Modelling temperature and salt concentration distribution in membrane distillation feed channel

The method of Ilias and Govind for modeling ultrafiltration was modified to model a flat sheet air gap membrane distillation module with empty channels. In the membrane distillation process, there is mutual dependence of the momentum and heat transport processes. It complicates the solution of the governing equations and often leads to using simplifications. The developed method allows solving hydrodynamic and heat transport equations without additional assumptions for decoupling the equations with permeation taken into account. Velocity and temperature distributions inside the membrane feed channel were obtained, as well as the concentration profiles of a sparingly soluble salt (barium sulfate). Severe temperature polarization, occurring under poor mixing conditions, has been shown. Supersaturation profiles of barium sulfate are shown to be dependent on the inlet temperature of the membrane channel, and at certain conditions a maximum value of the barium sulfate concentration lies in the bulk of the channel, rather than at membrane surface.

[1]  M. C. García-Payo,et al.  Gas permeation and direct contact membrane distillation experiments and their analysis using different models , 2002 .

[2]  Mohamed Khayet,et al.  Theory and experiments on sweeping gas membrane distillation , 2000 .

[3]  M. C. García-Payo,et al.  Air gap membrane distillation of aqueous alcohol solutions , 2000 .

[4]  Anthony G. Fane,et al.  Gas and vapour transport through microporous membranes. I. Knudsen-Poiseuille transition , 1990 .

[5]  Anthony G. Fane,et al.  Optimal channel spacer design for ultrafiltration , 1991 .

[6]  S. P. Agashichev,et al.  Modeling and calculation of temperature-concentration polarisation in the membrane distillation process (MD) , 1993 .

[7]  Sudjito,et al.  Desalination by solar heated membrane distillation , 1991 .

[8]  Dianne E. Wiley,et al.  Spacer characterization and pressure drop modelling in spacer-filled channels for ultrafiltration☆ , 1994 .

[9]  A. B. Haan,et al.  Modelling of a transmembrane evaporation module for desalination of seawater , 1999 .

[10]  Anthony G. Fane,et al.  MASS FLUX ENHANCEMENT USING SPACER FILLED CHANNELS IN DIRECT CONTACT MEMBRANE DISTILLATION , 2001 .

[11]  P. M. Williams,et al.  Prediction of the rate of cross-flow ultrafiltration of colloids with concentration-dependent diffusion coefficient and viscosity : theory and experiment , 2001 .

[12]  Anthony G. Fane,et al.  Heat and mass transfer in membrane distillation , 1987 .

[13]  F. Banat,et al.  Modeling of Desalination Using Tubular Direct Contact Membrane Distillation Modules , 1999 .

[14]  M. C. García-Payo,et al.  Separation of binary mixtures by thermostatic sweeping gas membrane distillation: II. Experimental results with aqueous formic acid solutions , 2002 .

[15]  Gordon Atkinson,et al.  Thermodynamics of "scale" mineral solubilities. 1. Barium sulfate(s) in water and aqueous sodium chloride , 1988 .

[16]  M. C. García-Payo,et al.  Air gap membrane distillation of sucrose aqueous solutions , 1999 .

[17]  María del Carmen García Payo,et al.  Air gap membrane distillation of aqueous alcohol solutions , 2000 .

[18]  Enrico Drioli,et al.  Direct contact membrane distillation: modelling and concentration experiments , 2000 .

[19]  P. Sheng,et al.  Theory and Simulations , 2003 .

[20]  M. C. García-Payo,et al.  Separation of binary mixtures by thermostatic sweeping gas membrane distillation: I. Theory and simulations , 2002 .