A low power, reconfigurable fabric body area network for healthcare applications

Body Area Networks (BANs) are gaining prominence for their capability to revolutionize medical monitoring, diagnosis and treatment. This thesis describes a BAN that uses conductive fabrics (e-textiles) worn by the user to act as a power distribution and data communication network to sensors on the user’s body. The network is controlled by a central hub in the form of a Base Station, which can either be a standalone device or can be embedded inside one of the user’s portable electronic devices like a cellphone. Specifications for a Physical (PHY) layer and a Medium Access Control (MAC) layer have been developed that make use of the asymmetric energy budgets between the base station and sensor nodes in the network. The PHY layer has been designed to be suitable for the unique needs of such a BAN, namely easy reconfigurability, fault-tolerance and efficient energy and data transfer at low power levels. This is achieved by a mechanism for dividing the network into groups of sensors. The co-designed MAC layer is capable of supporting a wide variety of sensors with different data rate and network access requirements, ranging from EEG monitors to temperature sensors. Circuits have been designed at both ends of the network to transmit, receive and store power and data in appropriate frequency bands. Digital circuits have been designed to implement the MAC protocols. The base station and sensor nodes have been implemented in standard 180nm 1P6M CMOS process, and occupy an area 4.8mm and 3.6mm respectively. The base station has a minimum power consumption of 2.86mW, which includes the power transmitter, modulation and demodulation circuitry. The sensor nodes can recover up to 33.6μW power to supply to the biomedical signal acquisition circuitry with peak transfer efficiency of 1.2%. Thesis Supervisor: Anantha P. Chandrakasan Title: Joseph F. and Nancy P. Keithley Professor of Electrical Engineering

[1]  A. Lymberis,et al.  Wearable eHealth Systems For Personalised Health Management: State Of The Art and Future Challenges , 2004 .

[2]  Denis C. Daly,et al.  A pulsed UWB receiver SoC for insect motion control , 2009, 2009 IEEE International Solid-State Circuits Conference - Digest of Technical Papers.

[3]  W. Weber,et al.  Enabling technologies for disappearing electronics in smart textiles , 2003, 2003 IEEE International Solid-State Circuits Conference, 2003. Digest of Technical Papers. ISSCC..

[4]  C.M. Zierhofer,et al.  High-efficiency coupling-insensitive transcutaneous power and data transmission via an inductive link , 1990, IEEE Transactions on Biomedical Engineering.

[5]  Phillip Nadeau.  Multi-channel ultra-low-power receiver architecture for body area networks , 2011 .

[6]  Wentai Liu,et al.  Design and analysis of an adaptive transcutaneous power telemetry for biomedical implants , 2005, IEEE Transactions on Circuits and Systems I: Regular Papers.

[7]  Deborah Estrin,et al.  An energy-efficient MAC protocol for wireless sensor networks , 2002, Proceedings.Twenty-First Annual Joint Conference of the IEEE Computer and Communications Societies.

[8]  O. Omeni,et al.  Energy Efficient Medium Access Protocol for Wireless Medical Body Area Sensor Networks , 2007 .

[9]  M. Lakshmanan,et al.  AN ADAPTIVE ENERGY EFFICIENT MAC PROTOCOL FOR WIRELESS SENSOR NETWORKS , 2009 .

[10]  F.C. Lee,et al.  A MOSFET resonant synchronous rectifier for high-frequency DC/DC converters , 1990, 21st Annual IEEE Conference on Power Electronics Specialists.

[11]  Seulki Lee,et al.  A 1.12 pJ/b Inductive Transceiver With a Fault-Tolerant Network Switch for Multi-Layer Wearable Body Area Network Applications , 2009, IEEE Journal of Solid-State Circuits.

[12]  Soumyajit Mandal,et al.  Power-Efficient Impedance-Modulation Wireless Data Links for Biomedical Implants , 2008, IEEE Transactions on Biomedical Circuits and Systems.

[13]  Anantha Chandrakasan,et al.  A Supply-Rail-Coupled eTextiles Transceiver for Body-Area Networks , 2011, IEEE Journal of Solid-State Circuits.

[14]  Zamora,et al.  Electronic textiles: a platform for pervasive computing , 2003, Proceedings of the IEEE.

[15]  Stephen P. Boyd,et al.  Simple accurate expressions for planar spiral inductances , 1999, IEEE J. Solid State Circuits.

[16]  Klaus Finkenzeller,et al.  Rfid Handbook: Fundamentals and Applications in Contactless Smart Cards and Identification , 2003 .

[17]  D. Yamazaki,et al.  A Passive UHF RF Identification CMOS Tag IC Using Ferroelectric RAM in 0.35-$\mu{\hbox {m}}$ Technology , 2007, IEEE Journal of Solid-State Circuits.

[18]  J. Sebastian,et al.  Optimized synchronous rectification stage for low output voltage (3.3 V) DC/DC conversion , 1994, Proceedings of 1994 Power Electronics Specialist Conference - PESC'94.

[19]  C.R. Hogge.  A self correcting clock recovery circuit , 1985, IEEE Transactions on Electron Devices.

[20]  I.E. Lamprinos,et al.  Energy-efficient MAC Protocol for Patient Personal Area Networks , 2005, 2005 IEEE Engineering in Medicine and Biology 27th Annual Conference.

[21]  L. Kohn,et al.  To Err Is Human : Building a Safer Health System , 2007 .

[22]  Maysam Ghovanloo,et al.  A Wide-Band Power-Efficient Inductive Wireless Link for Implantable Microelectronic Devices Using Multiple Carriers , 2007, IEEE Transactions on Circuits and Systems I: Regular Papers.

[23]  Hoi-Jun Yoo,et al.  A 0.2-mW 2-Mb/s Digital Transceiver Based on Wideband Signaling for Human Body Communications , 2007, IEEE Journal of Solid-State Circuits.

[24]  Soumyajit Mandal,et al.  Low-Power CMOS Rectifier Design for RFID Applications , 2007, IEEE Transactions on Circuits and Systems I: Regular Papers.

[25]  Hoi-Jun Yoo,et al.  A 0.5-μ Vrms 12-μ W Wirelessly Powered Patch-Type Healthcare Sensor for Wearable Body Sensor Network , 2010, IEEE J. Solid State Circuits.

[26]  Anantha Chandrakasan,et al.  An 8-channel scalable EEG acquisition SoC with fully integrated patient-specific seizure classification and recording processor , 2012, 2012 IEEE International Solid-State Circuits Conference.

[27]  A.P. Chandrakasan,et al.  An Energy-Efficient All-Digital UWB Transmitter Employing Dual Capacitively-Coupled Pulse-Shaping Drivers , 2009, IEEE Journal of Solid-State Circuits.

[28]  Choongyeun Cho,et al.  Symmetric Vertical Parallel Plate Capacitors for On-Chip RF Circuits in 65-nm SOI Technology , 2007, IEEE Electron Device Letters.

[29]  Sungmee Park,et al.  Enhancing the quality of life through wearable technology , 2003, IEEE Engineering in Medicine and Biology Magazine.

[30]  Hoi-Jun Yoo,et al.  A 0.24nJ/b wireless body-area-network transceiver with scalable double-FSK modulation , 2011, 2011 IEEE International Solid-State Circuits Conference.

[31]  Marian Verhelst,et al.  A reconfigurable, 0.13µm CMOS 110pJ/pulse, fully integrated IR-UWB receiver for communication and sub-cm ranging , 2009, 2009 IEEE International Solid-State Circuits Conference - Digest of Technical Papers.

[32]  Sundaresan Jayaraman,et al.  The Wearable Motherboard™: The first generation of adaptive and responsive textile structures (ARTS) for medical applications , 1999, Virtual Reality.

[33]  Seulki Lee,et al.  A 5.2 mW Self-Configured Wearable Body Sensor Network Controller and a 12 $\mu$ W Wirelessly Powered Sensor for a Continuous Health Monitoring System , 2010, IEEE Journal of Solid-State Circuits.

[34]  H. Yoshida,et al.  A 950-MHz rectifier circuit for sensor network tags with 10-m distance , 2006, IEEE Journal of Solid-State Circuits.

[35]  Anantha Chandrakasan,et al.  A Biomedical Sensor Interface With a sinc Filter and Interference Cancellation , 2011, IEEE Journal of Solid-State Circuits.

[36]  G. Troster,et al.  Design and Characterization of Purely Textile Patch Antennas , 2006, IEEE Transactions on Advanced Packaging.

[37]  Rahul Sarpeshkar,et al.  Feedback Analysis and Design of RF Power Links for Low-Power Bionic Systems , 2007, IEEE Transactions on Biomedical Circuits and Systems.

[38]  G. D. Alley.  Interdigital Capacitors and Their Application to Lumped-Element Microwave Integrated Circuits , 1970 .

[39]  Hyejung Kim,et al.  A Wearable Fabric Computer by Planar-Fashionable Circuit Board Technique , 2009, 2009 Sixth International Workshop on Wearable and Implantable Body Sensor Networks.

[40]  Hoi-Jun Yoo,et al.  Electrical Characterization of Screen-Printed Circuits on the Fabric , 2010, IEEE Transactions on Advanced Packaging.

[41]  Christian Joachim,et al.  The physics of the near-field , 2000 .

[42]  Christofer Toumazou,et al.  A 1 V Wireless Transceiver for an Ultra-Low-Power SoC for Biotelemetry Applications , 2008, IEEE Journal of Solid-State Circuits.

[43]  Arun Paidimarri,et al.  Architecture for ultra-low power multi-channel transmitters for Body Area Networks using RF resonators , 2011 .

[44]  William P. Marnane,et al.  Energy-Efficient Low Duty Cycle MAC Protocol for Wireless Body Area Networks , 2009, IEEE Transactions on Information Technology in Biomedicine.

[45]  Oscar Garcia,et al.  A new driving scheme for synchronous rectifiers: single winding self-driven synchronous rectification , 2001 .

[46]  Seulki Lee,et al.  A 75μW real-time scalable network controller and a 25μW ExG sensor IC for compact sleep-monitoring applications , 2011, 2011 IEEE International Solid-State Circuits Conference.

[47]  Maysam Ghovanloo,et al.  A wideband frequency-shift keying wireless link for inductively powered biomedical implants , 2004, IEEE Transactions on Circuits and Systems I: Regular Papers.

[48]  Naveen Verma,et al.  A Micro-Power EEG Acquisition SoC With Integrated Feature Extraction Processor for a Chronic Seizure Detection System , 2010, IEEE Journal of Solid-State Circuits.

[49]  Mohamad Sawan,et al.  High-Speed OQPSK and Efficient Power Transfer Through Inductive Link for Biomedical Implants , 2010, IEEE Transactions on Biomedical Circuits and Systems.

[50]  G. Troster,et al.  Electrical characterization of textile transmission lines , 2003 .

[51]  Anantha P. Chandrakasan,et al.  Low-power CMOS digital design , 1992 .