Injection Locking in Switching Power Amplifiers

In this work, injection locking in switching power amplifiers (PAs) is studied. Traditionally, injection-locked PAs (ILPAs) have supported phase modulation, with injection locking used primarily to improve the power-added efficiency by reducing the power required to drive the ILPA. Since the output power in conventional ILPA architectures is mainly contributed by the locked oscillator in an ILPA, the amplitude modulation is difficult to achieve unless supply modulation is employed. In the ILPA presented in this work, it is shown that by injection locking a switching PA and a power oscillator, improvement in both power-added efficiency and drain efficiency can be achieved as compared to just a switching PA. Moreover, amplitude modulation at a fixed supply voltage is achieved using an RF-DAC approach to scale both the switching PA and the locked oscillator. This approach employs variable injection-strengths varying from ≤1 (weak injection locking) to >1 (strong injection locking) to achieve the required power back-off. Accordingly, new formulations are introduced to extend the existing injection locking theory for injection strengths >1 case in ILPAs. Benefits of a larger injection strength on lock-range, maximum allowable symbol rate, AM-PM distortion and phase noise performance for an ILPA is provided. An ILPA is designed to support 64-QAM and implemented in a standard 65-nm bulk CMOS process. A peak drain efficiency of 42.7% and power-added efficiency of 40% is measured at the highest output power of 23 dBm, operating from a 1.45 V PA power supply at 2.5 GHz. Modulation tests with 5/50 MSym/s 64-QAM signals achieve the measured RMS EVM of 1.9%/3.1% with the average output power, drain efficiency and power-added efficiency of 18.1 dBm, 27.9% and 25.8% at 2.5 GHz, respectively.

[1]  A. Rofougaran,et al.  A 900 MHz CMOS LC-oscillator with quadrature outputs , 1996, 1996 IEEE International Solid-State Circuits Conference. Digest of TEchnical Papers, ISSCC.

[2]  Renato Negra,et al.  14 dBm, 18–20 GHz injection-locked power amplifier with 45% peak PAE in 65nm CMOS , 2016, 2016 11th European Microwave Integrated Circuits Conference (EuMIC).

[3]  Pietro Andreani,et al.  Highly Efficient Class-C CMOS VCOs, Including a Comparison With Class-B VCOs , 2013, IEEE Journal of Solid-State Circuits.

[4]  Yanjie Wang,et al.  A highly linear dual-band mixed-mode polar power amplifier in CMOS with an ultra-compact output network , 2015, 2015 IEEE Custom Integrated Circuits Conference (CICC).

[5]  Lu Ye.  Design and Analysis of Digitally Modulated Transmitters for Efficiency Enhancement , 2013 .

[6]  E. Norrman.  The Inductance-Capacitance Oscillator as a Frequency Divider , 1946, Proceedings of the IRE.

[7]  R. Adler.  A Study of Locking Phenomena in Oscillators , 1946, Proceedings of the IRE.

[8]  Mayank Raj,et al.  A Wideband Injection-Locking Scheme and Quadrature Phase Generation in 65-nm CMOS , 2013, IEEE Transactions on Microwave Theory and Techniques.

[9]  Xiang Yi,et al.  A 50–59 GHz CMOS Injection Locking Power Amplifier , 2015, IEEE Microwave and Wireless Components Letters.

[10]  R. Harjani,et al.  Fast Hopping Injection Locked Frequency Generation for UWB , 2007, 2007 IEEE International Conference on Ultra-Wideband.

[11]  X. Zhang,et al.  A study of subharmonic injection locking for local oscillators , 1992, IEEE Microwave and Guided Wave Letters.

[12]  David J. Allstot,et al.  Strong Injection Locking in Low- $Q$ LC Oscillators: Modeling and Application in a Forwarded-Clock I/O Receiver , 2009, IEEE Transactions on Circuits and Systems I: Regular Papers.

[13]  Henrik Sjöland,et al.  A Decade Frequency Range CMOS Power Amplifier for Sub-6-GHz Cellular Terminals , 2020, IEEE Microwave and Wireless Components Letters.

[14]  Jeffrey S. Walling,et al.  A Switched-Capacitor RF Power Amplifier , 2011, IEEE Journal of Solid-State Circuits.

[15]  Paul R. Gray,et al.  A 1.9-GHz, 1-W CMOS class-E power amplifier for wireless communications , 1999 .

[16]  L. J. Paciorek.  Injection locking of oscillators , 1965 .

[17]  Sangwook Nam,et al.  A novel high-efficiency linear transmitter using injection-locked pulsed oscillator , 2005, IEEE Microwave and Wireless Components Letters.

[18]  Ali Hajimiri,et al.  A Phasor-Based Analysis of Sinusoidal Injection Locking in LC and Ring Oscillators , 2019, IEEE Transactions on Circuits and Systems I: Regular Papers.

[19]  Michiel Steyaert,et al.  A 700-MHz 1-W fully differential CMOS class-E power amplifier , 2002 .

[20]  Bruce A. Wooley,et al.  A Digitally Modulated Polar CMOS PA with 20MHz Signal BW , 2007, 2007 IEEE International Solid-State Circuits Conference. Digest of Technical Papers.

[21]  Jan M. Rabaey,et al.  An Ultra-Low-Power Injection Locked Transmitter for Wireless Sensor Networks , 2006, IEEE Journal of Solid-State Circuits.

[22]  Lianming Li,et al.  20.3 An 86-to-94.3GHz transmitter with 15.3dBm output power and 9.6% efficiency in 65nm CMOS , 2016, 2016 IEEE International Solid-State Circuits Conference (ISSCC).

[23]  B. Razavi.  A study of injection locking and pulling in oscillators , 2004, IEEE Journal of Solid-State Circuits.

[24]  Henrik Sjöland,et al.  An Injection-Locked Power Up-Converter in 65-nm CMOS for Cellular Applications , 2019, IEEE Transactions on Microwave Theory and Techniques.

[25]  F. Raab.  Intermodulation distortion in Kahn-technique transmitters , 1996 .

[26]  F. Svelto,et al.  Analysis of reliability and power efficiency in cascode class-E PAs , 2006, IEEE Journal of Solid-State Circuits.

[27]  W. McFarland,et al.  An IC for linearizing RF power amplifiers using envelope elimination and restoration , 1998, 1998 IEEE International Solid-State Circuits Conference. Digest of Technical Papers, ISSCC. First Edition (Cat. No.98CH36156).

[28]  Songcheol Hong,et al.  A 29 dBm 70.7% PAE Injection-Locked CMOS Power Amplifier for PWM Digitized Polar Transmitter , 2010, IEEE Microwave and Wireless Components Letters.

[29]  Hong-Yeh Chang,et al.  A Broadband Injection-Locking Class-E Power Amplifier , 2012, IEEE Transactions on Microwave Theory and Techniques.

[30]  Jeffrey S. Walling,et al.  A Quadrature Switched Capacitor Power Amplifier , 2016, IEEE Journal of Solid-State Circuits.

[31]  Ali M. Niknejad,et al.  A fully-integrated efficient CMOS inverse Class-D power amplifier for digital polar transmitters , 2012, 2011 IEEE Radio Frequency Integrated Circuits Symposium.