Transposition of the mechanical behavior from model to prototype of Francis turbines

Abstract Hydropower is nowadays essential for balancing the electrical grid providing flexibility and fast response. The role of hydraulic turbines has changed from working at their Best Efficiency Point (BEP) to work in the whole operating range when demanded. Francis turbines working at off-design conditions suffer from dynamic problems that affect the useful life of their components, especially of the runner. Reduced scale physical models of Francis turbines are widely used to determine their hydraulic behavior. Most of the hydraulic parameters obtained in model tests are transposable to prototype by using the similarity theories as long as they meet similitude requirements. However, from the mechanical behavior point of view, both model and prototype structures are not always similar and the mechanical behavior of the model is often not considered for transposition. In this paper, a transposition method for the mechanical behavior of Francis turbines models is presented and the results are compared with the real size prototype. The modal behavior of the runner, its stress and fatigue life estimation for different operating conditions are experimentally compared for both model and prototype. Results present the possibilities and limitations of transposing the mechanical parameters from model to prototype.

[1]  Franco Romerio,et al.  The Future of Hydropower in Europe: Interconnecting Climate, Markets and Policies , 2014 .

[2]  Chirag Trivedi,et al.  Compressible Large Eddy Simulation of a Francis Turbine During Speed-No-Load: Rotor Stator Interaction and Inception of a Vortical Flow , 2018, Journal of Engineering for Gas Turbines and Power.

[3]  Eduard Egusquiza,et al.  Detection of cavitation in hydraulic turbines , 2006 .

[4]  Xin Liu,et al.  A review on fatigue damage mechanism in hydro turbines , 2016 .

[5]  Andres Müller,et al.  Flow characteristics and influence associated with inter-blade cavitation vortices at deep part load operations of a Francis turbine , 2017 .

[6]  Alexandre Presas,et al.  Accurate Determination of the Frequency Response Function of Submerged and Confined Structures by Using PZT-Patches † , 2017, Sensors.

[7]  Alexandre Presas,et al.  Power swing generated in Francis turbines by part load and overload instabilities , 2017 .

[8]  Alexandre Presas,et al.  On the detection of natural frequencies and mode shapes of submerged rotating disk-like structures from the casing , 2015 .

[9]  Chirag Trivedi,et al.  A review on fluid structure interaction in hydraulic turbines: A focus on hydrodynamic damping , 2017 .

[10]  Andres Müller,et al.  Fluid–structure interaction mechanisms leading to dangerous power swings in Francis turbines at full load , 2017 .

[11]  Eduard Egusquiza,et al.  Experimental investigation of added mass effects on a Francis turbine runner in still water , 2006 .

[12]  Christophe Nicolet,et al.  One-Dimensional Modeling of Rotor Stator Interaction in Francis Pump-Turbine , 2006 .

[13]  Stephane Etienne,et al.  A numerical method for the determination of flow-induced damping in hydroelectric turbines , 2017 .

[14]  Rama B. Bhat,et al.  Dynamic Testing of Structures Using Scale Models , 2005 .

[15]  Ulrich Seidel,et al.  Dynamic loads in Francis runners and their impact on fatigue life , 2014 .

[16]  Alexandre Presas,et al.  Influence of the rotation on the natural frequencies of a submerged-confined disk in water , 2015 .

[17]  Alexandre Presas,et al.  Sensor-Based Optimized Control of the Full Load Instability in Large Hydraulic Turbines , 2018, Sensors.

[18]  Alexandre Presas,et al.  Feasibility of Using PZT Actuators to Study the Dynamic Behavior of a Rotating Disk due to Rotor-Stator Interaction , 2014, Sensors.

[19]  Alexandre Presas,et al.  Feasibility to Detect Natural Frequencies of Hydraulic Turbines under Operation Using Strain Gauges , 2017 .

[20]  Eduard Egusquiza,et al.  Analysis of the dynamic response of pump-turbine impellers. Influence of the rotor , 2016 .

[21]  Marco Amabili,et al.  Damping for large-amplitude vibrations of plates and curved panels, Part 1: Modeling and experiments , 2016 .

[22]  Alexandre Presas,et al.  Feasibility of Detecting Natural Frequencies of Hydraulic Turbines While in Operation, Using Strain Gauges , 2018, Sensors.

[23]  Alexandre Presas,et al.  Detection and analysis of part load and full load instabilities in a real Francis turbine prototype , 2017 .

[24]  F. Avellan,et al.  Numerical simulation of fluid added mass effect on a francis turbine runner , 2007 .

[25]  Alexandre Presas,et al.  Extension of Operating Range in Pump-Turbines. Influence of Head and Load , 2017 .

[26]  Andres Müller,et al.  Analysis of the part load helical vortex rope of a Francis turbine using on-board sensors , 2015 .

[27]  Philippe Bocher,et al.  Impact of startup scheme on Francis runner life expectancy , 2010 .

[28]  François Avellan,et al.  Mechanical impact of dynamic phenomena in Francis turbines at off design conditions , 2017 .

[29]  Alexandre Presas,et al.  Dynamic response of a rotating disk submerged and confined. Influence of the axial gap , 2016 .

[30]  Darrell F. Socie,et al.  Simple rainflow counting algorithms , 1982 .

[31]  Alexandre Presas,et al.  Experimental Study of a Vibrating Disk Submerged in a Fluid-Filled Tank and Confined With a Nonrigid Cover , 2017 .

[32]  Eduard Egusquiza,et al.  Failure investigation of a large pump-turbine runner , 2012 .

[33]  Bernd Nennemann,et al.  Challenges in Dynamic Pressure and Stress Predictions at No-Load Operation in Hydraulic Turbines , 2014 .

[34]  Hiroshi Tanaka,et al.  Vibration Behavior and Dynamic Stress of Runners of Very High Head Reversible Pump-turbines , 2011 .

[35]  Alexandre Presas,et al.  Numerical study on the influence of acoustic natural frequencies on the dynamic behaviour of submerged and confined disk-like structures , 2017 .

[36]  Alexandre Presas,et al.  Transmission of High Frequency Vibrations in Rotating Systems. Application to Cavitation Detection in Hydraulic Turbines , 2018 .

[37]  Alexandre Presas,et al.  On the capability of structural-acoustical FSI simulations to predict natural frequencies of rotating disk-like structures submerged in a heavy fluid , 2016 .

[38]  R. Blevins,et al.  Formulas for natural frequency and mode shape , 1984 .

[39]  Andres Müller,et al.  LDV survey of cavitation and resonance effect on the precessing vortex rope dynamics in the draft tube of Francis turbines , 2016 .

[40]  F. Avellan,et al.  Study of the vortex-induced pressure excitation source in a Francis turbine draft tube by particle image velocimetry , 2015 .

[41]  Ilmar F. Santos,et al.  Frequencies in the Vibration Induced by the Rotor Stator Interaction in a Centrifugal Pump Turbine , 2007 .

[42]  Alexandre Presas,et al.  Experimental study on the added mass and damping of a disk submerged in a partially fluid-filled tank with small radial confinement , 2014 .

[43]  Alexandre Presas,et al.  Influence of the boundary conditions on the natural frequencies of a Francis turbine , 2016 .

[44]  N Ruchonnet,et al.  Fatigue analyses of the prototype Francis runners based on site measurements and simulations , 2014 .

[45]  Luc Gagnon,et al.  Adding wind energy to hydropower , 2002 .

[46]  Charles D. Norman,et al.  Comparison of Vibration Test Results for a Model and Prototype Arch Dam. , 1977 .

[47]  Andres Müller,et al.  Dynamics of the precessing vortex rope and its interaction with the system at Francis turbines part load operating conditions , 2017 .

[48]  Zerong Zhang,et al.  Similarity Analysis between Scale Model and Prototype of Large Vibrating Screen , 2015 .

[49]  Andres Müller,et al.  Dynamic modal analysis during reduced scale model tests of hydraulic turbines for hydro-acoustic characterization of cavitation flows , 2019, Mechanical Systems and Signal Processing.

[50]  Alexandre Presas,et al.  Overview of the experimental tests in prototype , 2017 .

[51]  Andres Müller,et al.  Experimental evidence of inter-blade cavitation vortex development in Francis turbines at deep part load condition , 2017 .