Autonomous Impact Damage Monitoring in a Stiffened Composite Panel

This study is concerned with the detection and characterization of impact damage in a stiffened woven composite structure using high frequency Lamb waves and low frequency modal vibrations. The geometric and material complexities of the structure present practical difficulties in the direct analysis of both wave propagation and modal vibration data using theoretical constructs. Improved ultrasonic and vibration test setups consisting of distributed, high fidelity, and surface mounted sensor arrays are used here to determine changes in the dynamical properties of the composite structural components in the presence of damage. The sensors are assumed to provide both the low frequency global response (i.e., modal frequencies and mode shapes) of the structure to external loads and the (local) high frequency signals due to wave propagation effects in either passive or active mode of the ultrasonic array. A damage index, comparing the measured dynamical response of two successive states of the structure is introduced as a determinant of structural damage. The method relies on the fact that the dynamical properties of a structure change with the initiation or growth of damage. A diagnostic imaging tool is used for the interpretation and graphical representation of the indices to enable automated monitoring of the changes in the indices at a given instant of time. The value of the index at a given sensor increases with the proximity of the damage to the sensor. A sensitivity analysis is carried out in an effort to determine a threshold value of the index below which no reliable information about the state of health of the structure can be estimated. It is shown that the automated procedure is able to identify a defect right from its appearance, with some degree of confidence. The feasibility of developing a practical intelligent structural health monitoring system (ISHMS), based on the concept of `a structure requesting service when needed,' is discussed.

[1]  Dimitris A. Saravanos,et al.  Coupled Layerwise Analysis of Composite Beams with Embedded Piezoelectric Sensors and Actuators , 1995 .

[2]  Charles R. Farrar,et al.  Damage identification and health monitoring of structural and mechanical systems from changes in their vibration characteristics: A literature review , 1996 .

[3]  Ajit K. Mal,et al.  Wave theory of acoustic emission in composite laminates , 1996 .

[4]  P. Wilcox,et al.  Flexible interdigital PVDF transducers for the generation of Lamb waves in structures , 1997 .

[5]  Fu-Kuo Chang,et al.  Structural Health Monitoring , 2016 .

[6]  Zensheu Chang,et al.  WAVE PROPAGATION IN A PLATE WITH DEFECTS , 1998 .

[7]  Roy Ikegami,et al.  Crack growth detection and monitoring using broadband acoustic emission techniques , 1999, Smart Structures.

[8]  R. Badcock,et al.  The use of 0-3 piezocomposite embedded Lamb wave sensors for detection of damage in advanced fibre composites , 2000 .

[9]  Daniel J. Inman,et al.  IMPEDANCE-BASED HEALTH MONITORING OF CIVIL STRUCTURAL COMPONENTS , 2000 .

[10]  Grant P. Steven,et al.  VIBRATION-BASED MODEL-DEPENDENT DAMAGE (DELAMINATION) IDENTIFICATION AND HEALTH MONITORING FOR COMPOSITE STRUCTURES — A REVIEW , 2000 .

[11]  Leonardo Lecce,et al.  Experimental and Numerical Activities on Damage Detection Using Magnetostrictive Actuators and Statistical Analysis , 2000 .

[12]  Jeong‐Tae Kim,et al.  Improved damage identification method based on modal information , 2002 .

[13]  Constantinos Soutis,et al.  Damage detection in composite materials using frequency response methods , 2002 .

[14]  Anindya Ghoshal,et al.  Experimental Damage Detection on a Wing Panel Using Vibration Deflection Shapes , 2003 .

[15]  Sauvik Banerjee,et al.  Acoustic emission waveforms in composite laminates under low velocity impact , 2003, SPIE Smart Structures and Materials + Nondestructive Evaluation and Health Monitoring.

[16]  S. Abrate.  Composite structures: impact on composites 2002 , 2003 .

[17]  Fabrizio Ricci,et al.  A Conceptual Structural Health Monitoring System based on Vibration and Wave Propagation , 2005 .

[18]  Roy Ikegami,et al.  Advances in the development of built-in diagnostic system for filament wound composite structures , 2006 .