Online Vce measurement method for wear-out monitoring of high power IGBT modules

A simple Vce online monitoring circuit is presented in this paper. It allows an accurate wear out prediction of IGBT modules, in high-power applications, during normal converter operation. Bipolar measurement allows monitoring of both IGBT and antiparallel diode. The circuit uses two serial connected diodes to sense the Vce voltage with millivolt accuracy. One diode acts as a protection to block high DC voltage present on input terminals. When the device is conducting the voltage on the second diode is measured to compensate for the voltage drop on the protection diode thus eliminating voltage offset due to diodes' forward voltage temperature dependency. Using four diodes one can monitor voltages on all power devices in a converter leg.

[1]  Dawei Xiang,et al.  An Industry-Based Survey of Reliability in Power Electronic Converters , 2011, IEEE Transactions on Industry Applications.

[2]  T. Plum,et al.  On-line Junction Temperature Measurement of CoolMOS Devices , 2007, 2007 7th International Conference on Power Electronics and Drive Systems.

[3]  Mounira Berkani,et al.  Ageing and Failure Modes of IGBT Modules in High-Temperature Power Cycling , 2011, IEEE Transactions on Industrial Electronics.

[4]  Stig Munk-Nielsen,et al.  Lifetime investigation of high power IGBT modules , 2011, Proceedings of the 2011 14th European Conference on Power Electronics and Applications.

[5]  Stig Munk-Nielsen,et al.  Innovative measuring system for wear-out indication of high power IGBT modules , 2011, 2011 IEEE Energy Conversion Congress and Exposition.

[6]  Seung-Ki Sul,et al.  On-line estimation of IGBT junction temperature using on-state voltage drop , 1998, Conference Record of 1998 IEEE Industry Applications Conference. Thirty-Third IAS Annual Meeting (Cat. No.98CH36242).

[7]  Mauro Ciappa,et al.  Selected failure mechanisms of modern power modules , 2002, Microelectron. Reliab..

[8]  Kristian Bonderup Pedersen,et al.  Bond wire lift-off in IGBT modules due to thermomechanical induced stress , 2012, 2012 3rd IEEE International Symposium on Power Electronics for Distributed Generation Systems (PEDG).

[9]  C.P.W. Geurts,et al.  Proceedings of the 13th international conference on wind engineering (ICWE13), July 10-15, 2011, Amsterdam , 2011 .