Fast prediction of non-uniform temperature distribution: A concise expression and reliability analysis

Abstract Fast prediction of indoor temperature distribution is valuable to recognize the status and assist in rapid decision making and heat source control. Prediction using a superposition theorem based on the assumption of fixed flow field is an alternative method of performing fast prediction. However, little research revealed the methods’ reliability based on fixed flow field, and previous prediction methods primarily focused on the temperature at a steady state. In this paper, an algebraic expression was established to predict the temperature distribution based on the definition of transient accessibility indices for temperature. The prediction accuracy was mainly verified using a numerical method with 14 cases. It was concluded: (1) the proposed expression can perform fast prediction once the transient accessibility indices are prepared in advance; (2) the fixed flow field adopted in the proposed method should be built by a thermal scenario considering the heat source at a certain intensity, rather than a scenario with no heat source. The accuracy is acceptable for positions outside the heat source area; (3) there is no significant effect of the choice of supply air temperature utilized in building the fixed flow field on prediction accuracy. The research on prediction accuracy is helpful for a reasonable application of the proposed method in real projects.

[1]  A. Melikov,et al.  Personalized ventilation: evaluation of different air terminal devices , 2002 .

[2]  James W. Axley,et al.  Multizone Airflow Modeling in Buildings: History and Theory , 2007 .

[3]  S. Kato,et al.  Control of indoor thermal environment based on concept of contribution ratio of indoor climate , 2010 .

[4]  Goodarz Ahmadi,et al.  Building removal of particulate pollutant plume during outdoor resuspension event , 2014 .

[5]  Cheuk Ming Mak,et al.  A study of interunit dispersion around multistory buildings with single-sided ventilation under different wind directions , 2014 .

[6]  Mats Sandberg,et al.  Investigation of air quality, comfort parameters and effectiveness for two floor-level air supply systems in classrooms , 2007 .

[7]  Yong Wang,et al.  Design configuration for a higher efficiency air conditioning system in large space building , 2014 .

[8]  Paolo Maria Congedo,et al.  CFD modeling and moisture dynamics implications of ventilation scenarios in historical buildings , 2014 .

[9]  Xiaoliang Shao,et al.  An analytical expression for transient distribution of passive contaminant under steady flow field , 2012 .

[10]  P V Nielsen,et al.  Computational fluid dynamics and room air movement. , 2004, Indoor air.

[11]  F. Haghighat,et al.  Zonal Modeling for Simulating Indoor Environment of Buildings: Review, Recent Developments, and Applications , 2007 .

[12]  Wangda Zuo,et al.  Simulations of Air Distributions in Buildings by FFD on GPU , 2010 .

[13]  Liangzhu Wang,et al.  Evaluation of some assumptions used in multizone airflow network models , 2008 .

[14]  C. Méndez,et al.  CFD Analysis of the Human Exhalation Flow using Different Boundary Conditions and Ventilation Strategies , 2013 .

[15]  Jiyuan Tu,et al.  CFD study of the effects of furniture layout on indoor air quality under typical office ventilation schemes , 2014 .

[16]  S. Patankar.  Numerical Heat Transfer and Fluid Flow , 2018, Lecture Notes in Mechanical Engineering.

[17]  Quanyi Huang,et al.  Numerical and experimental investigation on the dynamic airflow of human movement in a full-scale cabin , 2014 .

[18]  van Taj Twan Hooff,et al.  On the suitability of steady RANS CFD for forced mixing ventilation at transitional slot Reynolds numbers. , 2013, Indoor air.

[19]  Hee-Jin Park,et al.  The effect of location of a convective heat source on displacement ventilation: CFD study , 2001 .

[20]  Subhransu Roy,et al.  Numerical simulation of two-dimensional room air flow with and without buoyancy , 2000 .

[21]  Q Chen,et al.  Real-time or faster-than-real-time simulation of airflow in buildings. , 2009, Indoor air.

[22]  Per Heiselberg,et al.  Room Air and Contaminant Distribution in Mixing Ventilation , 1996 .

[23]  Xiaoliang Shao,et al.  An algorithm for fast prediction of the transient effect of an arbitrary initial condition of contaminant , 2015 .

[24]  C. K. Lee,et al.  Computer modeling of displacement ventilation systems based on plume rise in stratified environment , 2007 .

[25]  Xianting Li,et al.  Evolution of contaminant distribution at steady airflow field with an arbitrary initial condition in ventilated space , 2008 .

[26]  Hazim B. Awbi,et al.  A study of the air quality in the breathing zone in a room with displacement ventilation , 2001 .

[27]  Qingyan Chen,et al.  A zero-equation turbulence model for indoor airflow simulation , 1998 .

[28]  K. F. Fong,et al.  CFD study on effect of the air supply location on the performance of the displacement ventilation system , 2005 .

[29]  Zhang Lin,et al.  Numerical Investigation of Indoor Aerosol Particle Dispersion under Stratum Ventilation and under Displacement Ventilation , 2009 .

[30]  Cheuk Ming Mak,et al.  Pollutant dispersion in a natural ventilated dental clinic , 2013 .

[31]  P. J. Jones,et al.  Computational fluid dynamics for building air flow prediction—current status and capabilities , 1992 .

[32]  Xianting Li,et al.  Accessibility: A New Concept to Evaluate Ventilation Performance in a Finite Period of Time , 2004 .

[33]  Elisabeth Mundt,et al.  Non-buoyant pollutant sources and particles in displacement ventilation , 2001 .

[34]  S. Kato.  New Scales for Evaluating Ventilation Efficiency as Affected by Supply and Exhaust Opening Based on Spatial Distribution of Contaminant , 1992 .