Arching in hoppers: I. Arching theories and bulk material flow properties

In this paper, the first in a series of two, the theories of arching in symmetrical hoppers are discussed in terms of the underlying assumptions related to flow properties of bulk materials. In particular, the link between the form of the instantaneous and effective yield conditions, and the form of the flow function is investigated in detail, and the resulting implications in the arching theories are critically assessed. It is demonstrated that approximations involved in flow properties determination may contradict the assumptions in the arching theory used. The analysis is supplemented with results of direct shear tests on limestone, gypsum, coal, cement, and taconite, which are subsequently used to illustrate the required approximations. Also, some modifications to the existing arching theories are discussed. In a companion paper, the results of this paper are used to predict the value of outlet size critical for arching, which is next compared with results of mid-scale model tests on plane (wedge-type) and conical hoppers.

[1]  P. T. Stainforth,et al.  Computer analysis of powder flow characteristics , 1971 .

[2]  A. Schofield,et al.  Critical State Soil Mechanics , 1968 .

[3]  D. M. Walker An approximate theory for pressures and arching in hoppers , 1966 .

[4]  J. Rooda A numerical method for the calculation of the powder flow properties obtained with the Jenike flow factor tester , 1975 .

[5]  J. Schwedes,et al.  Measurement of flow properites of bulk solids , 1990 .

[6]  D. Cheng,et al.  Some investigations into the strength and flow properties of powders , 1965 .

[7]  A. H. Birks,et al.  The direct measurement of the failure function of a cohesive powder , 1971 .

[8]  O. Molerus,et al.  Effect of interparticle cohesive forces on the flow behaviour of powders , 1978 .

[9]  H. B. Manbeck,et al.  Flow properties of powders using four testers — measurement, comparison and assessment , 1993 .

[10]  A. Roberts,et al.  The interpretation of ring shear cell results , 1974 .

[12]  Andrew Drescher,et al.  Arching in hoppers: II. Arching theories and critical outlet size , 1995 .

[13]  H. Tsunakawa,et al.  Measurements of the failure properties of granular materials and cohesive powders , 1982 .

[14]  P. C. Arnold,et al.  Improved analytical flowfactors for mass-flow hoppers , 1976 .

[15]  P. T. Stainforth,et al.  An analytical hopper design method for cohesive powders , 1973 .

[16]  J. Schwedes Shearing behaviour of slightly compressed cohesive granular materials , 1975 .

[17]  G. Enstad,et al.  ON THE THEORY OF ARCHING IN MASS FLOW HOPPERS , 1975 .

[18]  H. S. Fogler,et al.  A note on capillary model of developments for sandstone acidization , 1977 .

[19]  Andrew Drescher,et al.  Analytical methods in bin-load analysis , 1991 .

[20]  D. M. Walker,et al.  A basis for bunker design , 1967 .

[21]  P. C. Arnold,et al.  An analytical solution for the stress function at the wall of a converging channel , 1976 .

[22]  A. H. Birks,et al.  The preparation of powder specimens for shear cell testing , 1965 .