Crack growth criteria incorporating non-singular stresses: Size effect in apparent fracture toughness

Simple criteria accounting for the non-singular stresses at the crack tip are considered. They are based on the comparison of the local stress concentration with the material microstrength. The local stress concentration is estimated either as the magnitude of the conventional elastic stress ahead of the process zone, or by its averaging over the process zone length. When a criterion of this type is used to find the critical load and then the conventional fracture toughness, the latter will be dependent of the crack length. This size effect in fracture toughness manifests itself as an increase (if the non-singular part of the near-tip stress field is positive) or decrease (if the non-singular part is negative) in the apparent fracture toughness as the crack length increases. The obtained dependence is compared with available experimental data. It is also shown that when the load can be resolved into a superposition of elementary loads, the size effect can asymptotically (for long cracks) be presented as a weighted sum of the elementary size effects (i.e. the size effects associated with the elementary loads) with the weights equal to the relative contributions of the elementary loads into the total stress intensity factor.

[1]  N. Muskhelishvili.  Some basic problems of the mathematical theory of elasticity , 1953 .

[2]  D. S. Dugdale.  Yielding of steel sheets containing slits , 1960 .

[3]  G. I. Barenblatt.  THE MATHEMATICAL THEORY OF EQUILIBRIUM CRACKS IN BRITTLE FRACTURE , 1962 .

[4]  V. V. Novozhilov,et al.  On a necessary and sufficient criterion for brittle strength: PMM vol. 33, n≗2, 1969, pp. 212–222 , 1969 .

[5]  J. Whitney,et al.  Stress Fracture Criteria for Laminated Composites Containing Stress Concentrations , 1974 .

[6]  Harold Liebowitz,et al.  Crack border stress and displacement equations revisited , 1977 .

[7]  A. R. Ingraffea,et al.  Experimental verification of a fracture mechanics model for tensile strength prediction of Indiana Limestone , 1978 .

[8]  G. Leonardo.  Fracture toughness characterization of materials under multiaxial loading , 1979 .

[9]  J. Rice,et al.  Slightly curved or kinked cracks , 1980 .

[10]  J. D. Embury,et al.  A Treatment of Inelastic Deformation Around a Crack Tip due to Microcracking , 1980 .

[11]  W. C. Cooley,et al.  Mechanics of Brittle Fracture , 1982 .

[12]  Mark Kachanov,et al.  Interaction of a crack with a field of microcracks , 1983 .

[13]  H. Rossmanith.  Modelling of fracture process zones and singularity dominated zones , 1983 .

[14]  Arne Hillerborg,et al.  Analysis of one single crack , 1983 .

[15]  V. P. Tamuzh,et al.  Propagation of a main crack in a body with distributed microcracks , 1984 .

[16]  Joseph F Labuz,et al.  EXPERIMENTAL ANALYSIS OF CRACK PROPAGATION IN GRANITE , 1985 .

[17]  Alberto Carpinteri,et al.  Mechanical damage and crack growth in concrete , 1986 .

[18]  John W. Hutchinson,et al.  Crack tip shielding by micro-cracking in brittle solids , 1987 .

[19]  S. Nemat-Nasser,et al.  Toughening by partial or full bridging of cracks in ceramics and fiber reinforced composites , 1987 .

[20]  Michael Ortiz,et al.  Microcrack coalescence and macroscopic crack growth initiation in brittle solids , 1988 .

[21]  Surendra P. Shah,et al.  Experimental methods for determining fracture process zone and fracture parameters , 1990 .

[22]  Z. Bažant,et al.  IDENTIFICATION OF NONLINEAR FRACTURE PROPERTIES FROM SIZE EFFECT TESTS AND STRUCTURAL ANALYSIS BASED ON GEOMETRY-DEPENDENT R-CURVES , 1991 .

[23]  G. C. Sih,et al.  A special theory of crack propagation , 1991 .

[24]  H. Horii,et al.  Analytical modeling of microcracking and bridging in the fracture of quasi-brittle materials , 1992 .

[25]  Arcady Dyskin,et al.  A model of crack growth in microcracked rock , 1993 .

[26]  Hoshide Toshihiko.  Grain fracture model and its application to strength evaluation in engineering ceramics , 1993 .

[27]  Brian N. Cox,et al.  Concepts for bridged cracks in fracture and fatigue , 1994 .

[28]  S. Gong.  On the formation of near-tip microcracking and associated toughening effects , 1995 .

[29]  A FEM analysis of crack growth in microcracking brittle solids , 1995 .

[30]  Andy Ruina,et al.  Why K? High order singularities and small scale yielding , 1995 .