Machining strategy in five-axis milling using balance of the transversal cutting force

Several solutions can be considered to resolve the problem of positioning a cutting tool on a free-form surface when five-axis milling. To choose a unique solution, in addition to the cutter–workpiece contact, an additional criterion can be taken into account. This may concern the local geometry of the surface or yet again the width milled to maximise the metal removal rate, but technological criteria relating to the cutting phenomenon and the quality of the surface produced are not considered. The present article introduces a strategy applying positioning combined with balancing of the transversal cutting force. This method involves using the ploughing effect of the milling cutters by simultaneously engaging the teeth located to the front of the cutter in relation to the feed movement and also those to the rear. The positioning obtained stabilises the cutter and contributes to making a net improvement in its dynamic behaviour. This leads in turn to significantly higher quality of the milled surface. The article presents a method to apply balancing of the transversal cutting force to two types of machining passes and elaborates an associated strategy to plan cutter paths enabling an improvement in surface quality to be achieved.

[1]  Johanna Senatore,et al.  Determination of angular fields outside low and high collisions to mill free-form surfaces on 5-axis CNC machines , 2012 .

[2]  F. Monies,et al.  Determining a collision-free domain for the tool in five-axis machining , 2004 .

[3]  K. Marciniak,et al.  Influence of surface shape in admissible tool positions in 5-axis face milling , 1987 .

[4]  Walter Rubio,et al.  Optimising Tool Positioning for End-Mill Machining of Free-Form Surfaces on 5-Axis Machines for both Semi-Finishing and Finishing , 2000 .

[5]  Yuan-Shin Lee,et al.  A shape-generating approach for multi-axis machining G-buffer models , 1999, Comput. Aided Des..

[6]  Yuan-Shin Lee,et al.  Admissible tool orientation control of gouging avoidance for 5-axis complex surface machining , 1997, Comput. Aided Des..

[7]  Paul J. Gray,et al.  Arc-intersect method for 5-axis tool positioning , 2005, Comput. Aided Des..

[8]  W. Edward Red,et al.  Tool selection for five-axis curvature matched machining , 2002, Comput. Aided Des..

[9]  A. A. Ball,et al.  Quadric method for cutter orientation in five-axis sculptured surface machining , 2008 .

[10]  Walter Rubio,et al.  Modelling cutting forces in milling on torus cutters , 2006 .

[11]  Walter Rubio,et al.  Optimum orientation of a torus milling cutter : Method to balance the transversal cutting force , 2007 .

[12]  Walter Rubio,et al.  Torus cutter positioning in five-axis milling using balance of the transversal cutting force , 2013 .

[13]  Peiqing Ye,et al.  Local interference detection and avoidance in five-axis NC machining of sculptured surfaces , 2005 .

[14]  Walter Rubio,et al.  Dynamic behaviour improvement for a torus milling cutter using balance of the transversal cutting force , 2009 .

[15]  Jean-Pierre Kruth,et al.  Optimization and dynamic adaptation of the cutter inclination during five-axis milling of sculptured surfaces , 1994 .

[16]  Sanjeev Bedi,et al.  Multi-point tool positioning strategy for 5-axis mashining of sculptured surfaces , 2000, Comput. Aided Geom. Des..