A Tutorial into Practical Capacity and Mass Balancing of Lithium Ion Batteries

[1]  M. Winter,et al.  Learning from Electrochemical Data: Simple Evaluation and Classification of LiMO2‐type‐based Positive Electrodes for Li‐Ion Batteries , 2017 .

[2]  M. Winter,et al.  Improving cycle life of layered lithium transition metal oxide (LiMO2) based positive electrodes for Li ion batteries by smart selection of the electrochemical charge conditions , 2017 .

[3]  M. Winter,et al.  Determining oxidative stability of battery electrolytes: validity of common electrochemical stability window (ESW) data and alternative strategies. , 2017, Physical chemistry chemical physics : PCCP.

[4]  M. Winter,et al.  Changing Established Belief on Capacity Fade Mechanisms: Thorough Investigation of LiNi1/3Co1/3Mn1/3O2 (NCM111) under High Voltage Conditions , 2017 .

[5]  H. Gasteiger,et al.  First-cycle defect evolution of Li1−xNi1/3Mn1/3Co1/3O2 lithium ion battery electrodes investigated by positron annihilation spectroscopy , 2016 .

[6]  M. Winter,et al.  Impact of Selected LiPF6 Hydrolysis Products on the High Voltage Stability of Lithium-Ion Battery Cells. , 2016, ACS applied materials & interfaces.

[7]  M. Winter,et al.  Best Practice: Performance and Cost Evaluation of Lithium Ion Battery Active Materials with Special Emphasis on Energy Efficiency , 2016 .

[8]  H. Ehrenberg,et al.  Changes of the balancing between anode and cathode due to fatigue in commercial lithium-ion cells , 2016 .

[9]  Peter Bieker,et al.  Lithium‐Ionen‐Technologie und was danach kommen könnte , 2016 .

[10]  Peter Bieker,et al.  Was braucht man für eine Super-Batterie? , 2016 .

[11]  H. Hahn,et al.  The truth about the 1st cycle Coulombic efficiency of LiNi1/3Co1/3Mn1/3O2 (NCM) cathodes. , 2016, Physical chemistry chemical physics : PCCP.

[12]  M. Winter,et al.  Learning from Overpotentials in Lithium Ion Batteries: A Case Study on the LiNi1/3Co1/3Mn1/3O2 (NCM) Cathode , 2016 .

[13]  M. Winter,et al.  Assessment of Surface Heterogeneity: a Route to Correlate and Quantify the 1st Cycle Irreversible Capacity Caused by SEI Formation to the Various Surfaces of Graphite Anodes for Lithium Ion Cells , 2015 .

[14]  Li Zhang,et al.  Correlation between lithium deposition on graphite electrode and the capacity loss for LiFePO4/graphite cells , 2015 .

[15]  Feixiang Wu,et al.  Li-ion battery materials: present and future , 2015 .

[16]  Peter Lamp,et al.  Future generations of cathode materials: an automotive industry perspective , 2015 .

[17]  Kyung Min Jeong,et al.  Effects of Capacity Ratios between Anode and Cathode on Electrochemical Properties for Lithium Polymer Batteries , 2015 .

[18]  Claire Villevieille,et al.  Rechargeable Batteries: Grasping for the Limits of Chemistry , 2015 .

[19]  H. Gasteiger,et al.  Review—Electromobility: Batteries or Fuel Cells? , 2015 .

[20]  M. Winter,et al.  Electrolytes for lithium and lithium ion batteries: From synthesis of novel lithium borates and ionic liquids to development of novel measurement methods , 2014 .

[21]  M. Winter,et al.  Investigations on novel electrolytes, solvents and SEI additives for use in lithium-ion batteries: Systematic electrochemical characterization and detailed analysis by spectroscopic methods , 2014 .

[22]  Jason R. Croy,et al.  Next-generation lithium-ion batteries: The promise of near-term advancements , 2014 .

[23]  Kevin G. Gallagher,et al.  Quantifying the promise of lithium–air batteries for electric vehicles , 2014 .

[24]  M. Winter,et al.  Vinyl sulfones as SEI-forming additives in propylene carbonate based electrolytes for lithium-ion batteries , 2014 .

[25]  Jens Leker,et al.  Current research trends and prospects among the various materials and designs used in lithium-based batteries , 2013, Journal of Applied Electrochemistry.

[26]  John B Goodenough,et al.  The Li-ion rechargeable battery: a perspective. , 2013, Journal of the American Chemical Society.

[27]  M. Winter,et al.  Fluoroethylene Carbonate as an Additive for γ-Butyrolactone Based Electrolytes , 2013 .

[28]  Martin Winter,et al.  How Do Reactions at the Anode/Electrolyte Interface Determine the Cathode Performance in Lithium-Ion Batteries? , 2013 .

[29]  Martin Winter,et al.  Influence of graphite surface modifications on the ratio of basal plane to “non-basal plane” surface area and on the anode performance in lithium ion batteries , 2012 .

[30]  P. He,et al.  Layered lithium transition metal oxide cathodes towards high energy lithium-ion batteries , 2012 .

[31]  B. Lucht,et al.  Electrolyte Reactions with the Surface of High Voltage LiNi0.5Mn1.5O4 Cathodes for Lithium-Ion Batteries , 2010 .

[32]  Martin Winter,et al.  The Solid Electrolyte Interphase – The Most Important and the Least Understood Solid Electrolyte in Rechargeable Li Batteries , 2009 .

[33]  Chunsheng Wang,et al.  Nano- and bulk-silicon-based insertion anodes for lithium-ion secondary cells , 2007 .

[34]  L. Nazar,et al.  X-ray/Neutron Diffraction and Electrochemical Studies of Lithium De/Re-Intercalation in Li1-xCo1/3Ni1/3Mn1/3O2 (x = 0 → 1) , 2006 .

[35]  M. Wohlfahrt‐Mehrens,et al.  Ageing mechanisms in lithium-ion batteries , 2005 .

[36]  M. Winter,et al.  What are batteries, fuel cells, and supercapacitors? , 2004, Chemical reviews.

[37]  Kang Xu,et al.  Nonaqueous liquid electrolytes for lithium-based rechargeable batteries. , 2004, Chemical reviews.

[38]  M. Whittingham,et al.  Lithium batteries and cathode materials. , 2004, Chemical reviews.

[39]  K. Möller,et al.  A study on electrolyte interactions with graphite anodes exhibiting structures with various amounts of rhombohedral phase , 2003 .

[40]  J. P. Olivier,et al.  Determination of the absolute and relative extents of basal plane surface area and “non-basal plane surface” area of graphites and their impact on anode performance in lithium ion batteries , 2001 .

[41]  J. Besenhard,et al.  Negative electrodes in rechargeable lithium ion batteries — Influence of graphite surface modification on the formation of the solid electrolyte interphase , 2000 .

[42]  Ralph E. White,et al.  Capacity Fade Mechanisms and Side Reactions in Lithium‐Ion Batteries , 1998 .

[43]  Petr Novák,et al.  Insertion Electrode Materials for Rechargeable Lithium Batteries , 1998 .

[44]  P. Novák,et al.  Graphites for lithium-ion cells : The correlation of the first-cycle charge loss with the Brunauer-Emmett-Teller surface area , 1998 .

[45]  J. Tarascon,et al.  New electrolyte compositions stable over the 0 to 5 V voltage range and compatible with the Li1+xMn2O4/carbon Li-ion cells , 1994 .

[46]  J. Tarascon,et al.  Rechargeable Li1 + x Mn2 O 4 / Carbon Cells with a New Electrolyte Composition Potentiostatic Studies and Application to Practical Cells , 1993 .