This paper is concerned about the basic properties of deployment of shape memory polymer composite (SMPC) and its application to deployable hinge for solar arrays. Shape memory polymer (SMP) used in this study is a thermoset styrene-based shape memory resin in contrast to normal thermoplastic SMPs. Carbon fiber fabric reinforced SMPC is discussed here. In order to investigate the basic performances of deployment for SMPC hinge, the experimental methods are used as follows: dynamic mechanical analysis (DMA), three point bending test and deployment tests. Results indicate that the glass transition temperature (Tg) of SMPC is approximate 63°C. SMPC shows typical linear elasticity and high bending modulus before glass transition in SMP, while exhibits apparent nonlinear viscoelasticity and low bending modulus within the range of glass transition in SMP. The shape recovery ratio of SMPC is above 90% at/above Tg, while drops sharply at below Tg. The deployment properties of SMPC depend strongly on the number of thermomechanical cycles, which become relatively stable after some packaging/deployment cycles. Moreover, deployment velocity and shape recovery ratio rise remarkably with the increase of temperature of SMPC. In the end, a prototype of solar array actuated by SMPC hinge, which is heated by passing an electrical current, deploys from about 180° to 0° in one minute. This SMPC hinge performs good deployment performances during numerous thermomechanical cycles.
[1]
Qing-Qing Ni,et al.
Creep and Cyclic Mechanical Properties of Composites Based on Shape Memory Polymer
,
2004
.
[2]
M. Lake,et al.
Shape memory polymer nanocomposites
,
2002
.
[3]
Martin M. Mikulas,et al.
Carbon Fiber Reinforced Shape Memory Polymer Composites
,
2000
.
[4]
Holger Hanselka.
Industrial and Commercial Applications of Smart Structures Technologies IV
,
2009
.
[5]
Xin Lan,et al.
Influence of cross-linking degree on shape memory effect of styrene copolymer
,
2007,
SPIE Smart Structures and Materials + Nondestructive Evaluation and Health Monitoring.
[6]
Ken Gall,et al.
Developments in elastic memory composite materials for spacecraft deployable structures
,
2001,
2001 IEEE Aerospace Conference Proceedings (Cat. No.01TH8542).
[7]
Ken Gall,et al.
Shape Memory Polymers for Elastic Memory Composites
,
2002
.
[8]
A. Lendlein,et al.
Shape-memory polymers
,
2002
.
[9]
Xin Lan,et al.
Investigation of mechanical and conductive properties of shape memory polymer composite (SMPC)
,
2007,
SPIE Smart Structures and Materials + Nondestructive Evaluation and Health Monitoring.
[10]
Xin Lan,et al.
MECHANICAL AND ELECTRICAL PROPERTIES OF SHAPE MEMORY POLYMER MATRIX AND CARBON NANOCOMPOSITE
,
2022
.