Imprint reduction in a plasma layer preformed with x-ray irradiation

Indirect–direct-hybrid irradiation scheme has been proposed for suppressing the initial imprint of the laser irradiation nonuniformities. The target is irradiated by a low intensity x-ray radiation prior to the direct-drive laser pulse. The x-ray irradiation generates a plasma expansion layer on the target surface. The thermal smoothing effect is expected to take place in the preformed plasma when the direct-drive laser pulse comes onto the target, and then, the initial imprint can be significantly reduced. Planar target experiments on the indirect–direct-hybrid irradiation scheme were performed. The preformed plasma profile was measured by using x-ray side-on backlighting method. The reduction of the initial imprint was demonstrated by the indirect–direct-hybrid irradiation scheme on planar target experiments. The imprint is suppressed by a factor of 1.5–7 depending on x-ray preirradiation conditions. Results are in good agreement with the cloudy-day model with parameters derived from one-dimensional sim...

[1]  Kunioki Mima,et al.  Random Phasing of High-Power Lasers for Uniform Target Acceleration and Plasma-Instability Suppression , 1984 .

[2]  H. Schwarz,et al.  Laser Interaction and Related Plasma Phenomena: Volume 4B , 1977 .

[3]  R. Town,et al.  LASER IMPRINT REDUCTION USING A LOW-DENSITY FOAM BUFFER AS A THERMAL SMOOTHING LAYER AT 351-NM WAVELENGTH , 1998 .

[4]  Hiroshi Azechi,et al.  Direct-drive hydrodynamic instability experiments on the GEKKO XII laser , 1997 .

[5]  Hiroshi Azechi,et al.  Scalings of implosion experiments for high neutron yield , 1988 .

[6]  D. Neely,et al.  Measurements of direct drive laser imprint in thin foils by radiography using an x-ray laser backlighter , 1997 .

[7]  M. Key,et al.  Simulations of laser imprint for Nova experiments and for ignition capsules. Revision 1 , 1996 .

[8]  Measurement of single mode imprint in laser ablative drive of a thin Al foil by extreme ultraviolet laser radiography , 1998 .

[9]  Hiroshi Azechi,et al.  Indirect-direct hybrid target experiments with the GEKKO XII laser , 2000 .

[10]  R. Town,et al.  Analysis of a direct-drive ignition capsule designed for the National Ignition Facility , 2001 .

[11]  S. Manson,et al.  Photoabsorption cross sections for positive atomic ions with Z equal to or less than 30 , 1979 .

[12]  M. Matsuoka,et al.  Density profile of the ablating plasma produced by soft x-ray irradiation , 2001 .

[13]  Weber,et al.  Measurements of laser-speckle-induced perturbations in laser-driven foils. , 1996, Physical review. E, Statistical physics, plasmas, fluids, and related interdisciplinary topics.

[14]  Taylor,et al.  Measurement and simulation of laser imprinting and consequent Rayleigh-Taylor growth. , 1996, Physical review letters.

[15]  A. Velikovich,et al.  Growth of Pellet Imperfections and Laser Imprint in Direct Drive Inertial Confinement Fusion Targets , 2001 .

[16]  Hiroshi Azechi,et al.  Spectrally dispersed amplified spontaneous emission for improving irradiation uniformity into high power Nd:glass laser system , 1993 .

[17]  Stephen E. Bodner,et al.  Critical elements of high gain laser fusion , 1981 .

[18]  Samuel A. Letzring,et al.  Improved laser‐beam uniformity using the angular dispersion of frequency‐modulated light , 1989 .

[19]  H. Takabe,et al.  Formation of Initial Perturbation of Rayleigh-Taylor Instability in Supernovae and Laser-Irradiated Targets—Is There Any Similarity? , 2000 .

[20]  Jones,et al.  Use of X-ray preheated foam layers to reduce beam structure imprint in laser-driven targets. , 1995, Physical review letters.

[21]  Hiroshi Azechi,et al.  Moiré interferometry of short wavelength Rayleigh–Taylor growth , 1999 .

[22]  Nonlinear aspects of hydrodynamic instabilities in laser ablation , 1982 .

[23]  Kunioki Mima,et al.  Indirect/direct hybrid drive implosion experiments with x-ray pre-irradiation , 2000, Advanced High-Power Lasers and Applications.

[24]  Denis G. Colombant,et al.  High-gain direct-drive target design for laser fusion , 2000 .