Support for a linear length-tension relation of the torso extensor muscles: an investigation of the length and velocity EMG-force relationships.

This study investigated the hypothesis that the length-tension relation of the torso erectors would be linear, mirroring the observed linear increase in extension strength capability toward full flexion. The effect of torso extension velocity on the tension capability of these muscles was also investigated for common motion speeds. A myoelectric-based approach was used wherein a dynamic biomechanical model incorporating active and passive tissue characteristics provided muscle kinematic estimates during controlled sagittal plane extension motions. A double linear optimization formulation from the literature provided muscle tension estimates. The data of five male subjects supported the hypothesis of a linear length-tension relation toward full flexion for both the erector spinae and latissimus muscles. Velocity trends agreed with the predicted by Hill's exponential relation, although linear trends were found to fit the data almost as well. The results have implications for muscle tension estimation in biomechanical torso modeling, and suggest a possible low back pain injury mechanism through tissue strain while lifting in fully flexed postures.

[1]  M Solomonow,et al.  Architecture-based force-velocity models of load-moving skeletal muscles. , 1995, Clinical biomechanics.

[2]  O. Lippold,et al.  The relation between force, velocity and integrated electrical activity in human muscles , 1954, The Journal of physiology.

[3]  G A Mirka,et al.  The quantification of EMG normalization error. , 1991, Ergonomics.

[4]  A. Thorstensson,et al.  The role of the abdominal musculature in the elevation of the intra-abdominal pressure during specified tasks. , 1989, Ergonomics.

[5]  S M McGill,et al.  Passive stiffness of the human neck in flexion, extension, and lateral bending. , 1994, Clinical biomechanics.

[6]  D B Chaffin,et al.  Development and evaluation of a scalable and deformable geometric model of the human torso. , 1996, Clinical biomechanics.

[7]  W S Marras,et al.  A Three-Dimensional Motion Model of Loads on the Lumbar Spine: I. Model Structure , 1991, Human factors.

[8]  J. Desmedt,et al.  New Developments in Electromyography and Clinical Neurophysiology , 1973 .

[9]  W S Marras,et al.  Measurements of Loads on the Lumbar Spine Under Isometric and Isokinetic Conditions , 1984, Spine.

[10]  J. van den Berg,et al.  EMG to force processing I: An electrical analogue of the Hill muscle model. , 1981, Journal of biomechanics.

[11]  D. Winter,et al.  Predictions of knee and ankle moments of force in walking from EMG and kinematic data. , 1985, Journal of biomechanics.

[12]  W. Marras,et al.  A Biomechanical Assessment and Model of Axial Twisting in the Thoracolumbar Spine , 1995, Spine.

[13]  A B Schultz,et al.  Biomechanical model calculation of muscle contraction forces: a double linear programming method. , 1988, Journal of biomechanics.

[14]  D B Chaffin,et al.  A longitudinal study of low-back pain as associated with occupational weight lifting factors. , 1973, American Industrial Hygiene Association journal.

[15]  D. Chaffin,et al.  Trunk and hip muscle recruitment in response to external anterior lumbosacral shear and moment loads. , 1996, Clinical biomechanics.

[16]  D B Chaffin,et al.  Torso muscle moment arms at intervertebral levels T10 through L5 from CT scans on eleven male and eight female subjects. , 1993, Spine.

[17]  Ulrich Raschke.  Lumbar muscle activity prediction under dynamic sagittal plane lifting conditions: Physiological and biomechanical modeling considerations. , 1994 .

[18]  W. G. Allread,et al.  The Role of Dynamic Three-Dimensional Trunk Motion in Occupationally-Related Low Back Disorders: The Effects of Workplace Factors, Trunk Position, and Trunk Motion Characteristics on Risk of Injury , 1993, Spine.

[19]  P. V. Komi,et al.  Relationship between Muscle Tension, EMG and Velocity of Contraction under Concentric and Eccentric Work , 1973 .

[20]  J A Faulkner,et al.  Length-tension relationship of mammalian diaphragm muscles. , 1983, Journal of applied physiology: respiratory, environmental and exercise physiology.

[21]  M J Pearcy,et al.  Mechanical function of the human lumbar interspinous and supraspinous ligaments. , 1990, Journal of biomedical engineering.

[22]  J. Winters,et al.  Effect of initial upper-limb alignment on muscle contributions to isometric strength curves. , 1993, Journal of biomechanics.

[23]  Lina Santaguida,et al.  Measurement of the trunk musculature from T5 to L5 using MRI scans of 15 young males corrected for muscle fibre orientation. , 1993, Clinical biomechanics.

[24]  W S Marras,et al.  A stochastic model of trunk muscle coactivation during trunk bending. , 1993, Spine.

[25]  A Luttmann,et al.  Biomechanical analysis and assessment of lumbar stress during load lifting using a dynamic 19-segment human model. , 1989, Ergonomics.

[26]  A. Bahler,et al.  Modeling of mammalian skeletal muscle. , 1968, IEEE transactions on bio-medical engineering.

[27]  R. D'ambrosia,et al.  The isometric length-force models of nine different skeletal muscles. , 1992, Journal of biomechanics.

[28]  A. Huxley.  Muscle structure and theories of contraction. , 1957, Progress in biophysics and biophysical chemistry.

[29]  W Herzog,et al.  Force-length properties and functional demands of cat gastrocnemius, soleus and plantaris muscles. , 1992, Journal of biomechanics.

[30]  G. Smidt,et al.  Assessment of Abdominal and Back Extensor Function: A Quantitative Approach and Results for Chronic Low‐Back Patients , 1983, Spine.

[31]  M. Pollock,et al.  Quantitative Assessment of Full Range‐of-Motion Isometric Lumbar Extension Strength , 1990, Spine.

[32]  A. Thorstensson,et al.  Trunk muscle strength during constant velocity movements. , 1982, Scandinavian journal of rehabilitation medicine.

[33]  Richard Evan Hughes,et al.  Empirical evaluation of optimization-based lumbar muscle force prediction models. , 1991 .

[34]  R. Norman,et al.  1986 Volvo Award in Biomechanics: Partitioning of the L4 - L5 Dynamic Moment into Disc, Ligamentous, and Muscular Components During Lifting , 1986, Spine.

[35]  N. Bogduk,et al.  1987 Volvo Award in Basic Science: The Morphology of the Lumbar Erector Spinae , 1987, Spine.

[36]  M. Adams,et al.  Bending and compressive stresses acting on the lumbar spine during lifting activities. , 1994, Journal of biomechanics.

[37]  A. Schultz,et al.  The Activity of Individual Trunk Muscles During Heavy Physical Loading , 1987, Spine.

[38]  B. C. Abbott,et al.  The relation between velocity of shortening and the tension‐length curve of skeletal muscle , 1953, The Journal of physiology.

[39]  M. Adams,et al.  A technique for quantifying the bending moment acting on the lumbar spine in vivo. , 1991, Journal of biomechanics.

[40]  M. Johnson,et al.  Data on the distribution of fibre types in thirty-six human muscles. An autopsy study. , 1973, Journal of the neurological sciences.

[41]  A. Schultz,et al.  Analysis and Quantitative Myoelectric Measurements of Loads on the Lumbar Spine when Holding Weights in Standing Postures , 1982, Spine.

[42]  A Schultz,et al.  Use of lumbar trunk muscles in isometric performance of mechanically complex standing tasks , 1983, Journal of orthopaedic research : official publication of the Orthopaedic Research Society.

[43]  A. Hill.  The heat of shortening and the dynamic constants of muscle , 1938 .