Diagnosis of Bridging Defects Based on Current Signatures at Low Power Supply Voltages

Improvement of diagnosis methodologies is a key factor for fast failure analysis and yield improvement. As bridging defects are a common defect type in CMOS circuits, diagnosing this class of defect becomes relevant for present and future technologies. Bridging defects cause two additional current components, the bridge and the downstream current. This work presents the effect of the downstream current on current signatures and its impact on the diagnosis of such defects. The authors demonstrate that the impact of downstream current is minimized at low power supply (Vdd) values. Therefore, current measurements at low power supply voltages are proposed to enhance bridge diagnosis. Experimental evidence of this behaviour is presented for real devices. Furthermore, current signatures measured at VVLV are used for the diagnosis of fifteen failing 0.18mum technology devices, which are demonstrated to contain a bridging defect.

[1]  Yuyun Liao,et al.  Fault coverage analysis for physically-based CMOS bridging faults at different power supply voltages , 1996, Proceedings International Test Conference 1996. Test and Design Validity.

[2]  Tracy Larrabee,et al.  Diagnosing realistic bridging faults with single stuck-at information , 1998, IEEE Trans. Comput. Aided Des. Integr. Circuits Syst..

[3]  Claude Thibeault,et al.  On the Adaptation of Viterbi Algorithm for Diagnosis of Multiple Bridging Faults , 2000, IEEE Trans. Computers.

[4]  Sreejit Chakravarty,et al.  Dynamic Diagnostic Test Generation System for IDDQ Measurement Based Diagnosis of Bridging Faults , 1995 .

[5]  John M. Acken,et al.  Fault Model Evolution For Diagnosis: Accuracy vs Precision , 1992, 1992 Proceedings of the IEEE Custom Integrated Circuits Conference.

[6]  Antonio Rubio,et al.  I/sub ddq/ secondary components in CMOS logic circuits preceded by defective stages affected by analogue type faults , 1991 .

[7]  Edward J. McCluskey,et al.  Very-low-voltage testing for weak CMOS logic ICs , 1993, Proceedings of IEEE International Test Conference - (ITC).

[8]  Edward J. McCluskey,et al.  Stuck-fault tests vs. actual defects , 2000, Proceedings International Test Conference 2000 (IEEE Cat. No.00CH37159).

[9]  Sreejit Chakravarty,et al.  Voting model based diagnosis of bridging faults in combinational circuits , 1995, Proceedings of the 8th International Conference on VLSI Design.

[10]  Elizabeth M. Rudnick,et al.  Bridge fault diagnosis using stuck-at fault simulation , 2000, IEEE Trans. Comput. Aided Des. Integr. Circuits Syst..

[11]  Franco Motika,et al.  Application and analysis of IDDQ diagnostic software , 1997, Proceedings International Test Conference 1997.

[12]  Anne Gattiker,et al.  Random and systematic defect analysis using IDDQ signature analysis for understanding fails and guiding test decisions , 2004 .

[13]  Claude Thibeault,et al.  Diagnosis method based on /spl Delta/Iddq probabilistic signatures: experimental results , 1998, Proceedings International Test Conference 1998 (IEEE Cat. No.98CH36270).

[14]  Thomas J. Vogels Effectiveness of I-V testing in comparison to IDDq tests [IC testing] , 2003, Proceedings. 21st VLSI Test Symposium, 2003..

[15]  S.D. Millman,et al.  Diagnosing CMOS bridging faults with stuck-at fault dictionaries , 1990, Proceedings. International Test Conference 1990.

[16]  A. R. Newton,et al.  Alpha-power law MOSFET model and its applications to CMOS inverter delay and other formulas , 1990 .

[17]  Vishwani D. Agrawal,et al.  New graphical I/sub DDQ/ signatures reduce defect level and yield loss , 2003, 16th International Conference on VLSI Design, 2003. Proceedings..

[18]  Bram Kruseman,et al.  The future of delta I/sub DDQ/ testing , 2001, Proceedings International Test Conference 2001 (Cat. No.01CH37260).

[19]  Rosa Rodríguez-Montañés,et al.  Bridges in sequential CMOS circuits: current-voltage signature , 1997, Proceedings. 15th IEEE VLSI Test Symposium (Cat. No.97TB100125).

[20]  Wojciech Maly,et al.  Current signatures: application , 1997, Proceedings International Test Conference 1997.

[21]  Robert C. Aitken,et al.  Fault Location with Current Monitoring , 1991, 1991, Proceedings. International Test Conference.

[22]  Rosa Rodríguez-Montañés,et al.  Bridging defects resistance measurements in a CMOS process , 1992, Proceedings International Test Conference 1992.

[23]  Sreejit Chakravarty,et al.  Algorithms for IDDQ measurement based diagnosis of bridging faults , 1992, J. Electron. Test..

[24]  Michael Nicolaidis Shorts in self-checking circuits , 1991, J. Electron. Test..

[25]  J. Figueras,et al.  I/sub DDQ/ test and diagnosis of CMOS circuits , 1995 .