Theoretical and numerical investigation on the fin effectiveness and the fin efficiency of printed circuit heat exchanger with straight channels

Abstract Theoretical and numerical studies were conducted on the fin effectiveness and the fin efficiency of printed circuit heat exchanger (PCHE). A heat conduction equation for the fins of PCHE with straight channels was derived, from which the longitudinal temperature distribution of the fins can be obtained. And the expressions of the fin effectiveness and the fin efficiency were developed. Based on their expressions, an understanding of the heat transfer process between the fin surface and the bulk fluid was improved. Results show that the PCHE fin effectiveness is enhanced by the choices of high fin thermal conductivity, decreasing the ratio of the fin thickness to the radius of the channels, or under conditions for which the convective coefficient is small. As for the fin efficiency of PCHE, it's improved with high fin thermal conductivity, thick fin and low convective coefficient of the working fluid. For the cases with large Biot number, the PCHE fin effectiveness and the PCHE fin efficiency can be weakened up to 20%, which should be considered in the modeling of thermal-hydraulic. Moreover, the theoretical investigations were validated against the numerical simulation, and they agree with each other very well.

[1]  Yoshiaki Oka,et al.  Numerical investigation of heat transfer in upward flows of supercritical water in circular tubes and tight fuel rod bundles , 2007 .

[2]  Koroush Shirvan,et al.  The design of a compact integral medium size PWR : the CIRIS , 2012 .

[3]  J. Lim,et al.  Stress and Heat Transfer Analyses for Different Channel Arrangements of PCHE , 2008 .

[4]  Jan Fokkens,et al.  Promising designs of compact heat exchangers for modular HTRs using the Brayton cycle , 2008 .

[5]  Konstantin Nikitin,et al.  New printed circuit heat exchanger with S-shaped fins for hot water supplier , 2006 .

[6]  H. No,et al.  Thermal hydraulic performance analysis of a printed circuit heat exchanger using a helium–water test loop and numerical simulations , 2011 .

[7]  Y. Kato,et al.  Printed circuit heat exchanger thermal–hydraulic performance in supercritical CO2 experimental loop , 2006 .

[8]  Y. Kato,et al.  Medium temperature carbon dioxide gas turbine reactor , 2004 .

[9]  Qiuwang Wang,et al.  Optimization of fin arrangement and channel configuration in an airfoil fin PCHE for supercritical CO2 cycle , 2014 .

[10]  Jiyun Zhao,et al.  Small and Medium sized Reactors (SMR): A review of technology , 2015 .

[11]  A. Kruizenga.  Heat transfer and pressure drop measurements in prototypic heat exchanges for the supercritical carbon dioxide Brayton power cycles , 2010 .

[12]  Vaclav Dostal,et al.  A supercritical carbon dioxide cycle for next generation nuclear reactors , 2004 .

[13]  L. Cachon,et al.  Flow analysis of an innovative compact heat exchanger channel geometry , 2016 .

[14]  Hee Cheon No,et al.  Thermal hydraulic performance analysis of the printed circuit heat exchanger using a helium test facility and CFD simulations , 2009 .

[15]  Zhang Yifan,et al.  PDF-based modeling on the turbulent convection heat transfer of supercritical CO2 in the printed circuit heat exchangers for the supercritical CO2 Brayton cycle , 2016 .