Optimization of surface roughness in broaching

Abstract The broaching process is used to generate high quality surfaces in very short times. In order to improve the understanding of the evolution of surface quality in broaching, a sensitivity study of the influence on the surface roughness of several broaching parameters dealing with the tool design, the cutting conditions or the workpiece material was performed. Forces and chip formation have also been analyzed so as to highlight the surface roughness generation. This paper shows how the process parameters (such as cutting speed or lubrication), tool design (rise per tooth, tooth angles, substrate material), and workpiece material affects the surface roughness.

[1]  Fritz Klocke,et al.  Force-based Temperature Modeling for Surface Integrity Prediction in Broaching Nickel-based Alloys , 2014 .

[2]  Guillaume Fromentin,et al.  Effects of a straight oil on friction at the tool-workmaterial interface in machining , 2010 .

[3]  Fritz Klocke,et al.  Modelling of Process Forces in Broaching Inconel 718 , 2013 .

[4]  Samad Nadimi Bavil Oliaei,et al.  Investigating the influence of built-up edge on forces and surface roughness in micro scale orthogonal machining of titanium alloy Ti6Al4V , 2016 .

[5]  Pedro J. Arrazola,et al.  Characterisation of friction and heat partition coefficients at the tool-work material interface in cutting , 2013 .

[6]  Volker Schulze,et al.  Surface Quality after Broaching with Variable Cutting Thickness , 2014 .

[7]  M. Elbestawi,et al.  Surface defects during microcutting , 2006 .

[8]  Volker Schulze,et al.  High speed broaching of case hardening steel SAE 5120 , 2012 .

[9]  M. A. Elbestawi,et al.  The Effect of Microstructure on Chip Formation and Surface Defects in Microscale, Mesoscale, and Macroscale Cutting of Steel , 2006 .

[10]  Frederik Zanger,et al.  Numerical Investigation of the Changing Cutting Force Caused by the Effects of Process Machine Interaction While Broaching , 2012 .

[11]  F. Klocke,et al.  Dry Broaching Using Carbon Free Steel as Tool Material , 2016 .

[12]  Hossam A. Kishawy,et al.  An energy based analysis of broaching operation: Cutting forces and resultant surface integrity , 2012 .

[13]  Nabil Gindy,et al.  An example of selection of the cutting conditions in broaching of heat-resistant alloys based on cutting forces, surface roughness and tool wear , 2005 .

[14]  Fritz Klocke,et al.  Influence of Temperature on Surface Integrity for Typical Machining Processes in Aero Engine Manufacture , 2011 .

[15]  Dragos Axinte.  Approach into the use of probabilistic neural networks for automated classification of tool malfunctions in broaching , 2006 .

[16]  David Dornfeld,et al.  Hard Broaching of Case Hardened SAE 5120 , 2014 .