A comparison of the conversion efficiency from optical power to electrical power for three common material homojunction photovoltaic micro-cells was performed. The device widths were varied as a function of incident wavelength such that optimum power conversions were determined whilst under illumination of monochromatic light. GaAs is the most effective material as optimum devices can be fabricated as thin as 15um thick with conversion efficiencies as high as 59%. However, GaAs is extremely expensive and has a limited wavelength response. Although Ge has the lowest conversion efficiency of 36%, it is the only material simulated that is responsive under illumination of long wavelengths above 1.0um, and may be particularly useful for specific applications as it is efficient at both 1310nm and 1550nm, where the attenuation in silica fibres is minimal. Si is a commercially viable material for the use as a photovoltaic power converter (PPC) with conversion efficiencies as high as 43% at 980nm. Lasers at this wavelength are extremely cheap to produce, as well as the cost of Silicon PPCs being minimal.
[1]
M. Green,et al.
45% efficient silicon photovoltaic cell under monochromatic light
,
1992,
IEEE Electron Device Letters.
[2]
H.P.D. Lanyon.
The physics of heavily-doped n+-p junction solar cells
,
1980
.
[3]
Donald A. Neamen Zhu.
Semiconductor physics and devices basic principles
,
1991
.
[4]
Graham Wild,et al.
Distributed optical fibre smart sensors for Structural Health Monitoring: A Smart Transducer Interface Module
,
2009,
2009 International Conference on Intelligent Sensors, Sensor Networks and Information Processing (ISSNIP).
[5]
Jan-Gustav Werthen,et al.
Powering Next Generation Networks by Laser Light over Fiber
,
2008,
OFC/NFOEC 2008 - 2008 Conference on Optical Fiber Communication/National Fiber Optic Engineers Conference.
[6]
S. J. Wojtczuk.
Long-wavelength laser power converters for optical fibers
,
1997,
Conference Record of the Twenty Sixth IEEE Photovoltaic Specialists Conference - 1997.