A novel digital multi-mode control strategy with PSM for primary-side flyback converter

ABSTRACT This article described a novel digital multi-mode control strategy for primary-side controlled flyback converter to improve the efficiency within full-load range. The working modes of different load ranges were chosen according to the main power losses analysis and other constraint. Especially, a novel pulse skip mode control method which could reduce the number of actual switching cycles was proposed to improve the light load efficiency. A prototype with field-programmable gate array control has been made to verify the proposed digital multi-mode control strategy.

[1]  Marn-Go Kim,et al.  An improved two-switch flyback converter with regenerative clamping , 2011 .

[2]  Bongkoo Kang,et al.  Improvement of power-conversion efficiency at light-load using a variable-duty burst mode , 2013, 2013 IEEE Power and Energy Conference at Illinois (PECI).

[3]  Feng Xu,et al.  Simulation realization of skip cycle mode integrated control circuit in the switching power supply with low standby loss , 2007 .

[4]  N. Barry,et al.  Primary side control circuit of a flyback converter , 2001, APEC 2001. Sixteenth Annual IEEE Applied Power Electronics Conference and Exposition (Cat. No.01CH37181).

[5]  Hangbiao Li,et al.  A high energy efficiency PSM/PWM dual-mode for DC-DC converter in portable applications , 2009, 2009 International Conference on Communications, Circuits and Systems.

[6]  Ehsan Adib,et al.  Novel zero voltage transition pulse width modulation flyback converter , 2010 .

[7]  Xiaogao Xie,et al.  Improved Synchronous Rectifier Driving Strategy for Primary-Side Regulated (PSR) Flyback Converter in Light-Load Mode , 2014, IEEE Transactions on Power Electronics.

[8]  Jung-Min Kwon,et al.  A single-stage quasi-resonant flyback converter using a synchronous rectifier , 2011 .

[9]  Yu-Lin Wang,et al.  A multimode digital controller IC for flyback converter with high accuracy primary-side feedback , 2013, Journal of Zhejiang University SCIENCE C.

[10]  Hsiao-Hsing Chou,et al.  An Adaptive Output Current Estimation Circuit for a Primary-Side Controlled LED Driver , 2013, IEEE Transactions on Power Electronics.

[11]  B. Yuan,et al.  Load current-sensing circuit integrated in high-frequency PWM/PFM hybrid DC–DC buck converter , 2014 .

[12]  Yong Li,et al.  A low-cost adaptive multi-mode digital control solution maximizing AC/DC power supply efficiency , 2010, 2010 Twenty-Fifth Annual IEEE Applied Power Electronics Conference and Exposition (APEC).

[13]  T. Mishima,et al.  Pulse Width and Pulse Frequency Modulation Pattern Controlled Active Clamp ZVS Inverter Link AC-DC Power Converter Utility AC Side Active Power Filtering Function for Consumer Magnetron Driver , 2007, IECON 2007 - 33rd Annual Conference of the IEEE Industrial Electronics Society.

[14]  FangJian,et al.  PRIMARY SIDE DETECTION AND PEAK CURRENT MODE CONTROL IN FLYBACK CONVERTER , 2004 .