A high efficiency single-phase multilevel packed U cell inverter for photovoltaic applications

PV systems have the drawbacks of high initial cost. The power electronics portions represents about 50% of this cost for no-battery systems. Therefore, it is important to act to decrease this cost through designing a power conditioning circuit with lower cost. This paper proposes implementation of economic and efficient multilevel inverter for PV applications. Packed U Cell (PUC) multilevel inverter is employed as a competitive converter with minimum components compared to the existing ones. Boost DC-DC converter is designed to extract the maximum power point using P&O algorithm. Only six switches and single DC source (PV) are used to deliver a better power quality output in terms of number of voltage levels, low THD, small output filter. Simulink and experimental prototype are built to investigate the effectiveness of this topology. Results show a good matching.

[1]  Haibing Hu,et al.  A Review of Power Decoupling Techniques for Microinverters With Three Different Decoupling Capacitor Locations in PV Systems , 2013, IEEE Transactions on Power Electronics.

[2]  Alex Van den Bossche,et al.  Developed cascaded multilevel inverter topology to minimise the number of circuit devices and voltage stresses of switches , 2014 .

[3]  Robert W. Erickson,et al.  Fundamentals of Power Electronics , 2001 .

[4]  Kamal Al-Haddad,et al.  Packed U Cells Multilevel Converter Topology: Theoretical Study and Experimental Validation , 2011, IEEE Transactions on Industrial Electronics.

[5]  D. K. Sharma,et al.  Advanced perturbation and observation (P&O) based maximum power point tracking (MPPT) of a solar photo-voltaic system , 2012, 2012 IEEE 5th India International Conference on Power Electronics (IICPE).

[6]  P.L. Chapman,et al.  Comparison of Photovoltaic Array Maximum Power Point Tracking Techniques , 2007, IEEE Transactions on Energy Conversion.

[7]  Mohammad A. S. Masoum,et al.  Closure on "Theoretical and experimental analyses of photovoltaic systems with voltage and current-based maximum power point tracking" , 2002 .

[8]  Mohamed Orabi,et al.  A High Efficiency Single-stage Current Source Inverter for Photovoltaic Applications , 2013 .

[9]  Antonios G. Kladas,et al.  Implementation of photovoltaic array MPPT through fixed step predictive control technique , 2011 .

[10]  Mohamed Orabi,et al.  Single-cell photovoltaic with integrated converter , 2011, 2011 IEEE 33rd International Telecommunications Energy Conference (INTELEC).

[11]  M. Masoum,et al.  Theoretical and Experimental Analyses of Photovoltaic Systems with Voltage and Current-Based Maximum Power Point Tracking , 2002, IEEE Power Engineering Review.