Experimental study on the self-humidification effect in proton exchange membrane fuel cells containing double gas diffusion backing layer

Adequate hydration of the membrane is required to ensure high proton conductivity in proton exchange membrane fuel cells (PEMFCs), which, in turn, is required for achieving high cell performances. While external humidifiers are typically used to humidify the supplied air in conventional systems, their use increases the complexity, weight, volume, and parasitic power loss in fuel cell systems, rendering them unviable in some systems, particularly for portable applications. In this study, the structure of a gas diffusion backing layer (GDBL) was modified to enhance the self-humidification effect in PEMFCs. Three types of GDLs were prepared for the experiments: a conventional GDL (GDL-A with uniform single GDBL) and two modified GDLs (GDL-A′B with uniform double GDBL and GDL-A′C with heterogeneous double GDBLs). In order to evaluate the effect of stacking and structural design on the self-humidification characteristics, some characteristics of the GDLs such as contact angle, resistance, and vapor permeation rate were measured. The electrochemical performances of the fuel cells were also measured at various relative humidity (RH) and stoichiometric ratio (SR) conditions. The results showed that stacking had a negligible effect, whereas the structural design of the GDBL had a significant effect on self-humidification. The self-humidification effect and the cell performance were improved significantly in the structurally modified GDBL. In addition, considering the actual field conditions and the results of the present study, it was concluded that the structural modifications made to the GDBL would be beneficial in improving the performance of the self-humidified PEMFCs.

[1]  Min-Soo Kim,et al.  Studies on the cathode humidification by exhaust gas recirculation for PEM fuel cell , 2012 .

[2]  B. Yi,et al.  Investigation on sulfuric acid sulfonation of in-situ sol–gel derived Nafion/SiO2 composite membrane , 2011 .

[3]  M. Balat.  Potential importance of hydrogen as a future solution to environmental and transportation problems , 2008 .

[4]  Tomasz Wiltowski,et al.  Separation of hydrogen from syngas using a regenerative system , 2008 .

[5]  Bo Ki Hong,et al.  Effects of anisotropic bending stiffness of gas diffusion layers on the performance of polymer electrolyte membrane fuel cells with bipolar plates employing different channel depths , 2014 .

[6]  Ravindra Datta,et al.  Understanding the gas diffusion layer in proton exchange membrane fuel cells. I. How its structural characteristics affect diffusion and performance , 2014 .

[7]  Suk Won Cha,et al.  An experimental study on the purge characteristics of the cathodic dead-end mode PEMFC for the submarine or aerospace applications and performance improvement with the pulsation effects , 2010 .

[8]  Kazunari Sasaki,et al.  Estimation of flooding in PEMFC gas diffusion layer by differential pressure measurement , 2007 .

[9]  Yong Chan Kim,et al.  Effects of self-humidification on the dynamic behavior of polymer electrolyte fuel cells , 2009 .

[10]  Min-Hsing Chang,et al.  Two-phase transport in the cathode gas diffusion layer of PEM fuel cell with a gradient in porosity , 2008 .

[11]  S. H. Kim,et al.  Improvement of low-humidity performance of PEMFC by addition of hydrophilic SiO2 particles to catalyst layer , 2006 .

[12]  Jong-Won Lee,et al.  A review of gas diffusion layer in PEM fuel cells: Materials and designs , 2012 .

[13]  Nobuyuki Oshima,et al.  Effect of capillary pressure on liquid water removal in the cathode gas diffusion layer of a polymer electrolyte fuel cell , 2008 .

[14]  D. Brett,et al.  Effect of clamping pressure on ohmic resistance and compression of gas diffusion layers for polymer electrolyte fuel cells , 2012 .

[15]  L. C. Meher,et al.  Technical aspects of biodiesel production by transesterification—a review , 2006 .

[16]  E. Ticianelli,et al.  Effects of the cathode gas diffusion layer characteristics on the performance of polymer electrolyte fuel cells , 2002 .

[17]  Chin-Hsiang Cheng,et al.  Effects of porosity gradient in gas diffusion layers on performance of proton exchange membrane fuel cells , 2010 .

[18]  Kyoung G. Lee,et al.  Sonochemical synthesis of Pt-deposited SiO2 nanocomposite and its catalytic application for polymer electrolyte membrane fuel cell under low-humidity conditions , 2012 .

[19]  Ramin Roshandel,et al.  The effects of porosity distribution variation on PEM fuel cell performance , 2005 .

[20]  A. Oikonomou,et al.  Influence of the water content on the kinetics of counter-ion transport in perfluorosulphonic membranes , 1990 .

[21]  Kyoungdoug Min,et al.  Analysis of the transient response and durability characteristics of a proton exchange membrane fuel cell with different micro-porous layer penetration thicknesses , 2013 .

[22]  Yuh-Shan Ho,et al.  Gas diffusion layer for proton exchange membrane fuel cells—A review , 2009 .

[23]  Jinsheng Xiao,et al.  Effects of porosity distribution variation on the liquid water flux through gas diffusion layers of PEM fuel cells , 2006 .

[24]  Eunsook Lee,et al.  Development of a novel hydrophobic/hydrophilic double micro porous layer for use in a cathode gas di , 2011 .

[25]  H. N. Yang,et al.  Preparation of Nafion/various Pt-containing SiO2 composite membranes sulfonated via different sources of sulfonic group and their application in self-humidifying PEMFC , 2013 .

[26]  Kan-Lin Hsueh,et al.  Improvement of the proton exchange membrane fuel cell (PEMFC) performance at low-humidity conditions by adding hygroscopic γ-Al2O3 particles into the catalyst layer , 2008 .

[27]  Jinsheng Xiao,et al.  Gas diffusion through differently structured gas diffusion layers of PEM fuel cells , 2007 .

[28]  Yun Wang,et al.  A review of polymer electrolyte membrane fuel cells: Technology, applications,and needs on fundamental research , 2011 .

[29]  M. Hori,et al.  Novel gas diffusion layer with water management function for PEMFC , 2004 .

[30]  Jaeyoung Lee,et al.  Atomic-layer-deposited TiO2 on cathode gas diffusion layer for low humidity operation in hydrogen fuel cells , 2012 .

[31]  Kourosh Zanganeh,et al.  A novel process integration, optimization and design approach for large-scale implementation of oxy-fired coal power plants with CO2 capture , 2007 .

[32]  Falin Chen,et al.  Effects of porosity change of gas diffuser on performance of proton exchange membrane fuel cell , 2003 .

[33]  M. Watanabe,et al.  Preparation of highly dispersed SiO2 and Pt particles in Nafion®112 for self-humidifying electrolyte membranes in fuel cells , 2006 .

[34]  Chao-Yang Wang,et al.  Measurement of relative permeability of fuel cell diffusion media , 2010 .

[35]  Liu Xiaowei,et al.  Elimination of water flooding of cathode current collector of micro passive direct methanol fuel cell by superhydrophilic surface treatment , 2014 .

[36]  Huaneng Su,et al.  Self-humidification of a PEM fuel cell using a novel Pt/SiO2/C anode catalyst , 2010 .

[37]  Hiroyuki Uchida,et al.  Investigation of the effect of a hydrophilic layer in the gas diffusion layer of a polymer electrolyte membrane fuel cell on the cell performance and cold start behaviour , 2014 .

[38]  M. Morishita,et al.  Novel hydrophilic and hydrophobic double microporous layer coated gas diffusion layer to enhance performance of polymer electrolyte fuel cells under both low and high humidity , 2013 .

[39]  M. Sharma,et al.  Prospects of biodiesel production from vegetable oils in India , 2005 .

[40]  H. Nakajima,et al.  Hydrophilic and hydrophobic double microporous layer coated gas diffusion layer for enhancing performance of polymer electrolyte fuel cells under no-humidification at the cathode , 2012 .

[41]  Suk Won Cha,et al.  Experimental study on enhancing the fuel efficiency of an anodic dead-end mode polymer electrolyte m , 2010 .

[42]  Megumi Kato,et al.  Design of low-humidification PEMFC by using cell simulator and its power generation verification test , 2006 .

[43]  Hiroyuki Uchida,et al.  Self-Humidifying Electrolyte Membranes for Fuel Cells Preparation of Highly Dispersed TiO 2 Particles in Nafion 112 , 2003 .

[44]  M. Morishita,et al.  Water vapor exchange system using a hydrophilic microporous layer coated gas diffusion layer to enhance performance of polymer electrolyte fuel cells without cathode humidification , 2012 .