Design and Manufacture of Woven Reinforced Glass/Polypropylene Composites for Mass Transit Floor Structure

Recent developments in hot-melt impregnation, extrusion, and thermoforming offer multiple avenues for the design and manufacture of low-cost thermoplastic composites for mass transit and automotive applications. Fiber reinforced thermoplastics such as glass/polypropylene (glass/PP) have found their applications in front-end bumper beams, under body shields, and other automotive applications. These materials also have potential usage in mass transit vehicles, such as buses. The present study focuses on the design and manufacture of a segment of the floor of a mass transit bus using glass/PP woven tape forms developed through a hot-melt impregnation process. An initial study on the existing mass transit buses found that a metal skeletal frame and plywood panels are used in the construction of the floor structure. The representative thermoplastic composite floor segment featured a glass/PP woven tape material, belt-pressed to form a flat laminate, and adhesively bonded to a vacuum thermoformed ribbed laminate. A combination of analysis software including Pro/Engineer, Hyper Mesh, and ANSYS 7.0 were used for the design and analysis. Weight savings up to 40% were realized using glass/PP woven tape thermoplastic composites as compared to the conventional metal/ plywood design

[1]  Gilbert Lebrun,et al.  Evaluation of bias-extension and picture-frame test methods for the measurement of intraply shear properties of PP/glass commingled fabrics , 2003 .

[2]  F. Keulen,et al.  Elastic stiffness analysis of a thermo-formed plain-weave fabric composite: Part I: geometry , 2000 .

[3]  E. L. D'Hooghe,et al.  Thermoplastic Composite Technology; Tougher Than You Think , 2000 .

[4]  Bernard Budiansky,et al.  On the minimum weights of compression structures , 1999 .

[5]  S. Bush,et al.  Sheet extrusion and thermoforming of discrete long glass fibre reinforced polypropylene , 2000 .

[6]  Suresh G. Advani,et al.  Process Modeling in Composites Manufacturing , 2004 .

[7]  James H. Starnes,et al.  Structural efficiency study of graphite-epoxy aircraft rib structures , 1990 .

[8]  M. Hou.  Stamp forming of continuous glass fibre reinforced polypropylene , 1997 .

[9]  Giuseppe Sala,et al.  A Numerical and Experimental Approach to Optimise Sheet Stamping Technologies: Polymers Thermoforming , 2002 .

[10]  J. Koenig,et al.  The characterization of low cost fiber reinforced thermoplastic composites produced by the DRIFT™ process , 2001 .

[11]  M. Ashby,et al.  The topological design of multifunctional cellular metals , 2001 .

[12]  Y. Maoult,et al.  Experimental study and numerical simulation of preform or sheet exposed to infrared radiative heating , 2001 .

[13]  Christos Kassapoglou,et al.  Simultaneous cost and weight minimization of composite-stiffened panels under compression and shear , 1997 .