A unified thermodynamic mechanism underlying fouling behaviors of soluble microbial products (SMPs) in a membrane bioreactor.

Soluble microbial products (SMPs) are the predominate foulants determining fouling extent in membrane bioreactors (MBRs). However, exact mechanism underlying their typical fouling behaviors remains unrevealed. In this study, the typical fouling behaviors of SMPs during initial operational period of a MBR were characterized. It was found that, although being low content, SMPs rather than sludge particulates preferentially adhered to membrane surface to accumulate a gel layer, and moreover, specific filtration resistance (SFR) of SMPs was approximately 700 times larger than that of the sludge particulates at operational day 3. According to energy balance principle, a unified thermodynamic mechanism underlying these fouling behaviors of SMPs was proposed. Thermodynamic analyses demonstrated that, the attractive interaction energy strength in contact between SMPs and membrane was larger by around 3700 times than that between sludge particulates and membrane, well explaining the extremely high adhesive ability of SMPs over sludge particlulates. Meanwhile, filtration through a SMPs layer was modelled and simulated as a thermodynamic process. Simulation on an agar gel showed that, about 92.6% of SFR was originated from mixing free energy change during filtration. Such a result satisfactorily interpreted the extremely high SFR of SMPs layer over sludge cake layer. The revealed thermodynamic mechanism underlying SMPs fouling behaviors significantly deepened understanding of fouling, and facilitated to development of effective fouling control strategies.

[1]  T. Waite,et al.  Role of gelling soluble and colloidal microbial products in membrane fouling. , 2009, Environmental science & technology.

[2]  Haiying Yu,et al.  A new insight into membrane fouling mechanism in submerged membrane bioreactor: osmotic pressure during cake layer filtration. , 2013, Water research.

[3]  Hongjun Lin,et al.  Factors affecting sludge cake formation in a submerged anaerobic membrane bioreactor , 2010 .

[4]  T. Waite,et al.  Impact of gel layer formation on colloid retention in membrane filtration processes , 2008 .

[5]  S. Bhattacharjee,et al.  DLVO interaction between rough surfaces , 1998 .

[6]  Hongjun Lin,et al.  Simulation of foulant bioparticle topography based on Gaussian process and its implications for interface behavior research , 2018 .

[7]  Hongjun Lin,et al.  A facile method for simulating randomly rough membrane surface associated with interface behaviors , 2018 .

[8]  S. Benjakul,et al.  Physico-chemical and gel properties of agar from Gracilaria tenuistipitata from the lake of Songkhla, Thailand , 2015 .

[9]  Jianrong Chen,et al.  Pollutant removal and membrane fouling in an anaerobic submerged membrane bioreactor for real sewage treatment. , 2014, Water science and technology : a journal of the International Association on Water Pollution Research.

[10]  Jianrong Chen,et al.  Realization of quantifying interfacial interactions between a randomly rough membrane surface and a foulant particle. , 2017, Bioresource technology.

[11]  David C. Stuckey,et al.  A REVIEW OF SOLUBLE MICROBIAL PRODUCTS (SMP) IN WASTEWATER TREATMENT SYSTEMS , 1999 .

[12]  Yiming He,et al.  Membrane fouling in a membrane bioreactor: High filtration resistance of gel layer and its underlying mechanism. , 2016, Water research.

[13]  Jianrong Chen,et al.  Fouling mechanisms of gel layer in a submerged membrane bioreactor. , 2014, Bioresource technology.

[14]  J. Wanner,et al.  The role and significance of extracellular polymers in activated sludge. Part I: Literature review , 2006 .

[15]  Haiying Yu,et al.  Membrane fouling in a submerged membrane bioreactor with focus on surface properties and interactions of cake sludge and bulk sludge. , 2014, Bioresource technology.

[16]  Hang-Sik Shin,et al.  Fouling in membrane bioreactors: An updated review. , 2017, Water research.

[17]  Wei Chen,et al.  Interaction mechanisms and predictions on membrane fouling in an ultrafiltration system, using the XDLVO approach , 2014 .

[18]  Menachem Elimelech,et al.  Fouling of reverse osmosis membranes by hydrophilic organic matter: implications for water reuse , 2006 .

[19]  Yu Tian,et al.  Interaction energy evaluation of soluble microbial products (SMP) on different membrane surfaces: role of the reconstructed membrane topology. , 2012, Water research.

[20]  Hongjun Lin,et al.  Quantification of interfacial interactions between a rough sludge floc and membrane surface in a membrane bioreactor. , 2017, Journal of colloid and interface science.

[21]  K. Dušek,et al.  Swelling of model networks , 1987 .

[22]  Zhiwei Wang,et al.  Assessment of SMP fouling by foulant–membrane interaction energy analysis , 2013 .

[23]  Yi Ding,et al.  Identification of the change in fouling potential of soluble microbial products (SMP) in membrane bioreactor coupled with worm reactor. , 2013, Water research.

[24]  Guangcai Ma,et al.  Mechanistic insights into alginate fouling caused by calcium ions based on terahertz time-domain spectra analyses and DFT calculations. , 2018, Water research.

[25]  Hongjun Lin,et al.  Membrane fouling in a submerged membrane bioreactor: New method and its applications in interfacial interaction quantification. , 2017, Bioresource technology.

[26]  Hongjun Lin,et al.  Effect of calcium ions on fouling properties of alginate solution and its mechanisms , 2017 .

[27]  E. Hoek,et al.  Extended DLVO interactions between spherical particles and rough surfaces. , 2006, Journal of colloid and interface science.

[28]  Amy E. Childress,et al.  Colloidal adhesion to hydrophilic membrane surfaces , 2004 .

[29]  L. Vera,et al.  Effect of sludge characteristics on membrane fouling during start-up of a tertiary submerged membrane bioreactor , 2016, Environmental Science and Pollution Research.

[30]  H. Nagaoka,et al.  Influence of bacterial extracellular polymers on the membrane separation activated sludge process , 1996 .

[31]  Hongjun Lin,et al.  A novel insight into membrane fouling mechanism regarding gel layer filtration: Flory-Huggins based filtration mechanism , 2016, Scientific Reports.

[32]  Simon Judd,et al.  The status of industrial and municipal effluent treatment with membrane bioreactor technology , 2016 .

[33]  Chuyang Y. Tang,et al.  Membrane cleaning in membrane bioreactors: A review , 2014 .

[34]  Amy E. Childress,et al.  Assessing short-range membrane–colloid interactions using surface energetics , 2002 .

[35]  A. Grasmick,et al.  Influence of macromolecule adsorption during filtration of a membrane bioreactor mixed liquor suspension , 2002 .

[36]  Marco Ferraris,et al.  Start-up of a pilot-scale membrane bioreactor to treat municipal wastewater , 2009 .

[37]  H. Zappe,et al.  Flory-Huggins swelling of polymer Bragg mirrors , 2006 .

[38]  F. Meng,et al.  Effect of sludge properties on the filtration characteristics of self-forming dynamic membranes (SFDMs) in aerobic bioreactors: Formation time, filtration resistance, and fouling propensity , 2013 .

[39]  Lei Jiang,et al.  How does the leaf margin make the lotus surface dry as the lotus leaf floats on water , 2008 .

[40]  Seeram Ramakrishna,et al.  A review on self-cleaning coatings , 2011 .

[41]  Hongjun Lin,et al.  Impacts of morphology on fouling propensity in a membrane bioreactor based on thermodynamic analyses. , 2018, Journal of colloid and interface science.

[42]  W. Borchard,et al.  Theory of swelling of a crosslinked substance in equilibrium with a solvent in various phases , 1991 .

[43]  Jianrong Chen,et al.  Effects of hydrophilicity/hydrophobicity of membrane on membrane fouling in a submerged membrane bioreactor. , 2015, Bioresource technology.

[44]  Berrin Tansel,et al.  Deposition of extracellular polymeric substances (EPS) and microtopographical changes on membrane surfaces during intermittent filtration conditions , 2006 .

[45]  Zhiwei Wang,et al.  Membrane fouling in a submerged membrane bioreactor (MBR) under sub-critical flux operation : Membrane foulant and gel layer characterization , 2008 .

[46]  H. Cölfen.  Analytical Ultracentrifuge Technologies for the Characterization of Biopolymer Gels and Microgels , 1999 .

[47]  Hongjun Lin,et al.  Novel insights into membrane fouling in a membrane bioreactor: Elucidating interfacial interactions with real membrane surface. , 2018, Chemosphere.

[48]  Hongjun Lin,et al.  Mechanism analyses of high specific filtration resistance of gel and roles of gel elasticity related with membrane fouling in a membrane bioreactor. , 2018, Bioresource technology.

[49]  W. Pronk,et al.  Three-dimensional excitation and emission matrix fluorescence (3DEEM) for quick and pseudo-quantitative determination of protein- and humic-like substances in full-scale membrane bioreactor (MBR). , 2017, Water research.

[50]  Hongjun Lin,et al.  Membrane fouling in a membrane bioreactor: A novel method for membrane surface morphology construction and its application in interaction energy assessment , 2016 .

[51]  R. Bai,et al.  Microfiltration of activated sludge wastewater—the effect of system operation parameters , 2002 .

[52]  Yiliang He,et al.  Changes in degrading ability, populations and metabolism of microbes in activated sludge in the treatment of phenol wastewater , 2017 .

[53]  C. J. van Oss,et al.  Acid—base interfacial interactions in aqueous media , 1993 .

[54]  Jianrong Chen,et al.  A novel integrated method for quantification of interfacial interactions between two rough bioparticles. , 2018, Journal of colloid and interface science.

[55]  S. Tan,et al.  Characterization of soluble microbial products (SMPs) in a membrane bioreactor (MBR) treating synthetic wastewater containing pharmaceutical compounds. , 2016, Water research.

[56]  Daniel B. Oerther,et al.  Effect of activated sludge properties and membrane operation conditions on fouling characteristics in membrane bioreactors. , 2006, Chemosphere.

[57]  Haiying Yu,et al.  Thermodynamic analysis of membrane fouling in a submerged membrane bioreactor and its implications. , 2013, Bioresource technology.

[58]  Gary Amy,et al.  Role of soluble microbial products (SMP) in membrane fouling and flux decline. , 2006, Environmental science & technology.

[59]  T. Waite,et al.  Gel layer formation and hollow fiber membrane filterability of polysaccharide dispersions , 2008 .

[60]  Simos Malamis,et al.  Membrane bioreactors – A review on recent developments in energy reduction, fouling control, novel configurations, LCA and market prospects , 2017 .

[61]  Jianrong Chen,et al.  A critical review of extracellular polymeric substances (EPSs) in membrane bioreactors: Characteristics, roles in membrane fouling and control strategies , 2014 .

[62]  Fangang Meng,et al.  Membrane Bioreactors for Industrial Wastewater Treatment: A Critical Review , 2012 .

[63]  Hang-Sik Shin,et al.  Sludge characteristics and their contribution to microfiltration in submerged membrane bioreactors , 2003 .

[64]  P. Flory.  Thermodynamics of High Polymer Solutions , 1941 .

[65]  Giorgio Mannina,et al.  Comparing two start-up strategies for MBRs: Experimental study and mathematical modelling , 2012 .

[66]  A. Drews,et al.  Recent advances in membrane bioreactors (MBRs): membrane fouling and membrane material. , 2009, Water research.