Thermal energy storage and release of a new component with PCM for integration in floors for thermal management of buildings

Abstract Lightweight envelopes (used primarily for economic reasons) are widely used in modern buildings but their low thermal capacity does not allow an optimal thermal comfort situation to be obtained in summer period. A solution is proposed here by using phase change materials (PCMs) incorporated in building structures to increase their thermal inertia without increasing their volume. A new polymer composite PCM containing 85% of paraffin, with a latent heat of melting of 110 kJ/kg and a melting point at about 27 °C, is incorporated in a hollow concrete floor panel. Experimental investigation on thermal behavior is presented to study the response to a temperature variation. Results clearly show the influence of PCM, namely a decrease of the surface wall temperature amplitude and an increase of thermal energy stored. A numerical simulation with COMSOL Multiphysics ® software confirms the enhancement of the floor inertia by the incorporation of the PCM. The simulation provides design guidelines for the thermal management system to minimize the quantity and size of PCM.

[1]  Javier Mazo,et al.  Modeling a radiant floor system with Phase Change Material (PCM) integrated into a building simulation tool: Analysis of a case study of a floor heating system coupled to a heat pump , 2012 .

[2]  Yvan Dutil,et al.  A review on phase-change materials: Mathematical modeling and simulations , 2011 .

[3]  Xu Xu,et al.  Modeling and simulation on the thermal performance of shape-stabilized phase change material floor used in passive solar buildings , 2005 .

[4]  Saleh A. Al-Ajlan,et al.  Measurements of thermal properties of insulation materials by using transient plane source technique , 2006 .

[5]  Luisa F. Cabeza,et al.  Review on thermal energy storage with phase change: materials, heat transfer analysis and applications , 2003 .

[6]  Esam M. Alawadhi,et al.  Thermal analysis of a building brick containing phase change material , 2008 .

[7]  Alberto Giretti,et al.  Radiant floors integrated with PCM for indoor temperature control , 2011 .

[8]  Mohammed M. Farid,et al.  A Review on Energy Conservation in Building Applications with Thermal Storage by Latent Heat Using Phase Change Materials , 2021, Thermal Energy Storage with Phase Change Materials.

[9]  A. Sharma,et al.  Review on thermal energy storage with phase change materials and applications , 2009 .

[10]  Jianlei Niu,et al.  Performance of cooled-ceiling operating with MPCM slurry , 2009 .

[11]  Fredrik Setterwall,et al.  Phase transition temperature ranges and storage density of paraffin wax phase change materials , 2004 .

[12]  Luisa F. Cabeza,et al.  Experimental study of using PCM in brick constructive solutions for passive cooling , 2010 .

[13]  Frank P. Incropera,et al.  Fundamentals of Heat and Mass Transfer , 1981 .

[14]  Beat Lehmann,et al.  Development of a thermally activated ceiling panel with PCM for application in lightweight and retrofitted buildings , 2004 .

[15]  V. V. Tyagi,et al.  PCM thermal storage in buildings: A state of art , 2007 .