Evolution of morphology and open-circuit voltage in alloy-energy transfer coexisting ternary organic solar cells

The oligomer-type small molecule PDT2FBT-ID is applied in a polymer/small molecule/fullerene ternary system. The PTB7-Th/PDT2FBT-ID/PC71BM ternary active layer shows complementary absorption spectra, enhanced face-on orientation and energy transfer properties. Compared to the binary system, the FF of the ternary system is improved from 66.72% to 76.14% and the Jsc is improved from 17.90 mA cm−2 to 18.92 mA cm−2. The maximum PCE of 11.1% is obtained in the ternary system with a common inverted device structure. Additionally, an alloy-like domain structure and energy transfer between the two donor materials are found to coexist in the ternary system. Based on the combined model, the variation in morphology and Voc is discussed in detail and compared with previous publications. An in-depth interpretation for the selection of a third compound in high performance ternary organic solar cells is provided. Finally, this facile design strategy could also be widely used in other systems.

[1]  Xiao-Fang Jiang,et al.  High-Performance Ternary Organic Solar Cell Enabled by a Thick Active Layer Containing a Liquid Crystalline Small Molecule Donor. , 2017, Journal of the American Chemical Society.

[2]  F. Liu,et al.  Ternary Organic Solar Cells Based on Two Compatible Nonfullerene Acceptors with Power Conversion Efficiency >10% , 2016, Advanced materials.

[3]  Long Ye,et al.  Energy‐Level Modulation of Small‐Molecule Electron Acceptors to Achieve over 12% Efficiency in Polymer Solar Cells , 2016, Advanced materials.

[4]  Yuguang Ma,et al.  Efficient Ternary Organic Solar Cells with High Composition Tolerance via Integrated Near-IR Sensitization and Interface Engineering , 2016 .

[5]  C. Brabec,et al.  Designing ternary blend bulk heterojunction solar cells with reduced carrier recombination and a fill factor of 77% , 2016, Nature Energy.

[6]  Jianqi Zhang,et al.  Acceptor End‐Capped Oligomeric Conjugated Molecules with Broadened Absorption and Enhanced Extinction Coefficients for High‐Efficiency Organic Solar Cells , 2016, Advanced materials.

[7]  C. Brabec,et al.  Fully Solution‐Processed Small Molecule Semitransparent Solar Cells: Optimization of Transparent Cathode Architecture and Four Absorbing Layers , 2016 .

[8]  Feng Gao,et al.  Fullerene‐Free Polymer Solar Cells with over 11% Efficiency and Excellent Thermal Stability , 2016, Advanced materials.

[9]  Weiqi Li,et al.  High‐Performance Polymer Tandem Solar Cells Employing a New n‐Type Conjugated Polymer as an Interconnecting Layer , 2016, Advanced materials.

[10]  Vincent M. Le Corre,et al.  Homo‐Tandem Polymer Solar Cells with VOC >1.8 V for Efficient PV‐Driven Water Splitting , 2016, Advanced materials.

[11]  Jianqi Zhang,et al.  Optimized “Alloy‐Parallel” Morphology of Ternary Organic Solar Cells , 2016 .

[12]  Fujun Zhang,et al.  Highly efficient ternary polymer solar cells by optimizing photon harvesting and charge carrier transport , 2016 .

[13]  Yanming Sun,et al.  Ternary Organic Solar Cells Based on Two Highly Efficient Polymer Donors with Enhanced Power Conversion Efficiency , 2016 .

[14]  Fujun Zhang,et al.  Versatile ternary organic solar cells: a critical review , 2016 .

[15]  Xiangwei Zhu,et al.  A conformational locking strategy in linked-acceptor type polymers for organic solar cells , 2016 .

[16]  H. Ade,et al.  Efficient organic solar cells processed from hydrocarbon solvents , 2016, Nature Energy.

[17]  A. Heeger,et al.  Polymer–Polymer Förster Resonance Energy Transfer Significantly Boosts the Power Conversion Efficiency of Bulk‐Heterojunction Solar Cells , 2015, Advanced materials.

[18]  Wei You,et al.  Status and prospects for ternary organic photovoltaics , 2015, Nature Photonics.

[19]  Jianqi Zhang,et al.  Oligomeric Donor Material for High‐Efficiency Organic Solar Cells: Breaking Down a Polymer , 2015, Advanced materials.

[20]  Jianqi Zhang,et al.  Conjugated Polymer-Small Molecule Alloy Leads to High Efficient Ternary Organic Solar Cells. , 2015, Journal of the American Chemical Society.

[21]  Wei Chen,et al.  High-performance ternary blend polymer solar cells involving both energy transfer and hole relay processes , 2015, Nature Communications.

[22]  Jianqi Zhang,et al.  Linked‐Acceptor Type Conjugated Polymer for High Performance Organic Photovoltaics with an Open‐Circuit Voltage Exceeding 1 V , 2015, Advanced science.

[23]  Jianqi Zhang,et al.  Synergistic Effect of Polymer and Small Molecules for High‐Performance Ternary Organic Solar Cells , 2015, Advanced materials.

[24]  P. Müller‐Buschbaum.  The Active Layer Morphology of Organic Solar Cells Probed with Grazing Incidence Scattering Techniques , 2014, Advanced materials.

[25]  Jianbin Xu,et al.  Ternary Bulk Heterojunction Photovoltaic Cells Composed of Small Molecule Donor Additive as Cascade Material , 2014 .

[26]  T. Xu,et al.  Ternary blend polymer solar cells with enhanced power conversion efficiency , 2014, Nature Photonics.

[27]  Suren A. Gevorgyan,et al.  Scalable, ambient atmosphere roll-to-roll manufacture of encapsulated large area, flexible organic tandem solar cell modules , 2014 .

[28]  Mikkel Jørgensen,et al.  Cost analysis of roll-to-roll fabricated ITO free single and tandem organic solar modules based on data from manufacture , 2014 .

[29]  Christoph J. Brabec,et al.  Environmentally Printing Efficient Organic Tandem Solar Cells with High Fill Factors: A Guideline Towards 20% Power Conversion Efficiency , 2014 .

[30]  R. Street,et al.  Influence of polymer compatibility on the open-circuit voltage in ternary blend bulk heterojunction solar cells. , 2014, ACS applied materials & interfaces.

[31]  Christoph J. Brabec,et al.  Towards 15% energy conversion efficiency: a systematic study of the solution-processed organic tandem solar cells based on commercially available materials , 2013 .

[32]  Christoph J. Brabec,et al.  Organic Ternary Solar Cells: A Review , 2013, Advanced materials.

[33]  C. Brabec,et al.  Charge Carrier Dynamics in a Ternary Bulk Heterojunction System Consisting of P3HT, Fullerene, and a Low Bandgap Polymer , 2013 .

[34]  Matthew Y. Sfeir,et al.  Polymer bulk heterojunction solar cells employing Förster resonance energy transfer , 2013, Nature Photonics.

[35]  Alan J. Heeger,et al.  Intensity dependence of current-voltage characteristics and recombination in high-efficiency solution-processed small-molecule solar cells. , 2013, ACS nano.

[36]  Yongfang Li,et al.  Tunable open-circuit voltage in ternary organic solar cells , 2012 .

[37]  Christoph J. Brabec,et al.  Round‐Robin Studies as a Method for Testing and Validating High‐Efficiency ITO‐Free Polymer Solar Cells Based on Roll‐to‐Roll‐Coated Highly Conductive and Transparent Flexible Substrates , 2012 .

[38]  S. Mannsfeld,et al.  Quantitative determination of organic semiconductor microstructure from the molecular to device scale. , 2012, Chemical reviews.

[39]  S. Khondaker,et al.  Near-infrared photoresponse sensitization of solvent additive processed poly(3-hexylthiophene)/fullerene solar cells by a low band gap polymer , 2012 .

[40]  S. Darling,et al.  Morphology characterization in organic and hybrid solar cells , 2012 .

[41]  W. You,et al.  Parallel-like bulk heterojunction polymer solar cells. , 2012, Journal of the American Chemical Society.

[42]  B. Thompson,et al.  Efficient ternary blend bulk heterojunction solar cells with tunable open-circuit voltage. , 2011, Journal of the American Chemical Society.

[43]  H. Ohkita,et al.  Selective Dye Loading at the Heterojunction in Polymer/Fullerene Solar Cells , 2011 .

[44]  D. Bradley,et al.  Effect of Crystallization on the Electronic Energy Levels and Thin Film Morphology of P3HT:PCBM Blends , 2011 .

[45]  A. Roy,et al.  Recombination in polymer-fullerene bulk heterojunction solar cells , 2010, 1010.5021.

[46]  Detlef-M Smilgies,et al.  Scherrer grain-size analysis adapted to grazing-incidence scattering with area detectors. , 2009, Journal of applied crystallography.

[47]  B. de Boer,et al.  Effect of traps on the performance of bulk heterojunction organic solar cells , 2007 .

[48]  Chin‐Ti Chen,et al.  Evolution of Red Organic Light-Emitting Diodes: Materials and Devices , 2004 .

[49]  S. Jenekhe,et al.  Excimers and Exciplexes of Conjugated Polymers , 1994, Science.

[50]  Jianhui Hou,et al.  Ternary Polymer Solar Cells based on Two Acceptors and One Donor for Achieving 12.2% Efficiency , 2017, Advanced materials.