Experimental investigation of the heat and mass transfer phenomena in a counterflow wet cooling tower with foam ceramic packing

This article deals with an experimental investigation of coinstantaneous heat and mass transfer phenomena between water and air in a counterflow wet cooling tower filled with a new type packing named “FCP-08.” The packing consisted of foamed ceramic corrugated board with sine waves, surface retention groove is 1.0 m high, and it has a cross-sectional test area of 0.68 m × 0.68 m. This investigation is focused mainly on the effect of the water–air mass flow ratio on the heat and mass transfer characteristics of the cooling tower, for different inlet water temperatures. The results show that the cooling water range, R , and the cooling tower efficiency, e , decrease with the increase in water–air mass flow ratio, L / G . Meanwhile, the heat rejected by the cooling tower, Q w , increases with the increase in the water mass flow rate. The cooling characteristic coefficient, K α V / L , slightly decreases with the increase in water–air mass flow ratio and the value is obviously higher than that of other packing investigated before. The relationship between the cooling characteristic coefficient and water–air mass flow ratio is obtained by linear fitting. The comparison between the obtained results and those found in the literature for other types of packing indicates that cooling performance of the tower with foam ceramic packing is better.

[1]  B. Kraushaar-Czarnetzki,et al.  Ceramic Foam Monoliths as Catalyst Carriers. 1. Adjustment and Description of the Morphology , 2003 .

[2]  Don W. Green,et al.  Perry's chemical engineers' handbook. 7th ed. , 1997 .

[3]  Esam Elsarrag,et al.  Experimental study and predictions of an induced draft ceramic tile packing cooling tower , 2006 .

[4]  A. K. M. Mohiuddin,et al.  Cooling tower: an energy conservation resource , 1992 .

[5]  Farhad Gharagheizi,et al.  Experimental study on the performance of mechanical cooling tower with two types of film packing , 2007 .

[6]  Kankanhalli N. Seetharamu,et al.  Experimental investigation of the performance of a counter-flow, packed-bed mechanical cooling tower , 1998 .

[7]  J. C. Kloppers,et al.  A critical evaluation and refinement of the performance prediction of wet-cooling towers , 2003 .

[8]  M. Deshusses,et al.  Determination of mass transfer coefficients for packing materials used in biofilters and biotrickling filters for air pollution control—2: Development of mass transfer coefficients correlations , 2008 .

[9]  R. J. Moffat,et al.  Contributions to the Theory of Single-Sample Uncertainty Analysis , 1982 .

[10]  M. Boumaza,et al.  Thermal performances investigation of a wet cooling tower , 2007 .

[11]  M. Boumaza,et al.  Experimental analysis of heat and mass transfer phenomena in a direct contact evaporative cooling tower , 2009 .

[12]  H. El-Dessouky.  Thermal and hydraulic performance of a three-phase fluidized bed cooling tower , 1993 .

[13]  M. Boumaza,et al.  Experimental investigation of the performance characteristics of a counterflow wet cooling tower , 2010 .

[14]  J. Braun.  Methodologies for the Design and Control of Central Cooling Plants , 1988 .

[15]  J. F. Missenden,et al.  The investigation of cooling tower packing in various arrangements , 2000 .

[16]  L. D. Berman,et al.  Evaporative cooling of circulating water , 1961 .