Wheatstone bridge magnetic field sensors using giant magnetoresistive ratio (GMR) multilayers were designed, fabricated, and evaluated. The GMR ranged from 10% to 20% with saturation fields of 60 Oe to 300 Oe. The multilater resistances decreased linearly with magnetic field and showed little hysteresis. In one sensor configuration, a permanent magnet bias was placed between two pairs of magnetoresistors, each pair representing opposite legs of the bridge. This sensor gave a bipolar bridge output whose output range was approximately GMR times the bridge source voltage. The second sensor configuration used shielding on one resistor pair, and it gave a bridge output dependent on the magnetic field magnitude, but not polarity, and the output range was approximately one half GMR tines the bridge source voltage. Field amplifications of 3 to 6 were accomplished by creating a gap in a low reluctance magnetic path, thus providing the full range of outputs with 1/3 to 1/6 of the intrinsic saturation fields of the GMR multilayers. >
[1]
J. Lenz.
A review of magnetic sensors
,
1990,
Proc. IEEE.
[2]
T. Mcguire,et al.
Anisotropic magnetoresistance in ferromagnetic 3d alloys
,
1975
.
[3]
Charles R. Westgate,et al.
The Hall effect and its applications
,
1980
.
[4]
Etienne,et al.
Giant magnetoresistance of (001)Fe/(001)Cr magnetic superlattices.
,
1988,
Physical review letters.
[5]
Y. J. Chen,et al.
GMR materials for low field applications
,
1993
.