The design of miniature 3D RF module

High-density packaging has become an important driver for new portable electronics. Miniature discrete components, flip-chip bonding of ICs and thin multilayer substrates are essentials for a small product. Further size reduction can be achieved with the integration of various passives, and modern covers with metal plated wiring can act as a substrate for the device. A 3D system-in-package (SiP) combines different chips and techniques into a single package without compromising individual semiconductor technologies. The driving force is the ability to construct complex, yet portable devices cost effectively and with high yield. A miniature 3D SiP short-range RF module operating in the unlicensed 2.4 GHz band was designed and manufactured. This paper introduces the module and discusses the steps required in designing, testing, and assembling of such complicated systems. Electrical design must meet the criteria set by system functionality, thermal behavior, testing environment, and manufacturing facilities. This work continues the research of the stacked 3D packaging technique developed in the Institute of Electronics at Tampere University of Technology. It utilizes thin high-density interconnect (HDI) printed wire board (PWB) interposers and flip-chip bonding of thinned chips. Interposers are stacked and bonded using solder plated polymer spheres.

[1]  Jianhua Wu,et al.  RF SiP technology innovation through integration , 2003, Fifth International Conference onElectronic Packaging Technology Proceedings, 2003. ICEPT2003..

[2]  A.B. Smolders,et al.  RF SiP: the next wave for wireless system integration , 2004, 2004 IEE Radio Frequency Integrated Circuits (RFIC) Systems. Digest of Papers.

[3]  Clemens J. M. Lasance.  Recent progress in compact thermal models , 2003, Ninteenth Annual IEEE Semiconductor Thermal Measurement and Management Symposium, 2003..

[4]  T. Swirbel,et al.  Electrical design and simulation of high density printed circuit boards , 1999 .

[5]  J. Miettinen,et al.  Stacked 3-D MCP with plastic ball vertical interconnections , 2003, 53rd Electronic Components and Technology Conference, 2003. Proceedings..

[6]  E. Beyne,et al.  Wafer-level packaging technology for high-Q on-chip inductors and transmission lines , 2004, IEEE Transactions on Microwave Theory and Techniques.

[7]  S.K. Pienimaa,et al.  High density packaging for mobile terminals , 2001, 2001 Proceedings. 51st Electronic Components and Technology Conference (Cat. No.01CH37220).

[8]  M. Mantysalo,et al.  System design issues for 3D system-in-package (SiP) , 2004, 2004 Proceedings. 54th Electronic Components and Technology Conference (IEEE Cat. No.04CH37546).