Review of integrated vehicle dynamics control architectures

Most of the chassis systems are developed by automotive suppliers to improve a specific vehicle performance. Drivers, and consequently vehicle manufacturers, are more concerned by the overall behaviour of the Vehicle. Many coordination architectures have been proposed in the literature in order to integrate different chassis systems in a single vehicle. In this paper, these architectures are compared and discussed. Two major classes are proposed: Downstream and Upstream Coordination. The purpose of this classification is to help car manufacturers and suppliers standardize an Integrated Vehicle Dynamics Control architecture for faster and more flexible designs.

[1]  Masao Nagai,et al.  Integrated Robust Control of Active Rear Wheel Steering and Direct Yaw Moment Control , 1997 .

[2]  Metin Ersoy,et al.  Chassis handbook : fundamentals, driving dynamics, components, mechatronics, perspectives , 2011 .

[3]  Mark Albert Selby,et al.  Intelligent vehicle motion control , 2003 .

[4]  Tor Arne Johansen,et al.  Control allocation - A survey , 2013, Autom..

[5]  Hyundong Heo,et al.  Integrated Chassis Control for Enhancement of High Speed Cornering Performance , 2015 .

[6]  Guodong Yin,et al.  Agent-based coordination framework for integrated vehicle chassis control , 2009 .

[7]  Ossama Mokhiamar,et al.  An integration of vehicle motion controls for full drive-by-wire vehicle , 2007 .

[8]  Amirmasoud Soltani.  Low cost integration of Electric Power-Assisted Steering (EPAS) with Enhanced Stability Program (ESP) , 2014 .

[9]  E. H. van den Berg.  Optimal Control Allocation on Over-Actuated Vehicles , 2016 .

[10]  Pascal Chaumette,et al.  Open-Interface Definitions for Automotive Systems Application to a Brake by Wire System , 2002 .

[11]  Yunqing Zhang,et al.  Integrated chassis control using ANFIS , 2008, 2008 IEEE International Conference on Automation and Logistics.

[12]  T. I. M. Gordon,et al.  Integrated Control Methodologies for Road Vehicles , 2003 .

[13]  Nicolas Navet,et al.  Automotive Embedded Systems Handbook , 2017 .

[14]  Ola Härkegård.  Dynamic Control Allocation Using Constrained Quadratic Programming , 2002 .

[15]  Tilman Bünte,et al.  Optimized force allocationߞA general approach to control and to investigate the motion of over-actu , 2006 .

[16]  María Jesús López Boada,et al.  Integrated control of front-wheel steering and front braking forces on the basis of fuzzy logic , 2006 .

[17]  C. Morgan,et al.  Development of neural-network control of steer-by-wire system for intelligent vehicles , 2002 .

[18]  Wuwei Chen,et al.  Integrated Control of Vehicle System Dynamics: Theory and Experiment , 2011 .

[19]  Danwei Wang,et al.  Coordination of steer angles, tyre inflation pressure, brake and drive torques for vehicle dynamics control , 2013 .

[20]  Nico A. Kelling,et al.  The BRAKE Project - Centralized Versus Distributed Redundancy for Brake-by-Wire Systems , 2002 .

[21]  Neil A. Duffie,et al.  Fault-tolerant heterarchical control of heterogeneous manufacturing system entities , 1988 .

[22]  Masao Nagai,et al.  Integrated Control of Active Rear Wheel Steering and Yaw Moment Control Using Braking Forces. , 1998 .

[23]  Francesco Borrelli,et al.  INTEGRATED BRAKING AND STEERING MODEL PREDICTIVE CONTROL APPROACH IN AUTONOMOUS VEHICLES , 2007 .

[24]  Ruben Morales-Menendez,et al.  Global chassis control system using suspension, steering, and braking subsystems , 2015 .

[25]  Seongjin Yim.  Coordinated control with electronic stability control and active steering devices , 2015 .

[26]  M. P. Gerard,et al.  Global Chassis Control and Braking Control using Tyre Forces Measurement , 2011 .

[27]  Weiwen Deng,et al.  Model predictive control allocation for stability improvement of four-wheel drive electric vehicles in critical driving condition , 2015 .

[28]  Johannes Tjønnås,et al.  Nonlinear and Adaptive Dynamic Control Allocation , 2008 .

[29]  Mauro Velardocchia,et al.  Control systems integration for enhanced vehicle dynamics , 2013 .

[30]  Junmin Wang,et al.  Lateral motion control for four-wheel-independent-drive electric vehicles using optimal torque allocation and dynamic message priority scheduling , 2014 .

[31]  Marc Bodson,et al.  Evaluation of optimization methods for control allocation , 2001 .

[32]  Markus Lienkamp,et al.  INTEGRATED VEHICLE DYNAMICS CONTROL BASED ON CONTROL ALLOCATION WITH SUBSYSTEM COORDINATION , 2013 .

[33]  Ansgar Trächtler,et al.  Closed-loop control with optimal tire-force distribution for the horizontal dynamics of an electric vehicle with single-wheel chassis actuators , 2013, 2013 American Control Conference.

[34]  Danwei Wang,et al.  Vehicle motion control with subsystem prioritization , 2015 .

[35]  Péter Gáspár,et al.  Active Suspension in Integrated Vehicle Control , 2009 .

[36]  Daniel P. Schrage,et al.  An open platform for reconfigurable control , 2001 .

[37]  Alberto Bemporad,et al.  An MPC/hybrid system approach to traction control , 2006, IEEE Transactions on Control Systems Technology.

[38]  Danwei Wang,et al.  Hardware-in-the-loop test rig for integrated vehicle control systems , 2013 .

[39]  Masanori Harada,et al.  Analysis of Lateral Stability with Integrated Control of Suspension and Steering Systems. , 1999 .

[40]  Dzmitry Savitski,et al.  Systematization of Integrated Motion Control of Ground Vehicles , 2015, IEEE Access.

[41]  Youmin Zhang,et al.  Bibliographical review on reconfigurable fault-tolerant control systems , 2003, Annu. Rev. Control..

[42]  S. Brennan,et al.  Integrated vehicle control via coordinated steering and wheel torque inputs , 2001, Proceedings of the 2001 American Control Conference. (Cat. No.01CH37148).

[43]  Ola Härkegård.  Dynamic Control Allocation Using Constrained Quadratic Programming , 2002 .