Numerical and experimental studies on propagation of A0 mode in a composite plate containing semi-infinite delamination: Observation of turning modes

Abstract Propagation of the anti-symmetric fundamental Lamb mode ( A 0 ) in a composite laminate containing a semi-infinite delamination was studied through numerical simulations and experimental studies. Here, the wave was generated on a sub-laminate above the delaminated region, and the reflection and transmission of the Lamb modes at the edge of the discontinuity were quantitatively studied. The wave group (named as ‘turning mode’), which was made to propagate from one side of the delamination to the other side (through delaminations) was captured and its transmission factor was estimated. Reflection and transmission factors of wave groups were estimated for three different laminates – quasi-isotropic, unidirectional and cross-ply, containing delamination at various interfaces across thickness. Propagation of ‘turning modes’ were also captured experimentally, employing air-coupled transducers, in quasi-isotropic laminates containing delaminations at different interfaces. Attenuation compensation was incorporated in the experimental signals to improve the comparison of transmission and reflection factors between numerical simulations and experiments.

[1]  Carlos E. S. Cesnik,et al.  Review of guided-wave structural health monitoring , 2007 .

[2]  Li Zhou,et al.  Power Reflection and Transmission in Beam Structures Containing a Semi-Infinite Crack , 2008 .

[3]  Emmanuel Moulin,et al.  Radome health monitoring with Lamb waves: experimental approach , 2000 .

[4]  J. Takatsubo,et al.  Lamb wave method for quick inspection of impact-induced delamination in composite laminates , 2004 .

[5]  K. Craig,et al.  Damage detection in composite structures using piezoelectric materials (and neural net) , 1994 .

[6]  Bruno Morvan,et al.  Interaction of Lamb waves on bonded composite plates with defects , 2007 .

[7]  K. Balasubramaniam,et al.  Interaction of the primary anti-symmetric Lamb mode (Ao) with symmetric delaminations: numerical and experimental studies , 2009 .

[8]  K. Balasubramaniam,et al.  Ultrasonic guided wave energy behavior in laminated anisotropic plates , 2006 .

[9]  Lin Ye,et al.  Some aspects of numerical simulation for Lamb wave propagation in composite laminates , 2006 .

[10]  S. I. Rokhlin,et al.  Coupling of Lamb waves with the aperture between two elastic sheets , 1983 .

[11]  K. Alnefaie,et al.  Finite element modeling of composite plates with internal delamination , 2009 .

[12]  Lin Ye,et al.  Lamb wave-based quantitative identification of delamination in CF/EP composite structures using artificial neural algorithm , 2004 .

[13]  E. Birt.  Damage detection in carbon-fibre composites using ultrasonic Lamb waves , 1998 .

[14]  Peter Cawley,et al.  Single Sided Inspection of Composite Materials Using Air Coupled Ultrasound , 1998 .

[15]  R Kazys,et al.  3D analysis of interaction of Lamb waves with defects in loaded steel plates. , 2006, Ultrasonics.

[16]  P. Cawley,et al.  The interaction of Lamb waves with delaminations in composite laminates , 1993 .

[17]  Krishnan Balasubramaniam,et al.  Delamination Size Detection using Time of Flight of Anti-symmetric (Ao) and Mode Converted Ao mode of Guided Lamb Waves , 2010 .

[18]  B. S. Wong,et al.  Experimental evaluation of delaminations in composite plates by the use of Lamb waves , 1995 .

[19]  Krishnan Balasubramaniam,et al.  Interaction of guided Lamb waves with an asymmetrically located delamination in a laminated composite plate , 2010 .

[20]  R Kazys,et al.  Air-coupled ultrasonic investigation of multi-layered composite materials. , 2006, Ultrasonics.

[21]  J. Rose.  Ultrasonic Waves in Solid Media , 1999 .

[22]  L. Rose,et al.  Wave reflection and transmission in beams containing delamination and inhomogeneity , 2003 .

[23]  Fuh-Gwo Yuan,et al.  Wave reflection and transmission in composite beams containing semi-infinite delamination , 2008 .