Development of a model for the simulation of the transfer of surface structure in the temper-rolling process

In the temper rolling process the effect of transferring the roll-surface structure to the steel sheet is purposely used to adjust a defined sheet-surface structure required for further processing. At the moment four cifferent texturing techniques (SBT, EDT, EBT, LT) are available for the production of specified roll-surface structures ; these techniques are based on two fundamental mechanisms : plastic deformation and local melting. The objective of the investigation presented in this paper is to analyze the transfer behaviour specific to the texturing technique used and, in addition to that, to develop a model for the simulation of these transfer characteristics. For this purpose in the first part the results of a comparative study on the basis of rolling tests on an industrial temper mill are presented. These results do not only point out the basic transfer mechanisms - penetration processes and reverse extrusion phenomena - but beyond that also lead to an explanation of the transfer behaviour specific to the texturing systems by the application of similarity numbers (substitute profile model). Possible reasons for the different transfer behaviour are on the one hand wear effects and on the other hand process-induced characteristics of the structure itself (e.g. isolated lubrication pockets). On the basis of these results in the second part a model is developed to simulate the transfer characteristics by the application of the finite element method (FEM).