94 GHz Dual-Reflector Antenna With Reflectarray Subreflector

The design, construction and measured performance is described of an offset parabolic reflector antenna which employs a reflectarray subreflector to tilt the focused beam from the boresight direction at 94 GHz. An analysis technique based on the method of moments (MoM) is used to design the dual-reflector antenna. Numerical simulations were employed to demonstrate that the high gain pattern of the antenna can be tilted to a predetermined angle by introducing a progressive phase shift across the aperture of the reflectarray. Experimental validation of the approach was made by constructing a 28 times 28 element patch reflectarray which was designed to deflect the beam 5deg from the boresight direction in the azimuth plane. The array was printed on a 115 mum thick metal backed quartz wafer and the radiation patterns of the dual reflector antenna were measured from 92.6-95.5 GHz. The experimental results are used to validate the analysis technique by comparing the radiation patterns and the reduction in the peak gain due to beam deflection from the boresight direction. Moreover the results demonstrate that this design concept can be developed further to create an electronically scanned dual reflector antenna by using a tunable reflectarray subreflector.

[1]  Changhua Wan,et al.  Efficient computation of generalized scattering matrix for analyzing multilayered periodic structures , 1995 .

[2]  R. J. Martin,et al.  Quasi-optical antennas for radiometric remote-sensing , 1996 .

[3]  Edward A. Parker,et al.  Influence of substrate loss tangent on performance of multilayer submillimetre-wave FSS , 1995 .

[4]  Ugo Cortesi,et al.  MARSCHALS: development of an airborne millimeter-wave limb sounder , 2001, Remote Sensing.

[5]  C. Rodgers,et al.  Retrieval of atmospheric temperature and composition from remote measurements of thermal radiation , 1976 .

[6]  J. Tuovinen,et al.  The Odin satellite - I. Radiometer design and test , 2003 .

[7]  David M. Pozar,et al.  Wideband reflectarrays using artificial impedance surfaces , 2007 .

[8]  J. Encinar Design of two-layer printed reflectarrays using patches of variable size , 2001 .

[9]  Vincent Fusco,et al.  Liquid-crystal-based reflectarray antenna with electronically switchable monopulse patterns , 2007 .

[10]  Rolf Jakoby,et al.  Electronically reconfigurable reflectarrays with nematic liquid crystals , 2006 .

[11]  R. Cahill,et al.  Tunable liquid crystal reflectarray patch element , 2006 .

[12]  R. Cahill,et al.  Design and Measurement of Reconfigurable Millimeter Wave Reflectarray Cells With Nematic Liquid Crystal , 2008, IEEE Transactions on Antennas and Propagation.

[13]  M. Arrebola,et al.  Analysis of dual-reflector antennas with a reflectarray as subreflector , 2008, IEEE Antennas and Propagation Magazine.

[14]  R. Jakoby,et al.  Cavity perturbation method for characterization of liquid crystals up to 35 GHz , 2004, 34th European Microwave Conference, 2004..

[15]  Roger W. Saunders,et al.  Measurements of the AMSU-B antenna pattern , 1996, IEEE Trans. Geosci. Remote. Sens..

[16]  J. Encinar,et al.  Multifed Printed Reflectarray With Three Simultaneous Shaped Beams for LMDS Central Station Antenna , 2008, IEEE Transactions on Antennas and Propagation.

[17]  F. Las-Heras,et al.  Reconstruction of Equivalent Currents Distribution Over Arbitrary Three-Dimensional Surfaces Based on Integral Equation Algorithms , 2007, IEEE Transactions on Antennas and Propagation.

[18]  R. Jakoby,et al.  77 GHz Reconfigurable Reflectarray with Nematic Liquid Crystal , 2007 .

[19]  T. A. Metzler,et al.  Analysis of a reflectarray antenna using microstrip patches of variable size , 1993 .

[20]  Vincent Fusco,et al.  Phase agile reflectarray cells based on liquid crystals , 2007 .

[21]  Fernando Las-Heras,et al.  Accurate analysis of printed reflectarrays considering the near field of the primary feed , 2009 .