A battery-less power management circuit for RF energy harvesting with input voltage regulation and synchronous rectification

This paper presents a battery-less power management circuit for RF energy harvesting applications. In general rectenna (antenna and rectifier) exhibits the maximum efficiency for a particular range of load resistance at different values of RF power received by the antenna. To track maximum power transfer and reduce the power overhead of the various modules an efficient and simple scheme is presented in this paper to maintain effective input resistance of the boost converter equal to the effective output resistance of the rectenna. Maximum power point tracking (MPPT) is achieved at the input of boost converter and synchronous rectification technique is also used to stop the loss of energy from output capacitor of the boost converter. It is shown that MPPT as a function of effective output resistance of the rectenna can be maintained for a range of input power without changing the emulated resistance at the input of the boost converter. The entire circuit is designed, optimized and simulated in 180nm mixed-mode CMOS technology. Post layout simulation results are presented for -10dBm input power at 950MHz received by the antenna. Output voltage of 1V is generated across a load resistance of 76 kΩ with achieved boost converter efficiency of 80%.

[1]  Marian K. Kazimierczuk,et al.  Pulse-Width Modulated DC-DC Power Converters , 2008 .

[2]  M. Kazimierczuk.  Pulse-Width Modulated DC-DC Power Converters: Kazimierczuk/Pulse-width Modulated DC-DC Power Converters , 2008 .

[3]  R. Zane,et al.  Resistor Emulation Approach to Low-Power RF Energy Harvesting , 2008, IEEE Transactions on Power Electronics.

[4]  Phillip E Allen,et al.  CMOS Analog Circuit Design , 1987 .

[5]  G. Cho,et al.  A 40 mV Transformer-Reuse Self-Startup Boost Converter With MPPT Control for Thermoelectric Energy Harvesting , 2012, IEEE Journal of Solid-State Circuits.

[6]  Maryam Shojaei Baghini,et al.  Broadband RF energy harvesting system covering CDMA, GSM900, GSM1800, 3G bands with inherent impedance matching , 2016, 2016 IEEE MTT-S International Microwave Symposium (IMS).

[7]  Takayasu Sakurai,et al.  An 80 mV Startup Dual-Mode Boost Converter by Charge-Pumped Pulse Generator and Threshold Voltage Tuned Oscillator With Hot Carrier Injection , 2012, IEEE Journal of Solid-State Circuits.

[8]  Giuseppe Palmisano,et al.  A 90-nm CMOS Threshold-Compensated RF Energy Harvester , 2011, IEEE Journal of Solid-State Circuits.

[9]  Regan Zane,et al.  Resistor Emulation Approach to Low-Power RF Energy Harvesting , 2008 .

[10]  Maryam Shojaei Baghini,et al.  An Integrated CMOS RF Energy Harvester with Differential Microstrip Antenna and On-Chip Charger , 2012, 2012 25th International Conference on VLSI Design.

[11]  Anantha Chandrakasan,et al.  A Battery-Less Thermoelectric Energy Harvesting Interface Circuit With 35 mV Startup Voltage , 2010, IEEE Journal of Solid-State Circuits.

[12]  Liang-Hung Lu,et al.  50 mV-Input Batteryless Boost Converter for Thermal Energy Harvesting , 2013, IEEE Journal of Solid-State Circuits.

[13]  Anantha Chandrakasan,et al.  Platform architecture for solar, thermal and vibration energy combining with MPPT and single inductor , 2011, 2011 Symposium on VLSI Circuits - Digest of Technical Papers.