A CFD Modeling Approach for Municipal Sewer System Design Optimization to Minimize Emissions into Receiving Water Body

The design of the urban sewage system is site specific, and it makes the use of three-dimensional (3D) model an alternative to a field study or a laboratory experiment. However, the use of 3D computational fluid dynamics (CFD) in the study of the urban sewage system has been generally limited to the study of a single structural component with simplified assumptions. In this study, the 3D model that adopted the renormalized group (RNG) k-ε turbulence model, the volume of fluid (VOF) free water surface model and the particle tracking approach was verified comparing the predicted flow field data with the measurements in laboratory scale experiments. Then, the model was applied to optimize the design of the combined sewer system (CSS) in the city of Edmonton with multiple hydraulic structures. Considering the details of predicted flow characteristics and the behaviors of the suspended solids, the final design was chosen and implemented to reduce the water pollution induced by the direct combined sewer overflow (CSO) discharge to the receiving water body. It is shown that the proposed 3D CFD modeling approach is a cost-effective tool to design the municipal sewer system.

[1]  Savvas Xanthos,et al.  Performance Assessment of Secondary Settling Tanks Using CFD Modeling , 2011 .

[2]  W. Rauch,et al.  Increase of River Base Flow by Hydropower Gate Operation for Mitigation of CSO Impacts – Potential and Limitations , 2007 .

[3]  A. J. Saul,et al.  Modelling the Performance of Combined‐Sewer Overflow Chambers , 2001 .

[4]  A. Saul.  Increasing Knowledge of CSO Technologies , 2004 .

[5]  Richard Burrows,et al.  The management of sediment in combined sewers , 2000 .

[6]  V. Stovin,et al.  Bed Shear Stress Boundary Condition for Storage Tank Sedimentation , 2003 .

[7]  Amruthur S. Ramamurthy,et al.  Three-dimensional modelling of flow in sharp open-channel bends with vanes , 2011 .

[8]  Leslie M. Smith,et al.  Renormalization group analysis of turbulence , 2003 .

[9]  Sreenivas Jayanti,et al.  Computational Study of Particle-Eddy Interaction in Sedimentation Tanks , 2004 .

[10]  J. Riley,et al.  Equation of motion for a small rigid sphere in a nonuniform flow , 1983 .

[11]  Kiyoshi Miyajima,et al.  Filtration of municipal sewage by ring shaped floating plastic net media , 1995 .

[12]  P. Servais,et al.  Modelling the impacts of Combined Sewer Overflows on the river Seine water quality. , 2007, The Science of the total environment.

[13]  S. Orszag,et al.  Development of turbulence models for shear flows by a double expansion technique , 1992 .

[14]  Matthieu Dufresne,et al.  CFD Modeling of Solid Separation in Three Combined Sewer Overflow Chambers , 2009 .

[15]  A. Gosman,et al.  Aspects of Computer Simulation of Liquid-Fueled Combustors , 1983 .

[16]  S. A. Morsi,et al.  An investigation of particle trajectories in two-phase flow systems , 1972, Journal of Fluid Mechanics.

[17]  C. W. Hirt,et al.  Volume of fluid (VOF) method for the dynamics of free boundaries , 1981 .

[18]  Zhanfeng Cui,et al.  CFD modelling of gas-sparged ultrafiltration in tubular membranes , 2002 .

[19]  F. Bombardelli,et al.  High-resolution Numerical Simulation of Flow Through a Highly Sinuous River Reach , 2004 .

[20]  Martin Fischer,et al.  Optimization of a hydrodynamic separator using a multiscale computational fluid dynamics approach. , 2013, Water science and technology : a journal of the International Association on Water Pollution Research.

[21]  Daniel Sztruhar,et al.  Enhancing urban environment by environmental upgrading and restoration , 2005 .

[22]  Hexiang Yan,et al.  3D modeling of flow, solid transport and settling processes in a large stormwater detention basin , 2011 .

[23]  Wolfgang Rauch,et al.  Assessing the relationship between water level and combined sewer overflow with computational fluid dynamics , 2008 .