In this paper, pressure and shear stress are derived under steady state using one-dimensional analysis of the single-grooved slider bearing and journal bearing with partial slip on the stationary surface. The Reynolds boundary conditions are used in the analysis of journal bearing to predict the extent of the full film region. In the cases of partial slip slider and journal bearing, the pressure distribution is higher compared with the conventional bearing with no slip. In the case of partial slip on both slider and journal bearing surfaces, the single-groove, immediately followed by the partial slip region, results in the increase in pressure distribution. The results also show that in comparison to the conventional bearing with no slip, in the cases of parrial slip slider and journal bearing, the shear stress increases before the region of slip/no slip interface, while the shear stress decreases in the region of no slip. In the case of the partial slip region on bearing surfaces, the shear stress distribution is lower in the region immediately after the groove. Significant pressure distribution is obtained due to the influence of partial slip on the slider bearing with uniform film thickness and the concentric journal bearing. The maximum pressure occurs at the end of the region of groove, immediately followed by the region of the partial slip. It is found that the pressure distribution of the slider and journal bearing with partial slip surface are not influenced with the further increase in the nondimensional slip coefficient (A) from 10 to 100.
[1]
H. Spikes.
The half-wetted bearing. Part 1: Extended Reynolds equation
,
2003
.
[2]
Hiroshi Udagawa,et al.
Drag reduction of Newtonian fluid in a circular pipe with a highly water-repellent wall
,
1999,
Journal of Fluid Mechanics.
[3]
S. Granick,et al.
Rate-dependent slip of Newtonian liquid at smooth surfaces.
,
2001,
Physical review letters.
[4]
H. Spikes.
The half-wetted bearing. Part 2: Potential application in low load contacts
,
2003
.
[5]
Shizhu Wen,et al.
Study on Thin Film Lubrication With Second-Order Fluid
,
2002
.
[6]
Richard F. Salant,et al.
Numerical Analysis of a Slider Bearing with a Heterogeneous Slip/No-Slip Surface
,
2004
.
[7]
A. Gosman,et al.
Entrainment and Inlet Suction: Two Mechanisms of Hydrodynamic Lubrication in Textured Bearings
,
2007
.
[8]
S. Granick,et al.
Limits of the hydrodynamic no-slip boundary condition.
,
2002,
Physical review letters.
[9]
Richard F. Salant,et al.
Numerical Analysis of a Journal Bearing With a Heterogeneous Slip/No-Slip Surface
,
2005
.
[10]
Chengwei Wu,et al.
Low Friction and High Load Support Capacity of Slider Bearing With a Mixed Slip Surface
,
2006
.
[11]
D. Williams,et al.
Shear-dependent boundary slip in an aqueous Newtonian liquid.
,
2001,
Physical review letters.