Investigation of single-mode fiber degradation by 405-nm continuous-wave laser light

Abstract. The degradation of 405-nm fiber-coupled diode laser systems with more than 50 mW power was investigated in detail with focus on the effects occurring at the input end. The coupling and transmission loss of the laser light were associated with the growth of a projection and a periodic structure on the input surface. To avoid this degradation, a short launch fiber with a good surface quality was used at the input end. In this way, the power transmission was stabilized for at least one month. However, structural degradation was noticed on the output surface of the single-mode fiber. To investigate this effect, the damaged samples were measured after different periods of time and examined with a scanning electron microscope and with an atomic force microscope. Reproducible spherical projections with a submicron periodic structure were found in the core region. Additionally, the spectral loss of the fiber was measured, showing the formation of color centers in the deep ultraviolet along the length of the fiber. These investigations were accompanied by simulations of the growth of the structure on the output surface. The influence of the structure was mainly on the divergence angle of the emitted laser beam, reducing the beam quality for applications.

[1]  Peter Karlitschek,et al.  Suppression of solarization effects in optical fibers for 266-nm laser radiation , 1997, Laser Damage.

[2]  Jörg Krüger,et al.  Femtosecond laser-induced periodic surface structures on silica , 2012 .

[3]  Peter Karlitschek,et al.  Possibilities and limitations of optical fibers for the transmission of excimer laser radiation , 1997, Laser Damage.

[4]  Kenneth T. V. Grattan,et al.  High power 405nm diode laser fiber-coupled single-mode system with high long-term stability , 2013, Photonics West - Lasers and Applications in Science and Engineering.

[5]  T. Sun,et al.  Influence of high power 405 nm multi-mode and single-mode diode laser light on the long-term stability of fused silica fibers , 2012, Other Conferences.

[6]  Fabrizio Messina,et al.  Generation of defects in amorphous SiO2 assisted by two-step absorption on impurity sites , 2008, Journal of physics. Condensed matter : an Institute of Physics journal.

[7]  Junji Kato,et al.  Surgical performance of a 405-nm diode laser in treatment of soft tissue , 2008 .

[8]  K.-F. Klein,et al.  Investigation of single-mode fiber output damage by 405nm CW laser light , 2013, Laser Damage.

[9]  Jörg Krüger,et al.  Formation of laser-induced periodic surface structures on fused silica upon multiple cross-polarized double-femtosecond-laser-pulse irradiation sequences , 2011 .

[10]  Jeff F. Young,et al.  Laser-induced periodic surface structure. I. Theory , 1983 .

[11]  Linards Skuja,et al.  Direct singlet-to-triplet optical absorption and luminescence excitation band of the twofold-coordinated silicon center in oxygen-deficient glassy SiO 2 , 1994 .

[12]  J. Irven,et al.  Optical fiber communications, Volume 1: Fiber Fabrication: Edited by Tingye Li Academic, 1985, pp xii + 363, £54, $54 , 1985 .

[13]  Kenneth T. V. Grattan,et al.  Generation of periodic surface structures on silica fibre surfaces using 405 nm CW diode lasers , 2013 .

[14]  Kenneth T. V. Grattan,et al.  UV-stabilized silica-based fibre for applications around 200 nm wavelength , 1997 .

[15]  Karl-Friedrich Klein,et al.  High-OH fibers with higher stability in the UV-region , 2006, SPIE BiOS.

[16]  Kenneth T. V. Grattan,et al.  Lifetime prediction for 405-nm single-mode delivery systems for therapeutic laser applications , 2012, Other Conferences.

[17]  Tim Scharnweber,et al.  Rapid prototyping of microstructures in polydimethylsiloxane (PDMS) by direct UV-lithography. , 2011, Lab on a chip.

[18]  P. Mazzoldi,et al.  Radiation effects in glasses , 1986 .

[19]  Eric J. Seibel,et al.  Delivery of single-mode and multi-mode therapeutic laser light using a single and dual cladding optical fiber for a scanning fiber endoscope , 2011, BiOS.

[20]  J. Wilborn,et al.  Effects of combined 405-nm and 880-nm light on Staphylococcus aureus and Pseudomonas aeruginosa in vitro. , 2006, Photomedicine and laser surgery.

[21]  John E. Sipe,et al.  Laser Induced Periodic Surface Structure , 1982 .

[22]  Douglas C. Allan,et al.  Induced density changes in 193-nm excimer-laser-damaged silica glass: a kinetic model , 2004, SPIE Advanced Lithography.

[23]  K. Kemeter,et al.  Herstellungsverfahren von Lichtwellenleitern , 2002 .

[24]  Timothy D. Soper,et al.  Scanning fiber endoscopy with highly flexible, 1 mm catheterscopes for wide‐field, full‐color imaging , 2010, Journal of biophotonics.

[25]  L. Skuja.  Optically active oxygen-deficiency-related centers in amorphous silicon dioxide , 1998 .

[26]  Kenneth T. V. Grattan,et al.  Surface and bulk effects in silica fibers caused by 405 nm CW diode laser irradiation and means for mitigation , 2012, Laser Damage.