .

[17]  Sven B Andersson,et al.  Effects of Multiple Injections on Engine-Out Emission Levels Including Particulate Mass from an HSDI Diesel Engine , 2007 .

[18]  John B. Heywood,et al.  Internal combustion engine fundamentals , 1988 .

[19]  Yoshihiro Hotta,et al.  Achieving Lower Exhaust Emissions and Better Performance in an HSDI Diesel Engine with Multiple Injection , 2005 .

[20]  Ezio Spessa,et al.  A real time zero-dimensional diagnostic model for the calculation of in-cylinder temperatures, HRR and nitrogen oxides in diesel engines , 2014 .

[21]  J. Desantes,et al.  The modification of the fuel injection rate in heavy-duty diesel engines. Part 1: Effects on engine performance and emissions , 2004 .

[22]  Jacqueline O'Connor,et al.  Post Injections for Soot Reduction in Diesel Engines: A Review of Current Understanding , 2013 .

[23]  Javier Monsalve-Serrano,et al.  Performance and engine-out emissions evaluation of the double injection strategy applied to the gasoline partially premixed compression ignition spark assisted combustion concept , 2014 .

[24]  Antonio Ficarella,et al.  Control of the combustion behaviour in a diesel engine using early injection and gas addition , 2006 .

[25]  Alessandro Ferrari,et al.  Diesel Injector Coking: Optical-Chemical Analysis of Deposits and Influence on Injected Flow-Rate, Fuel Spray and Engine Performance , 2012 .

[26]  Alberto Broatch,et al.  Investigation of Diesel combustion using multiple injection strategies for idling after cold start of passenger-car engines , 2010 .

[27]  S. Tullis,et al.  Improving NOx Versus BSFC with EUI 200 Using EGR and Pilot Injection for Heavy-Duty Diesel Engines , 1996 .

[28]  Q. Fang,et al.  Influences of pilot injection and exhaust gas recirculation (EGR) on combustion and emissions in a HCCI-DI combustion engine , 2012 .

[29]  Nebojsa Milovanovic,et al.  The Impact of Injection Strategies on Emissions Reduction and Power Output of Future Diesel Engines , 2008 .

[30]  Kazutoshi Mori,et al.  Effects of Multiple Injections on Diesel Emission and Combustion Characteristics , 2007 .

[31]  R. Mobasheri,et al.  Investigation of Pilot and Multiple Injection Parameters on Mixture Formation and Combustion Characteristics in a Heavy Duty DI-Diesel Engine , 2012 .

[32]  Investigations of closely coupled pilot and main injections as a means to reduce combustion noise in a small-bore direct injection Diesel engine , 2014 .

[33]  Andrea Catania,et al.  Numerical-Experimental Study and Solutions to Reduce the Dwell-Time Threshold for Fusion-Free Consecutive Injections in a Multijet Solenoid-Type CR System , 2006 .

[34]  O. Kastner,et al.  Directly actuated piezo injector for advanced injection strategies towards cleaner diesel engines , 2009 .

[35]  Ezio Spessa,et al.  Calculation of mass emissions, oxygen mass fraction and thermal capacity of the inducted charge in SI and diesel engines from exhaust and intake gas analysis , 2011 .

[36]  Seongeun Yu,et al.  Comparison of the effects of multiple injection strategy on the emissions between moderate and heavy EGR rate conditions: part 1-pilot injections , 2013 .

[37]  Stefano D'Ambrosio,et al.  Potential of double pilot injection strategies optimized with the design of experiments procedure to improve diesel engine emissions and performance , 2015 .

[38]  Nebojsa Milovanovic,et al.  Development of Premixed Low-Temperature Diesel Combustion in a HSDI Diesel Engine , 2008 .

[39]  Zunqing Zheng,et al.  Effect of two-stage injection on combustion and emissions under high EGR rate on a diesel engine by fueling blends of diesel/gasoline, diesel/n-butanol, diesel/gasoline/n-butanol and pure diesel , 2015 .

[40]  A. Maiboom,et al.  Experimental study of various effects of exhaust gas recirculation (EGR) on combustion and emissions of an automotive direct injection diesel engine , 2008 .

[41]  H. Sajjad,et al.  Impact of low temperature combustion attaining strategies on diesel engine emissions for diesel and biodiesels: A review , 2014 .