Mass-Producible 2D-MoS2-Impregnated Screen-Printed Electrodes That Demonstrate Efficient Electrocatalysis toward the Oxygen Reduction Reaction.

Two-dimensional molybdenum disulfide (2D-MoS2) screen-printed electrodes (2D-MoS2-SPEs) have been designed, fabricated, and evaluated toward the electrochemical oxygen reduction reaction (ORR) within acidic aqueous media. A screen-printable ink has been developed that allows for the tailoring of the 2D-MoS2 content/mass used in the fabrication of the 2D-MoS2-SPEs, which critically affects the observed ORR performance. In comparison to the graphite SPEs (G-SPEs), the 2D-MoS2-SPEs are shown to exhibit an electrocatalytic behavior toward the ORR which is found, critically, to be reliant upon the percentage mass incorporation of 2D-MoS2 in the 2D-MoS2-SPEs; a greater percentage mass of 2D-MoS2 incorporated into the 2D-MoS2-SPEs results in a significantly less electronegative ORR onset potential and a greater signal output (current density). Using optimally fabricated 2D-MoS2-SPEs, an ORR onset and a peak current of approximately +0.16 V [vs saturated calomel electrode (SCE)] and -1.62 mA cm-2, respectively, are observed, which exceeds the -0.53 V (vs SCE) and -635 μA cm-2 performance of unmodified G-SPEs, indicating an electrocatalytic response toward the ORR utilizing the 2D-MoS2-SPEs. An investigation of the underlying electrochemical reaction mechanism of the ORR within acidic aqueous solutions reveals that the reaction proceeds via a direct four-electron process for all of the 2D-MoS2-SPE variants studied herein, where oxygen is electrochemically favorably reduced to water. The fabricated 2D-MoS2-SPEs are found to exhibit no degradation in the observed achievable current over the course of 1000 repeat scans. The production of such inks and the resultant mass-producible 2D-MoS2-SPEs mitigates the need to modify post hoc an electrode via the drop-casting technique that has been previously shown to result in a loss of achievable current over the course of 1000 repeat scans. The 2D-MoS2-SPEs designed, fabricated, and tested herein could have commercial viability as electrocatalytic fuel cell electrodes because of being economical as a result of their scales of economy and inherent tailorability. The technique utilized herein to produce the 2D-MoS2-SPEs could be adapted for the incorporation of different 2D nanomaterials, resulting in SPEs with the inherent advantages identified above.

[1]  Jun‐Jie Zhu,et al.  A facile sonochemical route for the synthesis of MoS2/Pd composites for highly efficient oxygen reduction reaction. , 2017, Ultrasonics sonochemistry.

[2]  Huimin Wu,et al.  Production of MoS2/CoSe2 hybrids and their performance as oxygen reduction reaction catalysts , 2017, Journal of Materials Science.

[3]  Weitao Yang,et al.  All The Catalytic Active Sites of MoS2 for Hydrogen Evolution. , 2016, Journal of the American Chemical Society.

[4]  D. Yaron,et al.  In-Situ Platinum Deposition on Nitrogen-Doped Carbon Films as a Source of Catalytic Activity in a Hydrogen Evolution Reaction. , 2016, ACS applied materials & interfaces.

[5]  Pallavi Bothra,et al.  Size-selective electrocatalytic activity of (Pt)n/MoS2 for oxygen reduction reaction , 2016 .

[6]  D. A. Brownson,et al.  2D molybdenum disulphide (2D-MoS2) modified electrodes explored towards the oxygen reduction reaction. , 2016, Nanoscale.

[7]  M. Pumera,et al.  Negative Electrocatalytic Effects of p-Doping Niobium and Tantalum on MoS2 and WS2 for the Hydrogen Evolution Reaction and Oxygen Reduction Reaction , 2016 .

[8]  D. Wilkinson,et al.  PEM fuel cell electrocatalysts based on transition metal macrocyclic compounds , 2016 .

[9]  Z. Tian,et al.  Catalysis with Two‐dimensional Materials and Their Heterostructures , 2016 .

[10]  C. Suresh,et al.  Support interactive synthesis of nanostructured MoS2 electrocatalyst for oxygen reduction reaction , 2016 .

[11]  Dihua Wang,et al.  Hierarchical MoS2–rGO nanosheets with high MoS2 loading with enhanced electro-catalytic performance , 2015 .

[12]  D. A. Brownson,et al.  2D nanosheet molybdenum disulphide (MoS2) modified electrodes explored towards the hydrogen evolution reaction. , 2015, Nanoscale.

[13]  Sreekumar Kurungot,et al.  Layer-separated MoS2 bearing reduced graphene oxide formed by an in situ intercalation-cum-anchoring route mediated by Co(OH)2 as a Pt-free electrocatalyst for oxygen reduction. , 2015, Nanoscale.

[14]  Wenbo Song,et al.  Incorporated oxygen in MoS2 ultrathin nanosheets for efficient ORR catalysis , 2015 .

[15]  Dustin Banham,et al.  A review of the stability and durability of non-precious metal catalysts for the oxygen reduction reaction in proton exchange membrane fuel cells , 2015 .

[16]  Cuiling Zhang,et al.  MoS2/Nitrogen-doped graphene as efficient electrocatalyst for oxygen reduction reaction , 2015 .

[17]  Wenbo Song,et al.  High-quality phosphorus-doped MoS2 ultrathin nanosheets with amenable ORR catalytic activity. , 2015, Chemical communications.

[18]  Shuhong Yu,et al.  An efficient molybdenum disulfide/cobalt diselenide hybrid catalyst for electrochemical hydrogen generation , 2015, Nature Communications.

[19]  S. Lau,et al.  Preparation and characterization of few-layer MoS2 nanosheets and their good nonlinear optical responses in the PMMA matrix. , 2014, Nanoscale.

[20]  Y. Shao,et al.  Synergistic Catalytic Effect of MoS2 Nanoparticles Supported on Gold Nanoparticle Films for a Highly Efficient Oxygen Reduction Reaction , 2014 .

[21]  S. Louie,et al.  Evolution of interlayer coupling in twisted molybdenum disulfide bilayers , 2014, Nature Communications.

[22]  Takuya Masuda,et al.  Boron nitride nanosheet on gold as an electrocatalyst for oxygen reduction reaction: theoretical suggestion and experimental proof. , 2014, Journal of the American Chemical Society.

[23]  Jun Jiang,et al.  Nanostructured metal chalcogenides: synthesis, modification, and applications in energy conversion and storage devices. , 2013, Chemical Society reviews.

[24]  Dominique Baillargeat,et al.  From Bulk to Monolayer MoS2: Evolution of Raman Scattering , 2012 .

[25]  Jun Jiang,et al.  Water oxidation electrocatalyzed by an efficient Mn3O4/CoSe2 nanocomposite. , 2012, Journal of the American Chemical Society.

[26]  R. Compton,et al.  Activity of carbon electrodes towards oxygen reduction in acid: A comparative study , 2011 .

[27]  Lorenz Gubler,et al.  Radical (HO•, H• and HOO•) Formation and Ionomer Degradation in Polymer Electrolyte Fuel Cells , 2011 .

[28]  Changgu Lee,et al.  Anomalous lattice vibrations of single- and few-layer MoS2. , 2010, ACS nano.

[29]  Matthew Thorum,et al.  Electroreduction of dioxygen for fuel-cell applications: materials and challenges. , 2010, Inorganic chemistry.

[30]  I. Chorkendorff,et al.  Biomimetic Hydrogen Evolution: MoS2 Nanoparticles as Catalyst for Hydrogen Evolution , 2005 .

[31]  Jacob Bonde,et al.  Biomimetic hydrogen evolution: MoS2 nanoparticles as catalyst for hydrogen evolution. , 2005, Journal of the American Chemical Society.

[32]  Thomas Diehl,et al.  Air Pollution and Climate-Forcing Impacts of a Global Hydrogen Economy , 2003, Science.

[33]  T Kaskiala,et al.  Determination of oxygen solubility in aqueous sulphuric acid media , 2002 .

[34]  V. Radmilović,et al.  Oxygen Reduction on Carbon-Supported Pt−Ni and Pt−Co Alloy Catalysts , 2002 .

[35]  Hubert A. Gasteiger,et al.  The oxygen reduction reaction on a Pt/carbon fuel cell catalyst in the presence of chloride anions , 2001 .

[36]  D. Bartels,et al.  Temperature Dependence of Oxygen Diffusion in H2O and D2O , 1996 .

[37]  Craig E. Banks,et al.  The Oxygen Reduction Reaction at Graphene Modified Electrodes , 2014 .

[38]  Yang Jiang,et al.  Tribology of MoS2-Based Nanocomposites , 2012 .

[39]  Piotr Zelenay,et al.  Recent advances in non-precious metal catalysis for oxygen-reduction reaction in polymer electrolyte fuel cells , 2011 .