Experiments on the Stability and Response of a Flexible Rotor in Three Types of Journal Bearings

Three sets of bearings were tested on a three-mass flexible rotor: axial-groove, pressure-dam and preloaded three-lobe, and the instability thresholds and unbalance responses were determined. The pressure-dam bearings were designed for maximum rigid rotor stability; the three-lobe bearings had preload factors of approximately 0.75. Rotor first and second critical speeds were observed at 2550 and 9800 rpm, respectively. The instability thresholds and unbalance responses at the first critical speed for the axial-groove and three-lobe bearings were found to be strongly dependent on the load orientation. Maximum stability limits of 6550, 7400 and 10 400 rpm were found for the axial-groove, pressure-dam, and three-lobe bearings, respectively. Thus, the preloaded three-lobe bearings were the only set that allowed this particular rotor to operate above the second critical speed. The experimental data were also compared to theoretical predictions. Differences in instability thresholds of up to 37 percent were rea...

[1]  E. J. Gunter,et al.  Systems of Finite Elements for Finite Bearings , 1977 .

[2]  Paul E. Allaire,et al.  Analysis of Step Journal Bearings—Finite Length, Stability , 1980 .

[3]  B. J. Hamrock,et al.  Rayleigh Step Journal Bearing, Part II—Incompressible Fluid , 1968 .

[4]  C. F. Kettleborough,et al.  An Approximate Analytical Solution for the Stepped Bearing , 1961 .

[5]  Paul E. Allaire,et al.  Experimental Study of Three Journal Bearings with a Flexible Rotor , 1980 .

[6]  O. Pinkus.  Analysis and Characteristics of the Three-Lobe Bearing , 1959 .

[7]  J. W. Lund,et al.  Stability and Damped Critical Speeds of a Flexible Rotor in Fluid-Film Bearings , 1974 .

[8]  J. Glienicke,et al.  Paper 13: Experimental Investigation of the Stiffness and Damping Coefficients of Turbine Bearings and Their Application to Instability Prediction: , 1966 .

[9]  Paul E. Allaire,et al.  Analysis of Step Journal Bearings—Infinite Length, Inertia Effects , 1979 .

[10]  C. Ettles,et al.  The Application of a Finite Element Method to the Evaluation of oil Whirl Characteristics , 1974 .

[11]  Ronald D. Flack,et al.  An experimental determination of the instability of a flexible rotor in four-lobe bearings , 1980 .

[12]  J. W. Lund,et al.  Some Experiments on Instability of Rotors Supported in Fluid-Film Bearings , 1978 .

[13]  L. E. Barrett,et al.  Experimental-Theoretical Comparison of Instability Onset Speeds for a Three Mass Rotor Supported by Step Journal Bearings , 1980 .

[14]  I. W. Mayes,et al.  The Dynamics of Multi-Rotor Systems Supported on Oil Film Bearings , 1978 .

[15]  O. Pinkus,et al.  Theory of Hydrodynamic Lubrication , 1962 .

[16]  Donald F. Wilcock,et al.  Bearing design and application , 1957 .