Static cyclic in-plane shear response of damaged masonry walls retrofitted with NSM FRP strips – An experimental evaluation

Abstract An experimental study was conducted to assess the effect on strength and ductility of retrofitting unreinforced masonry (URM) shear panels with near surface mounted (NSM) carbon fibre reinforced polymer (CFRP) strips. A total of sixteen wall panels, 1200 mm × 1200 mm, were subjected to vertical pre-compression combined with increasing reversing cycles of in-plane lateral displacement. All wall panels were previously tested (prior to retrofitting) under compression and cyclic shear using three different pre-compression levels resulting in various levels of damage. The damaged walls were repaired, retrofitted with NSM FRP strips and retested under pre-compression stress levels of 2.8 MPa, 2 MPa and 1.4 MPa. The retrofitted walls displayed higher displacement capacities compared with URM walls highlighting the effectiveness of retrofitting URM walls under earthquake loading. The ultimate loads were not enhanced due to retrofitting under higher pre-compression levels. However the presence of the reinforcement did restore the ultimate loads to those observed for the original undamaged URM state. This meant that overall, the reinforcement was effective in increasing the energy dissipation capacity of the walls compared to URM. The improvements in the behaviour of the URM walls due to retrofitting were generally similar, irrespective of the amount of damage the URM walls experienced prior to retrofitting. The paper discusses the effect on strength, displacement capacity, energy dissipation and ductility achieved by FRP retrofitting of the damaged (lightly and highly) URM panels compared to the undamaged URM panels under different pre-compression levels. The broader aim of the research is to identify techniques for improving the seismic performance of existing URM walls under in-plane shear loading.

[1]  Pierino Lestuzzi,et al.  In-Plane Seismic Response of URM Walls Upgraded with FRP , 2005 .

[2]  Antonio Nanni,et al.  Analysis of unreinforced masonry concrete walls strengthened with glass fiber-reinforced polymer bars , 2005 .

[3]  Mark J. Masia,et al.  Bond behaviour of NSM FRP strips to modern clay brick masonry prisms under cyclic loading , 2009 .

[4]  T. Stratford,et al.  Shear Strengthening Masonry Panels with Sheet Glass-Fiber Reinforced Polymer , 2004 .

[5]  L. Lorenzis,et al.  Near-surface mounted FRP reinforcement: An emerging technique for strengthening structures , 2007 .

[6]  Pedro F. Silva,et al.  In-Plane Performance Assessment of URM Walls Retrofitted with FRP , 2006 .

[7]  Robert G. Drysdale,et al.  Enhancing Seismic Flexural Resistance of Historic Masonry Walls using Carbon Fiber Rope , 2004 .

[8]  R. Petersen,et al.  In-plane shear behaviour of unreinforced masonry panels strengthened with fibre reinforced polymer strips , 2009 .

[9]  Pablo Alcaino,et al.  EXPERIMENTAL RESPONSE OF MASONRY WALLS EXTERNALLY REINFORCED WITH CARBON FIBER FABRICS , 2006 .

[10]  M. Badoux,et al.  Shear strength of URM walls retrofitted using FRP , 2006 .

[11]  Mark J. Masia,et al.  In-Plane Shear Behavior of Masonry Panels Strengthened with NSM CFRP Strips. I: Experimental Investigation , 2010 .

[12]  A. Prota,et al.  In-plane shear performance of masonry panels strengthened with FRP , 2007 .

[13]  P. Lestuzzi,et al.  STATIC CYCLIC RESPONSE OF MASONRY WALLS RETROFITTED WITH FIBER-REINFORCED POLYMERS , 2007 .

[14]  P. Alcaíno,et al.  Repair of in-plane shear damaged masonry walls with external frp , 2011 .

[15]  Pedro F. Silva,et al.  Strengthening of Masonry Walls by FRP Structural Repointing , 2001 .

[16]  P. Alcaíno,et al.  Experimental Response of Externally Retrofitted Masonry Walls Subjected to Shear Loading , 2008 .

[17]  R. Capozucca,et al.  Experimental analysis of historic masonry walls reinforced by CFRP under in-plane cyclic loading , 2011 .

[18]  Antonio Nanni,et al.  FRP Strengthening of URM Walls with Openings - Experimental Results , 2005 .

[19]  Nebojša Mojsilović,et al.  Static-cyclic shear tests on masonry wallettes with a damp-proof course membrane , 2009 .

[20]  T. Almusallam,et al.  Behavior of FRP Strengthened Infill Walls under In-Plane Seismic Loading , 2007 .

[21]  Robert Park,et al.  Evaluation of ductility of structures and structural assemblages from laboratory testing , 1989 .

[22]  Jason Ingham,et al.  Diagonal Compression Testing of FRP-Retrofitted Unreinforced Clay Brick Masonry Wallettes , 2011 .

[23]  Nebojša Mojsilović,et al.  Masonry wallettes with damp-proof course membrane subjected to cyclic shear: An experimental study , 2010 .

[24]  Medhat A. Haroun,et al.  Seismic performance testing of masonry-infilled frames retrofitted by fiber composite , 1997 .

[25]  Maria Rosa Valluzzi,et al.  Flexural and shear strengthening of un-reinforced masonry with FRP bars , 2006 .

[26]  Pierino Lestuzzi,et al.  A REVIEW OF CONVENTIONAL SEISMIC RETROFITTING TECHNIQUES FOR URM , 2004 .