Piezoelectric energy harvesting from raindrop impacts

PEH (piezoelectric energy harvesting) techniques can be used to capture vibration, motion or acoustic noise, to be converted in to electrical output. In recent years there has been an increased interest in scavenging energy using alternative sources. This study focuses on the impact of raindrop on a PEH device and the possibility of harvesting energy from this source. Impact of water droplets on a PEH are analysed after having been released from various heights to replicate a rain shower. Detailed experimental results show features which have not been published in the literature before. The results show two distinct stages in the voltage and power output; first, a log growth, then an exponential decay during an impact event. A model is also developed to characterise the output power for one unit device which is then applied to an array of rain impact harvesters. The experimental results show a power output for one unit at around 2.5 μW that is typical of the data produced in other publications. However, there is significant room for improvement as the efficiency of the system is found to be no more than 0.12% of the total kinetic energy in a typical raindrop in freefall.

[1]  H. Tilmans.  Equivalent circuit representation of electromechanical transducers: I. Lumped-parameter systems , 1996 .

[2]  Introduction to Drop-Surface Interactions , 2002 .

[3]  Jonathan Swingler,et al.  The effect of relative humidity, temperature and electrical field on leakage currents in piezo-ceramic actuators under dc bias , 2009 .

[4]  C. Tropea,et al.  Droplet-wall collisions: Experimental studies of the deformation and breakup process , 1995 .

[5]  S. Zaleski,et al.  Droplet splashing on a thin liquid film , 2003 .

[6]  Ghislain Despesse,et al.  Harvesting raindrop energy: theory , 2008 .

[7]  R. Houze.  Stratiform precipitation in regions of convection : A meteorological paradox ? , 1997 .

[8]  Asrulnizam Abd Manaf,et al.  Harvesting Raindrop Energy with Piezoelectrics: a Review , 2014, Journal of Electronic Materials.

[9]  Heath Hofmann,et al.  Adaptive piezoelectric energy harvesting circuit for wireless remote power supply , 2002 .

[10]  José Gerardo V. da Rocha,et al.  Energy Harvesting From Piezoelectric Materials Fully Integrated in Footwear , 2010, IEEE Transactions on Industrial Electronics.

[11]  M. Rein.  Phenomena of liquid drop impact on solid and liquid surfaces , 1993 .

[12]  Eugene Zakar.  MEMS Piezo Pressure Sensor for Military Applications , 2004 .

[13]  Nicholas J. Ramer,et al.  Structure and vibrational frequency determination for α-poly(vinylidene fluoride) using density-functional theory , 2006 .

[14]  Earl Scime,et al.  Dynamics of falling raindrops , 2001 .

[15]  Naveen Verma,et al.  Design considerations for ultra-low energy wireless microsensor nodes , 2005, IEEE Transactions on Computers.

[16]  Brighid E. O Dochartaigh,et al.  Baseline Scotland: an overview of available groundwater chemistry data for Scotland , 2005 .

[17]  Yi-Chung Shu,et al.  Efficiency of energy conversion for a piezoelectric power harvesting system , 2006 .

[18]  C Tropea,et al.  Impact of droplets onto inclined surfaces. , 2005, Journal of colloid and interface science.

[19]  B. N. Volkov,et al.  International Tables of the Surface Tension of Water , 1983 .

[20]  V. P. C. Dassanayake,et al.  Harvesting of Kinetic Energy of the Raindrops , 2014 .

[21]  Ghislain Despesse,et al.  Harvesting raindrop energy: experimental study , 2008 .

[22]  Sang-Gook Kim,et al.  Ultra-wide bandwidth piezoelectric energy harvesting , 2011 .

[23]  Othman Sidek,et al.  Simulation of piezoelectric raindrop energy harvester , 2013, IEEE 2013 Tencon - Spring.

[24]  R. Miceli,et al.  Harvesting rainfall energy by means of piezoelectric transducer , 2013, 2013 International Conference on Clean Electrical Power (ICCEP).

[25]  Marco Marengo,et al.  Analysis of impact of droplets on horizontal surfaces , 2002 .

[26]  S. Trolier-McKinstry,et al.  Thin Film Piezoelectrics for MEMS , 2004 .

[27]  Jia-qing Cui,et al.  Applied Mechanics and Engineering Model on Raindrops falling , 2012, EMEIT 2012.

[28]  C. Stow,et al.  An experimental investigation of fluid flow resulting from the impact of a water drop with an unyielding dry surface , 1981, Proceedings of the Royal Society of London. A. Mathematical and Physical Sciences.

[29]  Paul K. Wright,et al.  Powering a wireless sensor node with a vibration-driven piezoelectric energy harvester , 2011 .

[30]  Jonathan Swingler,et al.  Micro-computer tomography—An aid in the investigation of structural changes in lead zirconate titanate ceramics after temperature-humidity bias testing , 2009 .