An Experimental Study of Static and Dynamic Characteristics of a 580mm(22.8in.) Diameter Direct Lubrication Tilting Pad Journal Bearing

Direct lubrication tilting pad journal bearings (DLTPJ bearings) have rarely been applied to large-scale rotating machinery, such as turbines or generators, whose journal diameters are more than 500 mm. In this paper, static and dynamic characteristics of a 580 mm (22.8 in.) diameter DLTPJ bearing were studied experimentally using a full-scale bearing test rig. In the static test, distribution of metal temperature, oil film pressure, and bearing loss were measured in changing oil flow rate, with mean bearing pressure ranging up to 2.9 MPa. The maximum metal temperature of the DLTPJ bearing was compared to that of a conventional flood lubrication bearing, and it was confirmed that the direct lubrication could increase load capacity. In the dynamic test, spring and damping coefficients of oil film were obtained by exciting the bearing casing that was floated by air bellows. These data will be used for analysis and design of steam turbine rotors and their bearing systems. Also, vibration of pads was investigated because metal failure on upper pads due to vibration has been found in some actual machines. In order to generate oil film pressure on the surface of upper pads, a Rayleigh-step was machined there, and it was confirmed that vibration was reduced by the Rayleigh-step.

[1]  Tsuneo Someya,et al.  Journal-Bearing Databook , 1989 .

[2]  Waldemar Dmochowski,et al.  A Study of the Thermal Characteristics of the Leading Edge Groove and Conventional Tilting Pad Journal Bearings , 1993 .

[3]  Keith Brockwell,et al.  A Study Of Parameters That Affect Pivoted Shoe Journal Bearing Performance In High-Speed Turbomachinery. , 2001 .

[4]  Jean Frene,et al.  Experimental Study of Tilting-Pad Journal Bearings—Comparison With Theoretical Thermoelastohydrodynamic Results , 1992 .

[5]  J. W. Lund,et al.  The Influence of Fluid Inertia on the Dynamic Properties of Journal Bearings , 1975 .

[6]  Hiromu Hashimoto,et al.  Static and Dynamic Characteristics of Rolling-Pad Journal Bearings in Super-Laminar Flow Regime , 1988 .

[7]  Masato Tanaka.  Thermohydrodynamic Performance of a Tilting Pad Journal Bearing With Spot Lubrication , 1991 .

[8]  Waldemar Dmochowski,et al.  Analysis And Testing Of The Leg Tilting Pad Journal Bearing - A New Design For Increasing Load Capacity, Reducing Operating Temperatures And Conserving Energy. , 1994 .

[9]  W. W. Gardner.  An Experimental Study of Thrust Pad Flutter , 1998 .

[10]  A. J. Leopard,et al.  Paper 13: Tilting Pad Thrust Bearings: Factors Affecting Performance and Improvements with Directed Lubrication , 1969 .

[11]  Christopher B. Stewart.  Influence Of Oil Injection Method On Thrust Bearing Performance At Low Flow Conditions. , 1999 .

[12]  A. M. Mikula,et al.  A Comparison of Tilting Pad Thrust Bearing Lubricant Supply Methods , 1983 .

[13]  R. D. Flack,et al.  Accuracy evaluation of experimentally derived dynamic coefficients of fluid film bearings. I: Development of method , 1990 .